DeLonghi DEGHSL75 - Manuals

DeLonghi DEGHSL75 Hob – User Manual in PDF format online.

Manuals:

User Manual

User Manual DeLonghi DEGHSL75

Summary

Page 2 - PRODUCT LABEL; Approval Requirements for Domestic Gas cooking appliances

2 PRODUCT LABEL This cooktop has been designed and constructed in accordance with the following codes and specifications: AGA101 (AS 4551) Approval Requirements for Domestic Gas cooking appliances AS/NZS 60335.1 General Requirements for Domestic electrical appliances AS/NSZ 60335.2.102 Particular Re...

Page 3 - professionally qualified technician.; This film must be removed before using the; IMPORTANT: The use of suitable protective clothing/gloves is

3 IMPORTANT SAFETY PRECAUTIONS AND RECOMMENDATIONS IMPORTANT: This appliance is designed and manufactured solely for the cooking of domestic (household) food and is not suitable for any non domestic application and therefore should not be used in a commercial environment. The appliance guarantee wil...

Page 6 - INSTALLATION; ELECTRICAL REQUIREMENTS; the load specified on the plate.

6 INSTALLATION CAUTION: ■ Important: The use of suitable protective clothing/gloves is recommended when handling or cleaning of this appliance. ■ This appliance must be installed in accordance with these installation instructions, local gas fitting regulations, municipal building codes, water supply...

Page 7 - Agent or a similarly qualified person in order to avoid a hazard.; established electrical regulations.; Figure 1

7 L N 3. The wire which is coloured brown must be connected to the terminal marked “ L ” (Live) or “ A ” (Active) or coloured Red. ■ A suitable isolating switch providing full disconnection from the mains power supply (under overvoltage category III conditions) shall be incorporated in the permanent...

Page 8 - CLEARANCES

8 CLEARANCES Installation clearances and protection of combustible surfaces shall comply with the current local regulations e.g. AS/NZS5601 - Gas Installations code. Measures (mm) Description A B C D E F (minimum) G (minimum) Model DEGHSL60 600 510 49 (*) 560 480 60 (**) 200 (***) Model DEGHSL75 750...

Page 9 - INSTALLED IN MARINE CRAFT OR CARAVANS.; Overhead clearances; Standards requirement; Temperature of nearby surfaces.; This is typically achieved by:

9 (*) From top of countertop (**) Between the back edge of the cut-out and the back of the countertop. (***) From the side edge of the cut-out to any vertical combustible surface. If this distance is less than 200 mm, the surface shall be protected (in accordance with AS/NZS5601) to a height of not ...

Page 10 - FASTENING THE COOKTOP; Model DEGHSL90

10 FASTENING THE COOKTOP Each cooktop is provided with an installation kit including brackets and screws for fastening the cooktop to benches from 30 to 40mm thick. Models DEGHSL60, DEGHSL75 (fig. 3a): The kit includes two “ F ” type brackets (for the front of the cooktop), two “ R ” type brackets (...

Page 11 - GAS SUPPLY; flames in simultaneously at the; Gas connection for

11 GAS SUPPLY ■ This appliance is suitable for use with Natural Gas or ULPG (Check the “gas type” sticker attached to the appliance). ■ For Natural Gas the gas supply must be regulated to obtain a pressure of 1 kPa: – with the two semi-rapid (SR) burners operating at the maximum - model DEGHSL60 onl...

Page 12 - INSTALLATION WITH A FLEXIBLE HOSE ASSEMBLY; After connection the installer must check that the hose is

12 tighten or replace connections as appropriate. Warning: Do not use any naked flame to check for leaks. 2. The operation of the appliance MUST be tested before leaving.3. Adjust the test point pressure or supply pressure to the value which is appropriate for the gas type. 4. Turn on the appliance ...

Page 13 - TABLE FOR THE CHOICE OF THE INJECTORS; Natural Gas; CONVERSION PROCEDURE (to convert to Natural gas or to ULPG); To replace the injectors proceed as follows:; IMPORTANT

13 TABLE FOR THE CHOICE OF THE INJECTORS Natural Gas ULPG Test Point Pressure [kPa] 1.0 2.75 BURNER Injector Orifice Dia. [mm] Gas Consumption [MJ/h] Injector Orifice Dia. [mm] Gas Consumption [MJ/h] Auxiliary (AUX) 0.92 3.90 0.56 3.90 Semi-rapid (SR) 1.17 6.50 0.70 6.20 Rapid (R) ( 1 ) 1.54 11.75 0...

Page 14 - replace with gas regulator (see figs.

14 and replace with test point adaptor (see figs. 4a, 4b). ■ If the cooktop is suitable for use with Universal LPG and must be converted for use with Natural gas, before connecting to the gas main remove the appliance test point adaptor and replace with gas regulator (see figs. 4a, 4b). NOTE: Gas re...

Page 15 - MINIMUM BURNER SETTING ADJUSTMENT; Using a screwdriver turn screw “; Normally for ULPG fully tighten the adjustment screw.; LUBRICATING THE GAS TAP; Figure 6

15 MINIMUM BURNER SETTING ADJUSTMENT Check whether the flame spreads to all burner ports when the burner is lit with the gas tap set to the minimum position. If some ports do not light, increase the minimum gas rate setting.Check whether the burner remains lit even when the gas tap is turned quickly...

Page 16 - USE and CARE; NOT use or store flammable materials near this appliance.

16 USE and CARE CAUTION: ■ This appliance must be used only for the task it has explicitly been designed for, that is for domestic cooking of foodstuffs. Any other form of usage is to be considered as inappropriate and therefore dangerous. Do not use this appliance as a space heater. ■ Do NOT place ...

