Dakota Digital CLK-1002B - Manual
Dakota Digital CLK-1002B – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – DASH CUTOUT
- Page 3 – SERVICE AND REPAIR
- Page 4 – Technical specifications; volts; ODYSSEY SERIES DIGITAL GAUGE LIMITED WARRANTY
CLK-1002B rev. A
DIGITAL CLOCK TO MATCH VFD-1002B
Introduction:
The Odyssey gauge series from Dakota Digital, Inc. incorporates the reliability and quality of our
standard gauges, along with several unique features and easy mounting. These features include:
•
Quartz
accuracy.
•
Night dimming feature.
•
Very low standby power to prevent battery drain.
•
High Visibility VFD display for sunlight readability.
The Odyssey series clock displays the current time in 12 hour format. The high brightness display
matches our other Odyssey and STR series gauges and has the same night brightness dimming capability.
Operation:
The gauge needs the red, orange, and black wires connected to operate. The red wire should have
switched 12 volt power from an ACC. point on the fuse panel. The orange wire should have constant 12 volt
power. The black wire should be connected to a good ground point. When the blue wire has 12 volts, it will dim
the display for night viewing.
Setting the time:
Using a small, thin object such as a toothpick or pin, press “set” buttons through front lens access holes.
The access holes are on the right side of the lens. Top “set” button advances hours, bottom “set” button
advances minutes. Each time that you make a change to either the hours or minutes, the seconds are reset to
zero.
Adjusting the accuracy:
The clock is accurate to +/-2 minutes a month as it is sent. It can be tuned for better accuracy if
desired. Press and hold both of the set buttons for several seconds. The clock will display “C 0”. The “C”
indicates that it is in the calibration mode and the second number is the current calibration value. The
calibration value indicates the number of seconds to add or subtract each day. The clock can be adjusted from
+7 sec/day to -7 sec/day.
Press the minute set button to change the cal value. Press the hour set button to return to normal clock
operation.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Wiring: BLACK - connect to a good ground point in the vehicle. RED - connect to switched 12 volt power point. (An accessory terminal will work for this.) ORANGE - connect to a constant 12 volt power point. (This will keep the correct time.) BLUE - connect to the tail light circuit. Mounting: The gau...
Troubleshooting guide. Problem Possible cause Solution Clock will not light up Red wire does not have Connect to a location that has power power. when the key is on. Orange wire does not have Connect to a location that has power power. all of the time. Black wire is not getting Connect ground to a d...
Technical specifications Minimum operating voltage - 7 volts Maximum operating voltage - 18 volts (operating at or near maximum rating for an extended time can damage unit) Clock accuracy - ± 2 minute per month Typical current draw (@ 13.8V) - 0.13 A Standby current draw (key off) - 0.002 A ODYSSEY ...
