Crimestopper EZ-10 - Manuals

Page 2 - VENDORS

TABLE OF CONTENTS Operation Cautions & Warnings…….……………..….…………………………………….…………………………2 Remote Control Diagrams………...……………………………………………………………………………...…….3 Remote Engine Control…………….…..…………………………………………………………………….……….4-6 Turbo Timer Mode……………………………….……………………………………...………………………………7 Convenience and Saf...

Page 3 - REMOTE CONTROL DIAGRAMS; LOCK; Flashlight; “COOLFLASH” BLUE LED FLASHLIGHT; NOTE: REMOTE START BUTTON DELAY

REMOTE CONTROL DIAGRAMS #1 #2 #3 LOCK ENGINE UNLOCK VEHICLE #2 FLASHLIGHT START/STOP EZ-30 EngineStart/Stop Flashlight Vehicle#2 EZ-10 System EZ-30 SYSTEM The transmitter supplied with the EZ-30 system has 5 buttons total. The button configuration of the EZ-30 is Factory-set and unchangeable. See Pa...

Page 4 - REMOTE ENGINE CONTROL; REMOTE ENGINE STARTING - SUCCESSFUL START:; IGN; REMOTE ENGINE STARTING - UNSUCCESSFUL START; NO FURTHER; TURNING OFF A REMOTE STARTED ENGINE:; RUN TIME RESET

REMOTE ENGINE CONTROL REMOTE ENGINE STARTING - SUCCESSFUL START: 1) Press the remote start button for at least 1 second. 2) Parking lights flash once; return solid, and the Ignition/Acc circuits turn on. 3) After a few seconds the Starter Motor engages, Parking lights and Acc circuits will turn off ...

Page 5 - ENTERING YOUR REMOTE STARTED VEHICLE:; now controlling your vehicle.

REMOTE ENGINE CONTROL ENTERING YOUR REMOTE STARTED VEHICLE: 1) With engine running, Remote Unlock system (EZ-30) or open door with key. 2) Enter vehicle and be careful not to step on brake pedal! (Remote Start Reset) 3) Turn Ignition to ON/RUN position, then press brake pedal to reset the Remote Sta...

Page 6 - INFINITY RUN MODE; INDEFINITELY after the programmed run time elapses; INFINITY RUN MODE – EXITING THE VEHICLE:; then press and release the remote start button a second time.; ENTERING A VEHICLE DURING IDLE-DOWN or INFINITY RUN MODES:; See “Entering Your Remote Started Vehicle” on Last page.; SELECTABLE HOURLY COLD-START MODE – EXITING THE VEHICLE:

REMOTE ENGINE CONTROL INFINITY RUN MODE This mode can only be activated when "Idle Down" procedure. The Infinity Run mode allows the vehicle engine to remain running INDEFINITELY after the programmed run time elapses . This mode will allow the vehicle to be left running and unattended withou...

Page 7 - engine should remain running for the selected number of minutes.

TURBO TIMER MODE (OPTIONAL) The optional Turbo Timer mode allows the EZEE Start system to keep a Turbo or Turbo Diesel vehicle running for 1 to 5 minutes [selectively] after you remove the key, exit the vehicle, and lock the doors remotely. This is handy for turbo cool-down without the need for expe...

Page 8 - CONVENIENCE AND SAFETY FEATURES; HOOD OPEN SAFETY (Requires grounding hood pin installation)

CONVENIENCE AND SAFETY FEATURES EZ-30 ONLY: KEYLESS ENTRY (POWER DOOR LOCK CONTROL, Optional) This system enables you to remotely lock and unlock the vehicle’s doors (if equipped with power locks) via remote control for safety and convenience. Note: This feature may require extra labor and/or parts ...

Page 9 - BRAKE PEDAL RESET; TRANSMITTER PROGRAMMING; get 2 light flashes indicating the unit is waiting for a 2; unit will flash 3 times indicating its waiting for the 3; code and so on. If all 4 codes are learned, the unit will

CONVENIENCE AND SAFETY FEATURES BRAKE PEDAL RESET Prevents starting or shuts off a remote started vehicle when this circuit is active or activated. Prevents unauthorized tampering. This circuit shuts the system down immediately when brake pedal is pressed if the key is not in ignition and turned to ...

Page 10 - TRANSMITTER PROGRAM DIAGRAM:

TRANSMITTER PROGRAMMING TRANSMITTER PROGRAM DIAGRAM: IGN OFF WAIT FOR 4 FLASHES PRESS 4X's FLASH 2, 3, or 4 X's (GRAY WIRE GROUNDED) EZ-30 IGN OFF PRESS PRESS LOCK BUTTON EZ-10 COMPLETE START BUTTON 10

Page 11 - TROUBLESHOOTING: “BEFORE YOU CALL” SECTION; UNIT WILL NOT ATTEMPT A START (KEYLESS ENTRY FUNCTIONS NORMALLY):

2-VEHICLE OPERATION The EZ-30/10 systems can be used for 2 vehicle operation. A single remote can control a second vehicle with an identical system installed. There are some exceptions. See “Multi-Vehicle Notes” section below. VEHICLE #2 Press lower side buttonfirst, then you have4 seconds tocontrol...

Page 12 - UNIT FLASHES LIGHTS ONCE AND WILL NOT ATTEMPT A START:

TROUBLESHOOTING: “BEFORE YOU CALL” SECTION UNIT FLASHES LIGHTS ONCE AND WILL NOT ATTEMPT A START: The unit senses a fault at the Brake (Purple wire is active) or the Hood is OPEN (Gray wire grounded). This is a safety feature of the unit. Check installation for faults and make sure hood is closed an...