Page 17 - GAS BURNERS; The inner and outer crown can be used together or separately.; CONTROL KNOBS; The electric ignition is incorporated in the knobs.

17 M o d e l : DEGHSL90 15 14 8 9 10 11 1 7 2 3 4 Figure 7c GAS BURNERS 1. Auxiliary (A)2. Semi-rapid (SR)3. Semi-rapid (SR)4. Rapid (R)5. Triple-ring compact (TRC)6. Triple-ring (TR)7. Dual (DB) (*) (() IMPORTANT: The Dual burner (model DEGHSL90 only) is controlled by two separate knobs; one knob f...

Page 18 - USING GAS BURNERS; Figure 8a

18 USING GAS BURNERS ■ Check that the electricity is switched on to allow spark ignition. ■ Make sure that all controls are turned to “ ” (burner off). ■ The gas flow to the burner is controlled by a tap incorporating a safety cut-off valve. If the burner flame should go out for some reason, the saf...

Page 19 - wait for at; DUAL BURNER - MODELS DEGHSL90 ONLY; It is composed by one inner and one outer crown:; the inner and outer crown can be used; The Dual burner can be used:; are in the closed “ ” position.

19 LIGHTING GAS BURNERS FITTED WITH FLAME FAILURE SAFETY DEVICE In order to light the burner, you must: 1. Turn the knob (figs. 8a - 8b) in anti-clockwise direction up to the maximum aperture (symbol “ ” ), push in and hold the knob; this will light the gas. If there is no mains electrical supply, b...

Page 20 - Figure 9; DUAL BURNER OPERATION/CONTROL KNOBS; IMPORTANT: After using the dual burner check both the control

20 1 2 1 2 1+2 1 2 1 2 1+2 Figure 9 DUAL BURNER OPERATION/CONTROL KNOBS MODEL DEGHSL90 ONLY IMPORTANT: After using the dual burner check both the control knobs are in the closed “ ” position.

Page 21 - COOKING HINTS FOR GAS HOBS; When deep fat frying:; DO NOT; use water on the fire.; WARNING - VERY IMPORTANT NOTICE; DIAMETERS OF PANS WHICH MAY BE USED ON THE BURNERS; do not use pans with concave or convex bases

21 COOKING HINTS FOR GAS HOBS ■ The burner must be chosen according to the diameter of the pans and energy required. ■ The largest can be used for boiling, to seal meat or foods that are cooked quickly, and the smallest for stews and sauces. ■ Always ensure that you use the correct size of saucepan....

Page 22 - SMALL PAN ADAPTER - MODEL DEGHSL90 ONLY; This adapter is to be placed:; used with the inner crown only; ) when using small diameter; the small pan adapter in place.; CORRECT

22 SMALL PAN ADAPTER - MODEL DEGHSL90 ONLY This adapter is to be placed: ■ on top of the Dual burner ( used with the inner crown only ) when using small diameter pans, in order to prevent them from tipping over. IMPORTANT:To avoid any burner malfunction: ■ this adapter MUST be placed correctly (figs...

Page 23 - To use the WOK, you must place the wok stand in the; The special grille for wok pans; MUST BE PLACED ONLY; over the pan-rest for the

23 Model: DEGHSL60 (with triple-ring compact burner) CORRECT WRONG WOK STAND (figs. 12a - 12b, 13a - 13b, 14a - 14b) This special grille for woks should be placed over the pan-rest for the triple-ring compact, triple ring or Dual burner (depending on models). Warning: ■ The flat-bottomed pans are to...

Page 25 - CLEANING and MAINTENANCE; GENERAL ADVICE; and disconnected from the electrical power supply.; ENAMELLED PARTS; Dry preferably with a soft cloth.; STAINLESS STEEL SURFACES; Clean using an appropriate product. Always dry thoroughly.; irreparably damage the surface.; GAS TAPS

25 CLEANING and MAINTENANCE GENERAL ADVICE ■ Before you begin cleaning, you must ensure that the appliance is switched off and disconnected from the electrical power supply. ■ Important: The use of suitable protective clothing/gloves is recommended when handling or cleaning of this appliance. ■ Unde...

Page 26 - BURNERS; Both the probe and ignition plug must be very carefully cleaned.; CORRECT REPLACEMENT OF THE AUXILIARY, SEMI-RAPID AND RAPID; CORRECT REPLACEMENT OF THE TRIPLE-RING COMPACT (model; It is very important to check that the burner flame spreader “

26 BURNERS ■ These parts can be removed and cleaned with appropriate products. ■ After cleaning, the burners and their flame spreaders must be well dried and correctly replaced. ■ Check that the electrode/s “ S ” (figs. 15a, 15c, 15d, 15e) next to each burner is/are always clean to ensure trouble-fr...

Page 28 - PAN SUPPORTS; These parts can be removed and cleaned with appropriate products.

28 PAN SUPPORTS ■ These parts can be removed and cleaned with appropriate products. ■ After cleaning, they must be well dried and correctly replaced. ■ It is very important to check that the pan supports have been correctly positioned. Failure to do so can cause serious problems. ■ The prongs of the...

Page 29 - SERVICE AND MAINTENANCE; 30 or 240 VAC power supply is connected.; Servicing the appliance:; LUBRICATION OF THE GAS TAPS

29 SERVICE AND MAINTENANCE If the ignition spark fails to ignite or does not light the gas, check the following items before calling our Customer Service Centre to obtain the nearest Authorised Delonghi Service Agent: ■ Burner is reassembled and located correctly. ■ Spark electrode and white ceramic...