Dakota Digital MCL-2002 - Manuals

Page 2 - Mounting in a Dash with Cable Drive speedometer and rubber mounts

MAN# 650280:D Mounting in a Dash with Cable Drive speedometer and rubber mounts • Remove the dash • Unbolt and unplug the factory gauge • Install the rubber mounts and foam tape around the new Dakota Digital gauge. The tape should apply to the side of the gauge can and be against the bottom of the b...

Page 4 - ignition switch can be used for this.; GROUND; erratic operation.

MAN# 650280:D • Remove the dash • Unclip and unplug the factory gauge • Remove the rubber gasket from the factory gauge bezel. • Install gasket over the bezel of the Dakota Digital gauge. The gasket doesn’t cover the entire bezel; there should be some chrome showing when the gasket is installed. • U...

Page 5 - The neutral, low oil, and check engine indicators are activated by; CLOCK

MAN# 650280:D STATUS AND WARNING INDICATORS The right turn, left turn, and high beam indicators are activated by 12 volts at their respective hook-up wires. The right turn signal wire is green, the left turn signal wire is orange, and the high beam wire is purple. These can be connected to the same ...

Page 6 - Description; SPEEDOMETER SETUP/CALIBRATION; Auto Cal

MAN# 650280:D The setup menus are entered by holding the switch in while turning the key on. The menus are as follows: Menu Description AUTO auto calibrate speed ADJUST adjust calibrate speed S SET miles to service setting PERF turn on/off performance displays NIGHT turn on/off automatic night dimmi...

Page 7 - Rpm warning setup; Bar graph color selection

MAN# 650280:D S SET S SET S SET S SET Miles to Next Service setup The service mileage is a countdown mile meter. The service mile display can be disabled or can be set to count down from 500 – 7500 miles. If the service mileage is enabled and it gets to 0 miles it will display “ S -DvE ” each time t...

Page 8 - releasing the switch to store the gear position quicker.

MAN# 650280:D W WW WX XX XArn Arn Arn Arn V Voltage warning setup • Press and release the switch until “ WXArn V ” is displayed, then press and hold the switch until “ - “ is displayed. • Release the switch. The current warning point will be displayed ( 9 . 0 – 12 . 1 ). • Press and release the swit...

Page 9 - Tach signal setup; SignaL; Info menu; yes

MAN# 650280:D SignaL SignaL SignaL SignaL Tach signal setup • Press and release the switch until “ SignaL ” is displayed, then press and hold the switch until “ - “ is displayed. • Release the switch. The current setting will be displayed ( 12 HI or 5 LO ). • Press and release the switch until the d...

Page 10 - Battery input voltage:

MAN# 650280:D WIRING COLOR CODE FOR GAUGE: 2003 and older HD MCL-2002* Stock harness color Function YELLOW PINK or YELLOW /BLUE* tachometer signal PINK BLACK/YELLOW “ENGINE” indicator (-) BLACK BLACK ground (connect directly to battery negative) W HITE/BLUE connected to function switch W HITE W HITE...

Page 11 - Troubleshooting guide; Problem

MAN# 650280:D Troubleshooting guide Problem Possible cause Solution Gauge will not light up. Red wire does not have power. Connect to a location that has power. Black wire is not getting a good ground. Connect ground to a different location. Gauge is damaged. Return gauge for repair. (see instructio...