Dakota Digital UTV-1000 - Manual
Dakota Digital UTV-1000 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – page 2; Be sure to check engine oil level and add oil if needed
- Page 3 – page 3; SETUP
- Page 4 – page 4
- Page 5 – page 5; ADDITIONAL SETUP NOTES
- Page 6 – page 6; st odo
- Page 7 – page 7; TROUBLESHOOTING; RANGE
- Page 8 – page 8; SERVICE AND REPAIR; ©Copyright 2009 Dakota Digital Inc.
page 1
MAN#650231:A
UTV-1000
Multi Gauge for
2004-2006 Yamaha Rhino
Operation menu
Left switch functions
Pressing the left switch during normal gauge operation will move through the below commonly viewed functions
for convenience.
00000.0
Odometer
12:00A
Clock (hold left switch to set)
Setting clock:
Left switch press moves between hours and minutes
Right switch press changes current value
Hold left switch again to exit clock set mode
H 0.0
Hourmeter
Right switch functions
Pressing the right function switch during normal operation will scroll through the following display functions. A
heading will first appear after each press to display what display function is currently selected. After about 2
seconds, the display will show the data for the selected function.
Heading
Data
Description
trip A
a 0.0
Trip A (hold right switch to reset)
trip b
b 0.0
Trip B (hold right switch to reset)
srv mi
(
srv km
)
s 0000
Count down Service odometer if enabled (hold right switch to reset)
srv hr
sh 000
Count down service hour meter if enabled (hold right switch to reset)
mph
(
KPH
)
00 mph
(
00 KPH
)
Alternate speed display (hold right switch to change primary unit)
tach
r 0000
Tachometer displays in information center
IMPORTANT NOTE!
This gauge has an hour meter and
odometer preset option available only
for the first 1.0 engine hour and 10
miles (16km). See “ODO/HR
PRESET” for instructions.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
page 2 MAN#650231:A INSTALLATION: 1. Disconnect the battery to prevent possible damage to the electrical system or gauge during install. 2. Remove the stock gauge or indicator panel (see service manual for removal instructions). The UTV gauge will mount in this mounting location. 3. Remove the seats...
page 3 MAN#650231:A 6. Fuel sender installation (optional tube sender from Dakota Digital): a. To mount the sensor you will need to drill a hole in the fuel tank. Use a 1” hole saw, and drill a hole adjacent to the small dimple on the gas tank closest to the passenger side of the vehicle. Use a fuel...
page 4 MAN#650231:A Pulls up all values on speed and speed pulses in odometer Press Right switch to finish cal and save value ADJUST Adjust speed cal while driving ADJUST Each press of left switch toggles direction of adjustment, right switch to save and exit SRV MI ( SRV KM ) Sets value of servi...
