DeLonghi ECAM28465M - Manuals

9 Connecting the appliance Important! Check that the mains power supply voltage corresponds to the value indicated on the rating plate on the bottom of the appliance.Connect the appliance to an earthed and correctly installed socket with a minimum current rating of 10A only.If the power socket does ...

10 • release the main switch at the side of the appliance (fig. 2). Important! Never press the main switch while the appliance is on. MENU SETTINGS When you access the programming menu by pressing the MENU/ESC button, the following menu items are available: Rinsing Use this function to deliver hot w...

12 5. Press the button to confirm and exit. Statistics function This displays statistics relating to the machine. To display, proceed as follows:1. Press the MENU/ESC button to enter the menu; 2. Press the HOT MILK or LATTE button (fig. 8) until “Statis- tics” is displayed; 3. Press the button; 4. P...

13 2. Place under the coffee dispensing spouts, either: - 1 cup if you want one coffee (fig. 14); - 2 cups if you want 2 coffees. 3. Lower the spouts as near as possible to the cup. This makes a creamier coffee (fig. 15). 4. Press the button corresponding to the number of coffees required (1 cup or ...

14 Adjusting the amount of froth Turn the froth adjustment dial on the milk container lid to adjust the amount of froth on the milk delivered while making drinks with milk. Dial position Description Recommended for… No froth LATTE/ HOT MILK Min. froth FLAT WHITE Max. froth CAPPUCCINO/ HOT MILK (FROT...

15 The spout becomes hot during delivery. Hold by the handle only. Please note! If “Energy Saving” mode is enabled, you may have to wait a few seconds before the hot water or steam is delivered. Delivering hot water 1. Make sure the hot water spout is attached correctly (fig. 6). 2. Place a containe...

16 If you make a number of cappuccinos one after the other, the metal cup tray becomes hot. Wait for it to cool down before touching it and handle it from the front only. To clean (with the machine on):• Remove the drip tray (fig. 26), empty and clean. • Empty the grounds container and clean thoroug...

17 Please note! If the infuser is difficult to insert, before insertion, adapt it to the right size by pressing the two levers shown in the figure. 7. Once inserted, make sure the two red buttons have snapped out. PUSH 8. Close the infuser door. 9. Replace the water tank. Cleaning the milk container...

18 soft water ● slightly hard water ●● hard water ●●● very hard water ●●●● Set water hardness 1. Press the MENU/ESC button to enter the menu. 2. Press the HOT MILK or LATTE button to select “Water Hardness”. 3. Confirm the selection by pressing the button. 4. Press the HOT MILK or LATTE button and s...

20 DISPLAYED MESSAGES DISPLAYED MESSAGE POSSIBLE CAUSE SOLUTION FILL TANK Insufficient water in the tank. Fill the tank with water and/or insert it correctly, pushing it as far as it will go until it clicks into place. EMPTY GROUNDS CONTAINER The grounds container (A22) is full. Empty the grounds co...

21 TROUBLESHOOTING Below is a list of some of the possible malfunctions. If the problem cannot be resolved as described, contact Customer Services. PROBLEM POSSIBLE CAUSE SOLUTION The coffee is not hot The cups were not preheated. • Enable the cup warmer, leave the cups at least 20 minutes to warm u...

23 ELECTRICAL CONNECTION (UK ONLY) Before using this appliance ensure that the voltage indicated on the product corresponds with the main voltage in your home, if you are in any doubt about your supply contact your local electricity company.The flexible mains lead is supplied connected to a B.S. 136...