Page 2 - Attention New Spa Owner!; Filter Maintenance
Attention New Spa Owner! Congratulations on the purchase of your new Jacuzzi Premium spa!Listed below are impor tant maintenance recommendations youshould obser ve on a regular basis to protect your new investment . Filter Maintenance Your new spa is equipped with an advanced 2-stage water filtratio...
Page 3 - Table of Contents
Table of Contents 1.0 Important Spa Owner Information ..........................................1 2.0 FCC Notice......................................................................................1 3.0 Important Safety Instructions ...................................................2 3.1 Impor tan...
Page 5 - Important Spa Owner Information; Rearrange or relocate the receiving antenna.
1.0 Important Spa Owner Information Your Jacuzzi® Premium spa is constructed to the highest standards and iscapable of providing many years of trouble-free use. However, because heatretentive materials are utilized to insulate the spa for efficient operation, anuncovered spa sur face directly expose...
Page 6 - Important Saf ety Instructions; ) solid copper conductor between
3.0 Important Saf ety Instructions When installing and using this electrical equipment, basic safety pre-cautions should always be followed, including: 1. READ AND FOLLOW ALL INSTRUCTIONS BEFORE OPERATING THE SPA! 2. WARNING: To reduce the risk of injur y, do not permit children to use thisproduct u...
Page 9 - GENERAL ELECTRICAL SAFETY INSTRUCTIONS
2. The Consumer Products Safety Commission has stated that the water temperature in a spa should not exceed 104 °F (40 °C). Immersion inwater in excess of 104 °F (40 °C) can be hazardous to your health. 3. Obser ve a reasonable time limit when using the spa. Long exposures athigher temperatures can ...
Page 10 - Choosing A Location; Because of the combined weight of the spa, water
120/240 Volt Convertible Models A spa connected to a 120 VAC electrical ser vice must be located closeenough to a grounded, grounding-type electrical outlet so that the includedpower cord can be plugged directly into it . DO NOT USE AN EXTENSIONCORD as this could cause damage to the spa’s equipment ...
Page 12 - For 240 VAC Heater Operation:; Move the red wire on the main terminal; will not operate; at the same; Power Requirements
US / Canada J-310 1-Pump Convertible Model (60Hz) 120V/15A* 240V/30A* 240V/40A** Voltage: 120 VAC 240 VAC 240 VAC # of Wires: 3 (15A GFCI Cord) 4 4 Frequency: 60Hz 60Hz 60Hz Current Draw: 12A 21A 30A Circuit Breaker: 15A, 1-Pole 30A, 2-Pole 40A, 2-Pole For 240 VAC Heater Operation: Move the red wire...
Page 14 - Electrical Wiring Instructions; Never use an extension cord for any reason!; must; Do not use
6.0 Electrical Wiring Instructions IMPORTANT NOTICE: The electrical wiring of this spa must meet the requirements of the National Electrical Code (NEC) and anyapplicable state or local codes. The electrical circuit must beinstalled by a qualified electrician and approved by a local build-ing/electri...
Page 17 - Initiate Water Circulation; Depress the; Place Cover On Spa; RISK OF INJURY. Always check water temperature
If your water is extremely “hard”, it is preferable to fill half-way with hardwater and the rest of the way with softened water. Or, you may fill entirely with hard water if you use a special water additive available from yourJacuzzi Premium dealer. Always refill spa half way through both filter wal...
Page 18 - Control Functions; Operation Details; • Under water Light Operation: light runs for 1 hour then shuts
8.0 Control Functions 8.1 Control Panel A. LED Display: can display current water temperature (default display), water temperature setpoint, selected skimming/heating mode, and error messages. B. Warmer ( + ) Button: increases water temperature setpoint . C . Cooler ( - ) Button: decreases water tem...
Page 19 - Spa Features And Controls; J-340 model illustrated - Location of Features Varies by Model
Page 15 8.2 Spa Features And Controls 1. Control Panel2. Air Controls 3. Filter/Skimmer Grill 4. Maxx PowerPro Jets5. Therapy Jets 6. Diver ter Valve 7. Therapy Seat 8. Spa Light 9 Ver tical Jets (Foot Jets)10. Footwell Suction Fittings and Filters. 11. Water fall Feature12. Heater Return Fitting13....
Page 22 - Operating Instructions; Note: it is common for the heater to turn on after the spa is first; Setting Water Temperature; COOLER; Note: The first press of either; LIGHT; Selecting Desired Massage Action
Page 18 9.0 Operating Instructions The spa control system has automatic functions that operateupon star t-up and normal operation to protect the system.Upon power up, the readout displays the following information:1. Control panel displays current software release (e.g. 3.54), then; 2. Control panel...
Page 23 - Adjusting Individual Jet Flow; Note: Always keep at least 6 adjustable; Adjusting PowerPro Jets; Waterfall Feature; Button activates the waterfall feature. Then,
that allows you to customize the massage and per formanceby diver ting water between various jet systems. Simply turnmassage selector to position A (Combo), B, or C to diver twater pressure to various jet groups. Note: The valve is designed to operate in positions A (Combo), B, and C for optimum per...
