Dakota Digital MCL-2002 - Manual
Dakota Digital MCL-2002 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Mounting in a Dash with Cable Drive speedometer and rubber mounts
- Page 4 – ignition switch can be used for this.; GROUND; erratic operation.
- Page 5 – The neutral, low oil, and check engine indicators are activated by; CLOCK
- Page 6 – Description; SPEEDOMETER SETUP/CALIBRATION; Auto Cal
- Page 7 – Rpm warning setup; Bar graph color selection
- Page 8 – releasing the switch to store the gear position quicker.
- Page 9 – Tach signal setup; SignaL; Info menu; yes
- Page 10 – Battery input voltage:
- Page 11 – Troubleshooting guide; Problem
MAN# 650280:D
MODEL MCL-2002
TANK MOUNT SPEEDOMETER/TACHOMETER
*To avoid damage to motorcycle, please see Speedometer, Tachometer, and Status and Warning Indicators sections for details on locating
VSS, Tachometer, and indicator wires for most motorcycle applications
**For 2004+ HD utilizing the “Fat Bob” tank mount, please see our MCL-2004, it is designed as a direct plug-in gauge for these models. The
Check Engine indicator will not function using this gauge on 2004+ HD models due to the signal being fed through the ‘data bus’.
Mounting:
The base system is universal enough to fit in either a new-style, clip-in
(1995 or newer) or into the older style, bolt-in. The rubber mounts with studs on
both sides are used for the bolt-in style. The L-brackets are used for the clip in
style. The ¼” ABS ring is used for Deuce mounting.
Mounting hardware for the bolt-in system
with a speedometer cable
Mounting hardware for the clip-in system with an electric
transmission speed sensor.
IMPORTANT NOTE!
This gauge has an odometer preset option that is only available for the first
100 miles (160km) of operation. See “preset odometer” for instructions.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
MAN# 650280:D Mounting in a Dash with Cable Drive speedometer and rubber mounts • Remove the dash • Unbolt and unplug the factory gauge • Install the rubber mounts and foam tape around the new Dakota Digital gauge. The tape should apply to the side of the gauge can and be against the bottom of the b...
MAN# 650280:D • Remove the dash • Unclip and unplug the factory gauge • Remove the rubber gasket from the factory gauge bezel. • Install gasket over the bezel of the Dakota Digital gauge. The gasket doesn’t cover the entire bezel; there should be some chrome showing when the gasket is installed. • U...
MAN# 650280:D STATUS AND WARNING INDICATORS The right turn, left turn, and high beam indicators are activated by 12 volts at their respective hook-up wires. The right turn signal wire is green, the left turn signal wire is orange, and the high beam wire is purple. These can be connected to the same ...
