DeLonghi DE302GB - Manual - manualsarea.com

Page 2 - PRODUCT LABEL

2 Dear Customer, Thank you for having purchased and given your preference to our product. The safety precautions and recommendations reported below are for your own safety and that of others. Theywill also provide a means by which to make full use ofthe features offered by your appliance. Please kee...

Page 3 - IMPORTANT PRECAUTIONS AND RECOMMENDATIONS; WARNING; Keep children away from the appliance when it is in use.

3 IMPORTANT PRECAUTIONS AND RECOMMENDATIONS FORUSE OF ELECTRICAL APPLIANCES Use of any electrical appliance implies the necessity to follow a series of fundamentalrules. In particular: ■ Never touch the appliance with wet hands or feet; ■ o not operate the appliance barefooted; ■ o not allow childre...

Page 4 - INSTALLATION; appliance; ELECTRICAL REQUIREMENTS; suitable for the power consumed by the appliance.

4 INSTALLATION CAUTION: ■ This appliance must be installed in accordance with these installationinstructions, local gas fitting regulations, municipal building codes,water supply regulations, electrical wiring regulations, - Gas Installations and ony other relevant statutory regulations. ■ This appl...

Page 5 - Figure 1; BURNER COOKING HOB; Figure 2

N.B. The connection of the appliance to earth is mandatory. If the installation requires alterations to the domestic electrical system call a qualifiedelectrician. He should also check that the socket cable section is suitable for the power drawnby the appliance. Replacing the power cord must be don...

Page 7 - partition; between the; should; Figure 5; Overhead clearances; Standards requirement; Temperature of nearby surfaces.

7 The installation shall complywith the dimensions in Figures3 and 4, bearing in mind that: ■ A partition between the base of the hob and thecupboard below should be fitted 0 mm below the workbench surface if the cupboard isto be used for storage. ■ 500 mm 650 mm 450 mm 100 mm minimum between the si...

Page 8 - FASTENING THE COOKTOP

Figure 6 Figure 7 8 3 cm min 3 cm 4 cm S A R Adhesiveside G G R R FASTENING THE COOKTOP Each cooktop is provided with an instal-lation kit including brackets and screwsfor fastening the cooktop to benches from30 to 40 mm thick.The kit includes four R brackets and four self-threading screws S (figs. ...

Page 9 - Figure 9; Gas connection for

GAS SUPPLY: ■ This appliance is suitable for use with Natural Gas or ULPG . (Check the “gas type” sticker attached to the appliance). ■ For Natural Gas the gas supply must be regulated to obtain a pressure of 1 kPa with t burners operating. ■ For ULPG models connect the gas supply directly to the ap...

Page 10 - where a Natural gas / ULPG conversion has been completed.; INSTALLATION WITH A FLEXIBLE HOSE ASSEMBLY; : After connection the installer must check that the; IMPORTANT WARNING; : The installer shall ensure the hose assembly is

5. Check the minimum burner setting by quickly rotating the gas control knob from the maximum to the minimum position, the flame must not go out. If adjust-ment is required carry out the “minimum burner setting adjustment" proceduredescribed below. 6. If satisfactory performance cannot be obtain...

Page 11 - TABLE FOR THE CHOICE OF THE INJECTORS; Natural Gas; Burner

(Note: Gas type sticker and data plate are attached to the underside of the base ofthe appliance.) TABLE FOR THE CHOICE OF THE INJECTORS Natural Gas ULPG Test Point 1.0 2.75 Pressure (kPa) Burner Injector Orifice Gas Consumption Injector Orifice Gas Consumption [mm] [MJ/h] [mm] [MJ/h] Semi-rapid 1.1...

Page 12 - REPLACING THE INJECTORS; To replace the injectors proceed as follows:; IMPORTANT

Figure 11 Figure 12 12 CONVERSION PROCEDURE (to convert to Natural gas or toULPG) REPLACING THE INJECTORS The conversion procedure must be carried out only by an authorised person. This appliance is suitable for use with Natural gas or Universal LPG (check the “gastype” sticker attached to the appli...

Page 13 - MINIMUM BURNER SETTING ADJUSTMENT; Normally for; LUBRICATING THE GAS TAP

Figure 13 13 MINIMUM BURNER SETTING ADJUSTMENT Check whether the flame spreads to all burner ports when the burner is lit withthe gas tap set to the minimum position. If some ports do not light, increase theminimum gas rate setting. Check whether the burner remains lit even when the gas tap is turne...

