Dakota Digital HLY-2000 - Manual

Dakota Digital HLY-2000

Dakota Digital HLY-2000 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
Page: / 6

Table of Contents:

  • Page 2 – now restart in normal mode with the new speed calibration.
  • Page 3 – TACHOMETER; light up two bars above the corresponding number.; TACHOMETER RED LINE/SHIFT INDICATOR; will go out and then start back at 2.; TURN SIGNAL & HIGH BEAM INDICATORS; The right turn, left turn, and high beam indicators are; TRIP ODOMETER; The trip odometer is activated by the push button
  • Page 5 – Dakota Digital
Loading the manual

VFD DIGITAL INFORMATION SYSTEM

Dakota Digital

SERIES II

The latest in digital technology for the

motorcycle enthusiast.

INSTALLATION AND OPERATION MANUAL

Please read this before beginning installation or wiring.

MODEL HLY-2000

SPEEDOMETER/TACHOMETER

INFORMATION SYSTEM

Dakota Digital

3421 W. Hovland Ave.

Sioux Falls, SD 57107

Phone: (605) 332-6513

FAX: (605) 339-4106

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - now restart in normal mode with the new speed calibration.

POWER Connect the red wire from the main harness to accessory power from the ignition switch. In addition to powering the display system, this is also where the low voltage detection circuit monitors the electrical systemvoltage. A good quality, solid state ignition switch should be used. The contac...

Page 3 - TACHOMETER; light up two bars above the corresponding number.; TACHOMETER RED LINE/SHIFT INDICATOR; will go out and then start back at 2.; TURN SIGNAL & HIGH BEAM INDICATORS; The right turn, left turn, and high beam indicators are; TRIP ODOMETER; The trip odometer is activated by the push button

TACHOMETER The tachometer is used by connecting the yellow wire from the main harness to the negative side of the coil or to an ignition module tach output. The tachometer is adjustable for 1, 2, or 8 cylinder settings. The 1cylinder setting is used for single-fire ignition systems without a buffere...

Page 5 - Dakota Digital

WARRANTY All DAKOTA DIGITAL instruments are warranted free of defects in material and workmanship for 3 years from the date of purchase. In the event of a problem with one of our products within the warranty period,DAKOTA DIGITAL will replace or repair the instrument at no charge. (The decision to r...

Other Dakota Digital Models

All Dakota Digital Other