Page 2 - IMPORTANT NOTES FOR INSTALLATION AND OPERATION; This manual should be retained for future reference.
2 IMPORTANT NOTES FOR INSTALLATION AND OPERATION It is recommended that this manual be read thoroughly and that all instructions be followedcarefully. This manual should be retained for future reference. This is the safety alert symbol. It is used to alert you to potentialpersonal injury hazards. Ob...
Page 4 - SERVICE CONNECTIONS; DIMENSIONS
4 SERVICE CONNECTIONS A ID B C 14 1/2 [368] 20 7/8 [530] 4X WELD NUTSP5/16-18UNC 10 [254] 12 1/2 [318] 1 1/4 [32] G 2 1/8 [54] K H J F D 1 7/8 [48] SAFETY RELIEF VALVE E ELECTRICAL CONNECTION TO BE AS SPECIFIED ON DATA PLATE - CAPACITY 10 gallons 12 gallons MODEL KTG-10E KTG-12E 25 5/16 700 27 9/16 ...
Page 5 - INSTALLATION INSTRUCTIONS; The kettle must be installed in accordance with:
5 1.0 INSTALLATION INSTRUCTIONS Immediately after unpacking, check for possible shipping damage. If the kettle is found tobe damaged, save the packaging materials and contact the carrier within 15 days ofdelivery. 1. The kettle must be installed in accordance with: 2. State and/or local codes. 3. In...
Page 6 - Ground appliance to terminal provided inside console housing.
6 1.0 INSTALLATION INSTRUCTIONS (Continued) WARNING: Disconnect electrical power supply and place a tagat the disconnect switch to indicate you are on the circuit. 1. A waterproof electrical connection for power supply to console housing must be provided. 2. Ground appliance to terminal provided ins...
Page 7 - dial to the desired setting from 1 to 10.
7 2.0 INTRODUCTION DESCRIPTION Models KTG-6E (6 gallon capacity) and KTG-10E (10 gallon capacity) and KTG-12E (12gallon capacity) electrically powered, self-contained, countertop, tilting kettles. Each modelhas a jacket of double-wall construction forming a sealed reservoir around the lower two-thir...
Page 8 - OPERATING INSTRUCTIONS
8 3.0 OPERATING INSTRUCTIONS WARNING: The safety relief valve may discharge large amounts ofsteam and/or hot water. Keep away from the discharge tube at alltimes. Warn others in the area so they will not be startled by thesound. 1. Ensure that the external electrical shut-off to the kettle is on. 2....
Page 9 - Add water to kettle for cleaning purposes.; TILTING INSTRUCTIONS
9 3.0 OPERATING INSTRUCTIONS (Continued) 7. When cooking is finished set thermostat knob and power switch to the OFF position. 8. Pour finished product from kettle using tilt handle. Be careful to avoid splashing. 9. Add water to kettle for cleaning purposes. 10. Wash kettle thoroughly. See CLEANING...
Page 10 - CLEANING INSTRUCTIONS; Add water and mild detergent to the kettle immediately after use.; CAUTION: Do not use cleaning agents that are corrosive.; Should pitting or corrosion occur this is not covered by warranty.
10 4.0 CLEANING INSTRUCTIONS WARNING: Disconnect the power supply to the appliance beforecleaning or servicing. The kettle interior and exterior should be thoroughly washed after each use in preparationof a different food. 1. Add water and mild detergent to the kettle immediately after use. 2. Scrub...
Page 11 - Daily; provide a safe workplace.; Every Two Weeks; Perform a “try lever test” on the safety relief valve.; Every Six Months; Lubricate the bronze trunnion bearings.
11 5.0 MAINTENANCE Daily 1. Ensure there is adequate vacuum in the kettle jacket before operating. 2. Ensure that the appliance and controls are not damaged and that it can be safely operated. 3. Ensure the work area of the operator is not slippery and is clear of debris so as to provide a safe work...
Page 12 - VENTING INSTRUCTIONS; With an empty kettle, place power switch to the ON position.
12 6.0 TROUBLESHOOTING 6.1 LOW WATER LEVEL Proper water level must be maintained within the jacket for the kettle to operate. Depletionof water may occur from excessive opening of, or leakage through the safety relief valve. If water is below required operating level, either initially at start-up or...
Page 15 - FIRE FIGHTING MEASURES; PMCC; FLAMMABILITY LIMITS
15 4. FIRST AID EYES: Flush eyes with plenty of water. SKIN: Wash off in flowing water or shower. INGESTION: No adverse effects anticipated by this route of exposureincidental to proper industrial handling. INHALATION: Remove to fresh air if effects occur. Consult a physician. NOTE TO PHYSICIAN: No ...
Page 17 - (See Section 15 for Regulatory Information); HANDLING AND STORAGE; PERSONAL PROTECTIVE EQUIPMENT
17 MATERIAL SAFETY DATA SHEET Product: DOWFROST* HD HEAT TRANSFER FLUID, DYED Product Code: 04632 Effective Date: 02/20/01, Date Printed: 07/10/02, MSD: 002239 6. ACCIDENTAL RELEASE MEASURES (See Section 15 for Regulatory Information) PROTECT PEOPLE: Use appropriate safety equipment. For additional ...
Page 19 - ECOLOGICAL INFORMATION; (For detailed Ecological data, write or call the address; DISPOSAL CONSIDERATIONS; MATERIAL SAFETY DATA SHEET
19 SKIN: The LD50 for skin absorption in rabbits is >10,000 mg/kg. INGESTION: The oral LD50 for rats is 20,000 - 34,000 mg/kg. MUTAGENICITY: In vitro mutagenicity studies were negative. Animal mutagenicitystudies were negative. 12. ECOLOGICAL INFORMATION (For detailed Ecological data, write or ca...
Page 20 - (Not meant to be all-inclusive – selected regulations
20 FOR UNUSED & UNCONTAMINATED PRODUCT, the preferred options include sendingto a licensed, permitted: recycler, reclaimer, incinerator or other thermal destructiondevice. As a service to its customers, Dow can provide names of information resources to helpidentify waste management companies and...
Page 22 - CANADIAN REGULATIONS; This product is not a “Controlled Product” under WHMIS.; OTHER INFORMATION; MSDS STATUS: Revised to 16 section format.
22 CANADIAN REGULATIONS WHMIS INFORMATION: The Canadian Workplace Hazardous Materials InformationSystem (WHMIS) Classification for this product is: This product is not a “Controlled Product” under WHMIS. CANADIAN ENVIRONMENTAL PROTECTION ACT (CEPA) This product contains one or more substances which ...