Axis 25734 - Manual
Axis 25734 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – 4 HOUR TECHNICAL SUPPORT
- Page 3 – GENERAL INSTRUCTIONS:; Teflon Tape; ASSEMBLING THE PRODUCT:; of Teflon Tape that will be needed during installation, put it
- Page 4 – Installing the Axis 213 Camera; Install the camera onto the quick release bracket using
- Page 5 – Only; ALARMS; Blue; Installing Axis 213 Camera; in housing
- Page 6 – Installing Axis 214 Camera; The AXIS 214 camera requires 1” of spacing for optimal
- Page 8 – Wiring Connections; POWER; Red
- Page 9 – FOR REFERENCE ONLY; Captive screw
- Page 10 – Installing Axis 233 Camera; Note the position of the mounting holes on the camera
- Page 11 – Turn the camera counter-clockwise; Place the Quick Release plate onto the bottom of the; Make sure that the locking; Keyhole Slots
- Page 13 – jumpers for; POWER WIRING; Four total power wires; Use the chart below to determine the correct gauge of wire
- Page 14 – Housing Hardware; Replacement Parts List
Before attempting to connect or operate this product,
please read these instructions completely.
Product
Instructions
25734
81-IN6215
06/01/07
C O M M U N I C A T I O N S
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
- - ! ! SAFETY PRECAUTIONS IMPORTANT SAFEGUARDS 1. Read Instructions - All the safety and operating instructions should be read before the unit is operated. 2. Retain Instructions - The safety and operating instructions should be retained for future reference. 3. Heed Warnings - All warnings on the ...
- - ! ! ELECTRICAL SPECIFICATIONS (OUTDOOR ONLY): NOTE: This unit is designed for operation in an upright position. Installing the unit upside down may cause damage to the internal equipment, and will void the warranty. Be sure the bracket is properly and securely mounted to a supporting structure c...
- - 2. In the kit there are (8) aluminum spacers - (4) 1" and (4) ½". Thread (2) spacers - (1) 1" and (1) ½" - on top of each of the (4) 2" spacers that are already located on the base bracket inside the housing. 3. Then start (3) 8-32x3/8” phillips head screws onto the 3½ inch s...
