Axis 25734 - Manuals - manualsarea.com

Page 2 - 4 HOUR TECHNICAL SUPPORT

- - ! ! SAFETY PRECAUTIONS IMPORTANT SAFEGUARDS 1. Read Instructions - All the safety and operating instructions should be read before the unit is operated. 2. Retain Instructions - The safety and operating instructions should be retained for future reference. 3. Heed Warnings - All warnings on the ...

Page 3 - GENERAL INSTRUCTIONS:; Teflon Tape; ASSEMBLING THE PRODUCT:; of Teflon Tape that will be needed during installation, put it

- - ! ! ELECTRICAL SPECIFICATIONS (OUTDOOR ONLY): NOTE: This unit is designed for operation in an upright position. Installing the unit upside down may cause damage to the internal equipment, and will void the warranty. Be sure the bracket is properly and securely mounted to a supporting structure c...

Page 4 - Installing the Axis 213 Camera; Install the camera onto the quick release bracket using

- - 2. In the kit there are (8) aluminum spacers - (4) 1" and (4) ½". Thread (2) spacers - (1) 1" and (1) ½" - on top of each of the (4) 2" spacers that are already located on the base bracket inside the housing. 3. Then start (3) 8-32x3/8” phillips head screws onto the 3½ inch s...

Page 5 - Only; ALARMS; Blue; Installing Axis 213 Camera; in housing

- - Connect the power plug and the ethernet cable to the back of the camera. CAMERA POWER +12 VDC -12 VDC Power Connection - Reference Only CONTROLRJ45 Ethernet Connector ALARMS 1 Alarm 1 Blue 2 Alarm 2 Violet 3 Alarm 3 Gray 4 Common White Installing Axis 213 Camera ( cont. ) 4. Mount the camera ass...

Page 6 - Installing Axis 214 Camera; The AXIS 214 camera requires 1” of spacing for optimal

- - Attach cameras using these (3) holes Installing Axis 214 Camera 1. Install the AXIS 214 camera to the 2685 mounting plate using the (3) 3mm x 12mm bolt and lock washers provided. 2. The AXIS 214 camera requires 1” of spacing for optimal position within the housing. Use the 4 (1”) spacers provide...

Page 8 - Wiring Connections; POWER; Red

- - Wiring Connections CONTROLRJ45 Ethernet Connector ALARMS 1 Alarm 1 Blue 2 Alarm 2 Violet 3 Alarm 3 Gray 4 Common White POWER 1 Camera Power (24VAC) Red 2 Camera Power (24VAC) Orange Installing Axis 231D/232D Camera ( cont. ) 7. Then start (3) 8-32x3/8” phillips head screws onto the (3) ½" sp...

Page 9 - FOR REFERENCE ONLY; Captive screw

- - 12. Now grab the camera assembly and connector the RJ45 cable and the input cable to the camera. Open screw slots Installing Axis 231D/232D Camera ( cont. ) 13. Attach the camera assembly to the housing by sliding the (3) open screw slots over the screws in the housing. Slide the bracket forward...

Page 10 - Installing Axis 233 Camera; Note the position of the mounting holes on the camera

- 10 - Installing Axis 233 Camera 1. Note the position of the mounting holes on the camera bracket (see diagram below). 5. Now attach (4) 1” spacers (located in the packet that came with the housing) to the base bracket. 2. Since the 233 camera operates on 24vac, the power board that is located insi...

Page 11 - Turn the camera counter-clockwise; Place the Quick Release plate onto the bottom of the; Make sure that the locking; Keyhole Slots

- 11 - Installing Axis 233 Camera ( cont. ) 8. Turn the camera counter-clockwise . 9. When the locking buttons hit the end of the keyhole slots, tighten the locking screw. 7. Place the Quick Release plate onto the bottom of the camera, Make sure that the locking screws on the AXIS 233 camera line up...

Page 13 - jumpers for; POWER WIRING; Four total power wires; Use the chart below to determine the correct gauge of wire

- 1 - The unit is setup with (2) individual power inputs. 1. Accessory Power (yellow and green wire) 2. Camera Power (red and orange) If you wish to provide a single power transformer it is recommended that: 1. Be certain that you know the total power consumption of the housing Heaters (25 watts) + ...

Page 14 - Housing Hardware; Replacement Parts List

- 1 - Part Number Description 1 RPFD7015 Lower Trim Ring 2 FD7T Tinted Replacement Capsule FD7C Clear Replacement Capsule 3 RPFD703 Dome Clamping Bracket 4 RPFD072 24 Vac Heater 5 RPFD080 (12 Vdc) Blower (Used In 24v Housings) 6 RPFD060 Camera Bracket 7 RPRH707 Connection Pcb 8 RPFD040 Housing Hardw...