Crimestopper FS-10 - Manuals

Page 2 - TABLE OF CONTENTS; Transmitter Programming..........................................................................................................7; INSTALLATION CAUTIONS & WARNINGS; BEFORE BEGINNING; or damage may occur. Electrical current limits for this alarm are; WE RECOMMEND that the MAIN SYSTEM FUSE be REMOVED; before jump starting, using a battery; DO NOT ROUTE ANY WIRING THAT MAY BECOME ENTANGLED; with brake, and gas pedals, steering

2 TABLE OF CONTENTS Installation Cautions & Warnings…….………………………………………………………….……….…….……2 Control Module & Component Mounting…………….………………………..…………………..….….…….…..3 Wiring……..……………………………………………………………………………………………………...…….4-5 Power Door Lock Wiring...…………………………………………………….………..………………….…………6 Transmi...

Page 3 - CONTROL MODULE MOUNTING; located by an intruder.; Driver’s Side Underdash; across from the driver’s side.; COMPONENT MOUNTING; Mount the Valet/Override/Program push-button in a hidden but

3 CONTROL MODULE MOUNTING DO NOT Mount the control unit in the engine compartment! DO NOT Mount the control unit or wiring harness where they can become entangled with moving parts such as brake/gas/clutch pedals, or the steering column! The alarm control module should be mounted in a concealed loca...

Page 4 - WIRING; YELLOW WIRE: IGNITION SWITCHED “ ON ” AND “ START ” 12 VOLTS; and; “START”

4 WIRING GREEN WIRE: (-) DOOR TRIGGER Identify the wire that reads ground when any door is open and 12 volts when all doors are closed. Some vehicles may have isolated door triggers. In this case you may need to run additional wires from other doors or go directly to the wire that triggers the vehic...

Page 5 - Connect to RED siren wire from the Siren in the engine compartment.; WHITE WIRE: Two 12V FLASHING LIGHT; The sensor supplied with; SENSOR ADJUSTMENT

5 WIRING ORANGE WIRE: (-) NEGATIVE ARMED OUTPUT / STARTER DISABLE (500mA Ground, Optional) This wire becomes a (-) Ground Output when the System is Armed. This output is used for disabling the starter or to activate optional devices such as extra sensors, LED’s, window roll-up modules, voice modules...

Page 6 - POWER DOOR LOCK WIRING; NEGATIVE TRIGGER DOORLOCK WIRING

6 POWER DOOR LOCK WIRING GREEN WHITE: (-) Negative LOCK Pulse, BLUE WHITE: (-) Negative UNLOCK Pulse NEGATIVE TRIGGER DOORLOCK WIRING POSITIVE TRIGGER DOORLOCK WIRING GREEN WHITE GREEN WHITE FUSED+12V BLUE WHITE + BLUE WHITE 86 85 86 85 87 87 30 87A 30 87A FACTORY FACTORY L L POWER POWER LOCKING LOC...

Page 7 - REMOTE TRANSMITTER PROGRAMMING; is waiting for a 2; and flash the lights 3 times indicating its waiting for the 3; code and 4 times. If all 3 codes are learned,

7 REMOTE TRANSMITTER PROGRAMMING 1. Turn Ignition ON. 2. Press the Program/Override Button 4 times. After a few second delay, the unit will chirp and flash the lights 4 times. 3. Press button 1 on the remote control you wish to learn. You should get 2 light flashes indicating the unit is waiting for...

Page 8 - OPTION PROGRAMMING; flash the lights 5 times.; PROGRAMMING OPTIONS CHART

8 OPTION PROGRAMMING 1. Turn the Ignition ON and press the Override/Program button 5 times. After a slight delay, the system will chirp and flash the lights 5 times. 2. Within the next few seconds, press the Override/Program button [again] the number of times that corresponds to the feature list bel...

Page 9 - NOTE: Options can be instantly restored to Factory Default Values.; IGNITION CONTROLLED LOCKS

9 OPTION PROGRAMMING NOTE: Options can be instantly restored to Factory Default Values. To restore default values: Perform step #1 above, then press button 3. The siren and horn will chirp 4 times and lights will flash 4 times. Turn OFF Ignition. All programming options will be restored to * Default...

Page 10 - OPTION PROGRAMMING Cont.; DOUBLE UNLOCK PULSE; increase the risk of locking keys in the vehicle.

10 OPTION PROGRAMMING Cont. 6. DOUBLE UNLOCK PULSE The unit will send 2 Unlock Pulses when the #2 Unlock button is pressed. This feature may be required for interfacing this alarm with an existing Factory Keyless Entry or Alarm system in a vehicle. These systems are found on some Nissan, VW , Toyota...

Page 11 - OPERATING INSTRUCTIONS

11 OPERATING INSTRUCTIONS ACTIVE ARMING To arm the alarm and lock the doors, press the #1 Button (Lock Symbol) on the transmitter. You will hear a single siren chirp and the lights will flash once. The system will arm, the doors will lock and the starter will be disabled if these optional features a...

Page 12 - OPERATING INSTRUCTIONS Cont.; ALARM TRIGGER RESET

12 OPERATING INSTRUCTIONS Cont. ACTIVE RE-ARMING ( FAIL SAFE PROTECTION ) The Active Re-Arming feature allows the system will Re-Arm itself 40 seconds after being disarmed with the transmitter if a door has not yet been opened. This is handy if the vehicle is accidentally disarmed (via the transmitt...

Page 13 - EMERGENCY OVERRIDE & DISARM

13 OPERATING INSTRUCTIONS EMERGENCY OVERRIDE & DISARM If you have lost the transmitter or it stops working for any reason and the Alarm is armed, you will have to perform and Emergency Override to Disarm the Alarm. Open the door with the key, (alarm will sound). Turn the ignition on and press th...

Page 14 - CARJACK PROTECTION; ACTIVE CARJACK

14 CARJACK PROTECTION ACTIVE CARJACK This feature provides Active Carjack protection and must be enabled before use through Alarm programming (option 10). See page 8. W hen the Ignition is on (running), press button #2 ( Unlock Symbol ). Parking lights will flash TW ICE to confirm the Carjack countd...

Page 15 - LED / VALET SWITCH MOUNTING; the Alarm System is Armed.; WIRING: SHOCK SENSOR; RED

15 LED / VALET SWITCH MOUNTING LED: The LED is used as a System Status Indicator and it will also FLASH for use as security deterrent when the Alarm System is Armed. VALET SWITCH: Mount the Valet Switch (push-button) on dash or other accessible location. It is REQUIRED for Emergency Disarm, Programm...

Page 16 - WIRING DIAGRAM FS-10

16 WIRING DIAGRAM FS-10 Purple Green/white Blue Brown/white Red Black Blue/white Yellow Orange Green Brown Gray White Ground 12 Volt Battery Hood Switch Door Switch (-) 86 85 87 30 87A (-) Ignition Sense (+) (-) (-) Starter Kill Relay (-) (-) Arm Horn Honk Factory Car Horn (+) Parking Lights Trunk P...