Honeywell FC300860SE - Manuals

- 2 - 3. Mount the Sensor [A] = Fixed mounting holes [B] = Adjustable mounting slots from 61mm-85mm (2.4 ” -3.3 ” ) [C] = Tamper hole *This accessory is not covered by the approval. 4. Wire the Sensor Wiring Details • Observe proper polarity. • If not using the integrated EOL resistors, set all swit...

- 3 - 5. Sensor Components and Settings 6. Walk Test the Sensor and Adjust as Needed 1. Close the sensor and apply power to the sensor. Initialization is complete when the LED stops flashing slowly (about 30 seconds). 2. Walk through the detection area and observe the LED. 3. Adjust the microwave ra...

- 6 - REMOTE LED ENABLE (LED INPUT) (DT8360ACM only) The LED input terminal allows the LED to be remotely enabled. To use this feature, the LED DIP switch (switch 2) must be OFF, allowing the LED to operate based on the voltage level connected to the LED Input (see Wiring Details ). Switch 2 LED Inp...