Dakota Digital MCL-30K-TCH - Manual
Dakota Digital MCL-30K-TCH – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – WIRING
- Page 4 – FACTORY DEFAULT SETTINGS FOR SETUP MENUS; Engine Cylinders
- Page 5 – Display update setup
- Page 6 – Gear indicator setup; releasing the switch to store the gear position quicker.; Tach signal setup; Possible cause
- Page 7 – SERVICE AND REPAIR
1
MAN#650336
MCL-30K-TCH
Thank you for purchasing the Dakota Digital MCL-30K-TCH gauge for your Harley Davidson Touring bike. This kit is
designed to be a replacement for all touring models, from 1996 – 2003. This is part of a six gauge package for touring
models so you can add additional gauges as you choose.
INSTALLATION
First read and familiarize yourself with all of the components and this manual. The first step is to remove the
seat and disconnect the negative side of the battery, as with any electronic install. Once the battery is disconnected you
are ready to start.
Remove the outer fairing for FLHT models; this will vary from model to model, please follow the service manual
to expose the wiring and gauges. Road Glide (FLTR) models will not need the outer fairing removed.
Ultra (FLHT) with outer removed
Remove Factory Gauge
Now you are ready to start unplugging and removing the gauge.
ULTRA FLHT (batwing fairings)
Remove the clamps that hold the Speed and Tach in place with a screw driver or wrench depending on
application, and remove the gauges.
Remove nuts/screws and clamp to remove factory gauges
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
3 MAN#650336 WIRING First locate your tachometer connector in the factory wiring harness that were unplugged from the original tach gauge. The wires needed for the Dakota Digital tachometer should all be found here. The factory connector can be cut off or the new wires can be spliced into the harnes...
4 MAN#650336 FUNCTION SWITCH If an MCL-30K-SPD gauge is installed, then the factory speedometer push button switch is used as the main function switch, otherwise a push button switch should be connected and mounted to allow access to all of the gauge features. The function switch is used for setup a...
5 MAN#650336 TACHOMETER SETUP Main Menu Sub Menu Description CL set clock time tCH nigHt set night dimming level t CAL set engine cylinder setting vPdAtE set rpm update rate for digital readout WXArN set rpm shift warning point geAr transmission gear programming SIgnAL select 12 HI (normal) or 5 LO ...
