Hilti 2200184 - Manuals - manualsarea.com

Page 4 - ORIGINAL OPERATING INSTRUCTIONS; driver; Contents

en 1 ORIGINAL OPERATING INSTRUCTIONS SF 2-A/SFD 2-A cordless drill / driver It is essential that the operating instructions are read before the power tool is operated for the first time. Always keep these operating instructions together with the power tool. Ensure that the operating instructions are...

Page 5 - General information

en 2 ( Grip ) Lamp + Belt hook (optional) § Charging status indicator / Release button : Control switch (with electronic speed control) 1 General information 1.1 Safety notices and their meaning DANGER Draws attention to imminent danger that will lead to serious bodily injury or fatality. WARNING Dr...

Page 8 - Insert tools, accessories; Charger for Li-ion batteries

en 5 2.6 The items supplied include (cardboard box versions): 1 Power tool1 Operating instructions 2.7 Additional items required for operating the tool: B 12/2.6 Li-Ion battery and C4⁄1250 charger. 2.8 Liion battery charge status display LEDs light constantly LEDs blink Charge status C LED 1, 2, 3...

Page 10 - Safety instructions

en 7 5 Safety instructions NOTE The safety rules in section 5.1 contain all general safety rules for electric tools which, in accordance with the applicable standards, must be listed in the operating instructions. Accordingly, some of the rules listed may not be relevant to this tool. 5.1 General po...

Page 16 - Before use; of safely and correctly to avoid environmental pollution.

en 13 6 Before use 6.1 Battery use and care NOTE Battery performance drops at low temperatures. Use the tool only after fully charging the battery. This ensures that maximum battery capacity is available. Change to the second battery in good time. Recharge the battery immediately so that it is ready...

Page 18 - Operation; The tool may get hot during use.

en 15 7 Operation CAUTION The tool may get hot during use. Wear protective gloves. CAUTION When drilling and screwdriving, the grip of the tool may be deflected laterally (the tool tends to pivot about its own axis).CAUTION To avoid injuries caused by the insert tool, wear protective gloves when cha...

Page 20 - Care and maintenance

en 17 2. Push the locking sleeve on the hex. socket forward and hold it securely in this position. 3. Push the bit into the hex. socket as far as it will go and then release the locking sleeve. 4. Check that the drill bit is held securely. 7.4.2.2 Removing the tool 1. Set the forward / reverse switc...

Page 22 - Troubleshooting

en 19 – If the battery no longer reaches full charge, it may have lost capacity due to aging or overstressing. It is still possible to work with this battery. You should, however, soon replace the battery with a new one. 8.4 Maintenance WARNING Repairs to the electrical section of the power tool may...

Page 24 - 1 Manufacturer’s warranty - tools; the warranty conditions.

en 21 11 Manufacturer’s warranty - tools Please contact your local Hilti representative if you have questions about the warranty conditions. Printed: 24.03.2014 | Doc-Nr: PUB / 5174908 / 000 / 00

Page 25 - Hilti Corporation

*2081399* 2081399 Hilti Corporation LI-9494 Schaan Tel.: +423 / 234 21 11 Fax: +423 / 234 29 65 www.hilti.com Hilti = registered trademark of Hilti Corp., Schaan W 4334 | 0314 | 00-Pos. 3 | 1 Printed in China © 2014 Right of technical and programme changes reserved S. E. & O. 2081399 / A2 Printe...