Page 24 - Optional Stereo Receiver - Basic Operation; JENSEN
Both speakers located on spa corners (Sec. 8.2, page 15) are designed formanual extension and retraction. To expose each speaker for audio, simplypress it’s release button to unlatch the “pop-up” mechanism. To retracteach speaker before covering spa, gently press downward on each speakerenclosure un...
Page 29 - Optional Stereo Receiver - CD Player Operation; I n s e rt
F. Prescan Stations Scans stations stored in current band.1. Press grey BAND button to select desired radio band, if necessar y. 2. Press grey AS/PS button for less than 3-seconds. The radio pauses for 5-seconds at each station. Press grey AS/PS button again to stop scanning when desired station is ...
Page 31 - Optional Stereo Receiver Specifications; Specifications subject to change without notice.
Optional Stereo Receiver Specifications CD Player Signal/noise ratio . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .>86 dBFrequency response . . . . . . . . . . . . . . . . . . . . . . . .20 Hz - 20 kHzChannel separation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .>...
Page 32 - Automatic Filtration Cycles; Note: these modes consume far less energy than standard
Page 28 10.0 Automatic Filtration Cycles Your new spa includes a 24-hour circulation pump which filters the watercontinuously while using less energy than a common 100 watt light bulb!The circulation pump draws water through the skimmer bag and one of twofilter car tridges to effectively remove smal...
Page 33 - buttons; at the same time; or
buttons at the same time , then release. Then press either WARMER ( + ) or COOLER ( - ) button to select skimming/heater mode F0-F6 or lock modes L1-L2 below: Standard Skimming/Heating ModesF0 5 minutes of skimming per day (one 5 minute “Blow-Out” cycle ever y 24 hours to purge all plumbing lines) F...
Page 34 - Cleaning The Filters; ALWAYS TURN POWER TO SPA OFF BEFORE CLEANING THE
1 1.0 Spa Maintenance Proper and regular maintenance of your spa will help it retain its beauty andper formance. Your authorized Jacuzzi Premium dealer can supply you withall the information, supplies, and accessor y products you will need toaccomplish this. 11.1 Cleaning The Filters Your Jacuzzi Pr...
Page 36 - Draining and Refilling; To prevent damage
water quality maintenance. Replacement car tridges may be purchased fromyour Jacuzzi Premium dealer. 11.2 Draining and Refilling About ever y 3 to 6 months, you will want to replace the spa’s water. The fre-quency depends on a number of variables including the amount of use, atten-tion paid to water...
Page 37 - Cleaning The Spa Interior; Never attempt to remove the pillows by pulling on them!; DO NOT overtighten; Maintaining the Cover
11.3 Cleaning The Spa Interior To preser ve the sheen of your spa's sur face, it is crucial that you avoid using abrasive cleaners or cleaners which have adverse chemical effect onthe sur face. If you are not cer tain as to the suitability of a par ticularcleanser, consult your authorized Jacuzzi Pr...
Page 38 - For expert winterization of your spa, contact your authorized; In emergency situations, damage can be mini-
11.6 Maintaining The Wood Cabinet With time and exposure to the elements, the wood on your spa will tend toloose its new appearance. Protecting or reviving the wood sur faces is a fair-ly simple process. Light sanding with fine-grit sandpaper will help smoothany roughness and regular applications of...
Page 39 - Restarting Your Spa in Cold Weather; Water Quality Maintenance; Never store spa chemicals inside the spa's equipment bay
3. When the water level ceases to drop, use whatever means available to remove any remaining water from the footwell. 4. Turn off power to the spa. 5. Remove the equipment-side cabinet panels and locate the drain plugs in the front of the pump(s) (Figure-A, Page 11). Remove these plugs to allow the ...
Page 40 - Optional CD Ozone Water Main; tenance System
12.1 pH Control pH is a measure of relative acidity or alkalinity of water and is measured on ascale of 0 to 14. The midpoint of 7 is said to be neutral, above which is alka-line and below which is acidic. In spa water, IT IS VERY IMPORTANT TO MAINTAIN A SLIGHTLY ALKALINE CONDITION OF 7.2 to 7.8. Pr...
Page 41 - an overheat condition. This setting is not user-programmable.; Overheat Condition; Water is
an overheat condition. This setting is not user-programmable. Note: The summer logic does not take effect until the spa water tempera-ture reaches 95 °F (35 °C). This condition is more likely in excessively hotweather. Remember, the spa’s ability to cool is directly affected by theambient temperatur...
Page 42 - Panel displays COL
• This error will cause the heater to deactivate. The main pump #1 may also deactivate. • This problem is caused by an interruption in water flow from an excessively dir ty filter car tridge, an “air lock” condition at the pump intake, or by a malfunctioning flow switch. To Correct Condition:1. Chec...
Page 43 - Troubleshooting Procedures; Pump Does Not Operate but Light Does; Reduce thermostat setting so the circulation pump turns off.
14.0 Troubleshooting Procedures In the event your Jacuzzi® Premium spa is not working the way it should,please first review all the installation and operating instructions in this manual and check the message on the panel display. If you are still not satisfied it is working properly, please follow ...
