DeLonghi ECAM65055MS - Manuals

Page 4 - MILK

4 4 4 3 3 2 1 8 7 6 5 12 16 15 9 14 MILK 5 5 5 11 10 13

Page 7 - FUNDAMENTAL SAFET Y WARNINGS; Never clean by immersing the appliance in water.; FOR EUROPEAN MARKETS ONLY:; Children shall not play with the appliance.

7 1. FUNDAMENTAL SAFET Y WARNINGS • The appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person res...

Page 9 - Directly selected beverages:

9 In the App, you can also find information, tips and curious facts about the world of coffee, together with information on your machine at your fingertips. This symbol highlights the functions you can control or consult using the App. You can also create up to 6 new beverages and save them in your ...

Page 16 - Please note: general indications when preparing all; Cleaning the milk container after every use; Important! Danger of burns; DELIVERING HOT WATER

16 10.2 Regolare la quantità di schiuma Turn the froth adjustment dial (D1) to adjust the amount of froth on the milk delivered while making cappuccinos and milk-based coffees. Dial position Description Recommended for… NO FROTH HOT MILK (not frothed)/ CAFFELATTE MIN. FROTH LATTE MACCHIATO / FLAT WH...

Page 21 - Important! Danger of burns; SETTING WATER HARDNESS

21 ” f ” arrow corresponding to “NEXT>”; 39 5. “EMPTY DRIP TRAY” (fig. 47): Remove, empty and replace the drip tray (A14) and grounds container (A10). Press the selection arrow cor-responding to “NEXT>”; 6. “POSITION 2l CONTAINER OK TO START”. Place an empty container with a minimum capacity o...

Page 22 - Please note

22 3. Remove the paper from the water and shake lightly. After about a minute, 1, 2, 3, or 4 red squares form, depending on the hardness of the water. Each square corresponds to one level. 17.2 Setting water hardness 1. Press the selection arrow (B2) corresponding to the “ ” symbol (B8) to enter the...

Page 24 - DISPLAYED MESSAGES; DISPLAYED MESSAGE; INSERT WATER TANK; ESC

24 21. DISPLAYED MESSAGES DISPLAYED MESSAGE POSSIBLE CAUSE SOLUTION FILL TANK WITH FRESH WATER Insufficient water in the tank (A16). Fill the tank with water and/or insert it cor-rectly, pushing it as far as it will go until it clicks into place. INSERT WATER TANK The tank (A16) is not correctly in ...

Page 25 - OK; FILL BEANS CONTAINER; The coffee beans have run out.; SELECT A MILDER TASTE OR; Too much coffee has been used.

25 ADD GROUND COFFEE MAX. ONE MEASURE OK A LONG coffee with pre-ground coffee has been requested Place pre-ground coffee in the funnel (A4) (fig. 13) and press “OK ” to continue and complete delivery. FILL BEANS CONTAINER ESC The coffee beans have run out. Fill the beans container (A3-fig. 11). The ...

Page 26 - The water circuit is empty

26 INSERT WATER SPOUT The hot water spout (C6) is not inserted or is inserted incorrectly Insert the water spout as far as it will go. INSERT MILK CONTAINER The milk container (D) is not inserted correctly. Insert the milk container as far as it will go (fig. 18). INSERT INFUSER ASSEMBLY PUSH The in...

Page 27 - Turn the dial to the required froth position.; The machine must be descaled.; ESC OK; The inside of the appliance is very dirty.

27 TURN MILK FROTH ADJUSTMENT DIAL TO CLEAN POSITION CLEAN ESC Milk has been delivered recently and the tubes inside the milk container (D) must be cleaned. Turn the froth adjustment dial (D1) to CLEAN (fig. 20). TURN THE MILK FROTH ADJUSTMENT DIAL The milk container has been inserted with the froth...

Page 28 - TROUBLESHOOTING

28 The machine must be descaled. The descaling procedure described in section “16. Descaling” needs to be performed as soon as possible. The auto-start function is enabled. To disable the function, proceed as described in section “8.6 Auto-start ”. Energy saving is enabled. To disable the function, ...

Page 30 - Warning - this appliance must be earthed

30 23. ELECTRICAL CONNECTION (UK ONLY) Before using this appliance ensure that the voltage indicated on the product corresponds with the main voltage in your home, if you are in any doubt about your supply contact your local electricity company.The flexible mains lead is supplied connected to a B.S....