Autostart AS-6250V - Manuals

Page 2 - User Guide; Table of Contents; Transmitter Part Number and Module Serial; Parking Lights Flash Rate

P. 2 User Guide Table of Contents Transmitter Part Number and Module Serial Number............................................................... 3 Introduction ....................................................... 3 Basic Remote Operation .................................. 4 Remote-starting Your ...

Page 3 - Transmitter Part Number and Module Serial Number

User Guide P. 3 Transmitter Part Number and Module Serial Number Transmitter Part Number: The installer is to write in the boxes below the Module’s serial number and the location of the Valet Switch. Module Serial Number: Valet Switch is located (if installed): Introduction This Module is a state-of...

Page 4 - Basic Remote Operation; Pressing the; and; buttons at the same time will activate the; Remote-starting Your Vehicle; Setting Your Vehicle into Ready Mode

P. 4 User Guide Basic Remote Operation This system is equipped with a 5-button multi-channel transmitter. It can operate two in-dependent identically-equipped vehicles (see Multi-Car Operation for second-car transmitter functions). The functions of the transmitter are as follows: Note: Pressing the ...

Page 5 - Vehicle Presets; Heater & Heated Seat; Do not; Idle Mode

User Guide P. 5 quickly and remain lit. Skip to step 4. 3. Within 20 sec. of engaging the parking brake, press and hold LOCK , UNLOCK or START/STOP on the transmitter. The parking lights will flash 3 times quickly and remain lit. - 4. Remove the key: the engine will continue running. 5. Exit the veh...

Page 6 - manual transmission; Valet Modes; To put the system; into; To take the system; out of

P. 6 User Guide delivery or at a convenience store, lock your vehicle and leave it running for the length of a run cycle while you are away. To leave the vehicle in Idle Mode if your vehicle has an automatic transmission: 1. With the engine running, press the LOCK or UNLOCK button (to unlock the doo...

Page 7 - Ignition Valet; Mode; activate

User Guide P. 7 Ignition Valet The system can be placed in Valet Mode to disable the remote starting capabilities. If the vehicle needs to be serviced, or if you park it indoors, Valet Mode will prevent the engine from being accidentally started by remote control. To ENTER Valet Mode 1. With the key...

Page 8 - Or; To stop Panic Mode before the 1-minute delay, press the; Panic; Cold Weather Mode; enter

P. 8 User Guide 4. Flash twice again. Panic Mode Safety feature: Activate Panic Mode in an emergency situation. In an emergency situation, you can activate Panic Mode using the LOCK or UNLOCK or STOP button. This will: Shut down the engine, Unlock the doors (if UNLOCK is pressed) Or lock the door (i...

Page 9 - permanently disabled.; User-selectable Options; Note; the settings may affect the operation of your system.; Swap Start; START

User Guide P. 9 Priority Door Access This safety feature lets you unlock only the driver’s door when you press the UNLOCK button on the transmitter, and then UNLOCK the rest of the vehicle doors if the UNLOCK button is pressed for a second time within 3 seconds. Chirp Delete To temporarily disable t...

Page 12 - automatic transmission; Engine Run Time

P. 12 User Guide If your vehicle has an automatic transmission , proceed as follows to set the system in Turbo Mode : 1. With the engine already running, press the LOCK button on the transmitter until the parking lights come ON . 2. Remove the ignition key from the ignition switch. The engine will g...

Page 13 - press the

User Guide P. 13 Multi-Car Operation This option allows the owner of two vehicles, both equipped with identical systems, to control both systems with only one remote transmitter. To control the second vehicle, simultaneously press the TRUNK button and the button of the function you wish to use: Pres...

Page 14 - Parking Lights Flash Rate (Normal Operation)

P. 14 User Guide Parking Lights Flash Rate (Normal Operation) Flashes Description 1 • Doors locked, Alarm and starter kill armed. • Run time has expired. • TRUNK button pressed. • Start signal received by the module. • Cold weather mode cancelled. 2 • Remote start attempt cancelled by remote. • Door...