Page 14 - USE and CARE; “1 BURNER COOKING HOB”; COOKING POINT; Triple ring burner control knob; “2 BURNER COOKING HOB”; The appliance is class 3 rated; COOKING POINTS; Do NOT use or store flammable materials near this appliance.; Do NOT modify this appliance.

USE and CARE CAUTION: ■ This appliance must be used only for the task it has explicitly been designed for, that is for domestic cooking of foodstuffs. Any other form of usage is tobe considered as inappropriate and therefore dangerous. Do not use thisappliance as a space heater. ■ Do NOT place combu...

Page 15 - LIGHTING GAS BURNERS; Check that the electricity is switched on to allow spark ignition.

LIGHTING GAS BURNERS ■ Check that the electricity is switched on to allow spark ignition. ■ Make sure that all controls are turned to zero. ■ The gas flow to the burner is controlled by a tap incorporating a safety cut-offvalve. If the burner flame should go out for some reason, the safetyvalve will...

Page 16 - Burners; to 2 cm; COOKING HINTS FOR GAS HOBS; Wok pans max 36 cm

LIGHTING GAS BURNERS (FITTED WITH SAFETY CUT-OFF VALVE) In order to light the burner, you must: 1 – Turn the knob fig. 1 7 in anti-clockwise direction up to the maximum aperture, push in and hold the knob; this will light the gas. If there is no mains electricalsupply, bring a lighted match close to...

Page 17 - CORRECT USE OF TRIPLE-RING BURNER; To use the WOK you must place the wok stand in the; CORRECT; position as; WRONG

CORRECT USE OF TRIPLE-RING BURNER - DE30WGB model only ■ The flat-bottomed pans are to be placed directly onto the pan-support. ■ To use the WOK you must place the wok stand in the CORRECT position as shown in fig. 20. Figure 21 17 Figure 20 WRONG CORRECT Figure 19 Figure 19

Page 18 - Cleaning and Maintenance; GENERAL ADVICE; GLASS SURFACE; All traces of the cleaner must be removed with a damp cloth.

Cleaning and Maintenance 18 GENERAL ADVICE ✓ Before you begin cleaning you must ensure that the hob is switched off. ✓ It is advisable to clean when the appliance is cold and especially when cleaning theenamelled parts. ✓ All enamelled surfaces have to be washed with soapy water or some other non-ab...

Page 19 - ENAMELLED PARTS; STAINLESS STEEL SURFACES

ENAMELLED PARTS ✓ All the enamelled parts must be cleaned with a sponge and soapy water only or othernon-abrasive products. ✓ Dry preferably with a soft cloth. ✓ If acid substances such as lemon juice, tomato conserve, vinegar etc. are left on theenamel for a long time they will etch it, making it o...

Page 20 - NEVER unscrew the burner plate fixing screws (fig.

IMPORTANT WARNING NEVER unscrew the burner plate fixing screws (fig. 22). The burner plates can be removed ONLY by an authorised service agent. Damage to the appliance will occur if not observing this condition and this mayresult in serious injury to the user. The manufacturer declines every respons...

Page 21 - BURNERS AND GRIDS

BURNERS AND GRIDS ✓ These parts can be removed and cleaned with appropriate products. ✓ After cleaning, the burners and their flame spreaders must be well dried and correctlyreplaced. ✓ It is very important to check that the burner flame spreader and the cap have been cor-rectly positioned. Failure ...

Page 23 - CORRECT POSITIONING OF THE TRIPLE RING BURNER

A B Flamefailureprobe " T " Ignitor " S " CORRECT POSITIONING OF THE TRIPLE RING BURNER Figure 26 Figure 27 Figure 28 Figure 29 ✓ The triple ring burner must be correctlypositioned (see fig. 26 ); the burner ribs must be fitted in their housing asshown by the arrow.The burner correct...

Page 24 - SERVICE AND MAINTENANCE; Servicing the appliance:

SERVICE AND MAINTENANCE If the ignition spark fails to ignite or does not light the gas, check the followingitems before calling our Customer Service Centre to obtain the nearest AuthorisedDelonghi Service Agent: ■ Burner is reassembled and located correctly. ■ Spark electrode and white ceramic are ...

DeLonghi DE302GB - Manual

Table of Contents:

Other Manuals for DeLonghi DE302GB

Summary

Other DeLonghi Hobs Models