Autostart CT-1010 - Manual
Autostart CT-1010 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Installation Guide; Installation Points to Remember
- Page 3 – Harness Description; 2 PIN HARNESS
- Page 4 – How to Flash the Hood Pin
- Page 5 – MODE 1
- Page 6 – increase; OFF
- Page 7 – Retain Accessory Output; button of the; Resetting the Module; programming page for default values)
- Page 8 – Diagnostics - Parking Lights Flash Rate; FLASHES RATE
Keyless Entry And Alarm System
Notice
The manufacturer will accept no responsibility for any electrical damage resulting from
improper installation of the product, be that either damage to the vehicle itself or to the Unit.
This Unit must be installed by a certified technician using all safety devices supplied. Only
registered technicians will be eligible to use the Prostart technical support telephone
service. Please review the Installation Guide carefully before beginning any work
.
DOC
: 1.06
November 10, 2006
TL
Manufactured in Canada by Autostart
CT-1010
Installation Guide
Table of Contents
Included in the Kit
........................... 1
Installation Points to Remember
.. 2
Programmable Features
.................. 2
Harness Description
......................... 3
How to Flash the Hood Pin
........... 4
Programming a Transmitter
........... 4
Programming Options
.................... 4
Dome Light Delay.
........................... 7
Retain Accessory Output
............... 7
Zone 2 Disable Output
.................. 7
Multi-car Operation
........................ 7
Resetting the Module
...................... 7
Diagnostics - Parking Lights Flash
Rate
..................................................... 8
Closing Up
......................................... 8
Included in the Kit
Please review the installation guide before beginning the installation, especially the wiring diagram and the
programming options. It is very important that you familiarize yourself with the programming and operation of
the system, even if you have already installed an alarm system in the past. There are many great new features
that may be overlooked if the manual is not read: you would therefore not maximize the unit’s potential. Prior to
the installation, make sure that all the hardware components required to install the system are in the box.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
P. 2 Installation Guide Alarm-050 The following is a list of components included in the kit: o 1 – Control unit. o 2- CT-200 transmitters o 1 – plug-in L.E.D o 1 – Hood-pin switch o 1 – plug-in valet button. o 1 – user guide o 1 – installation guide. The kit also includes the following harnesses...
Installation Guide P. 3 4. Relock • If you unlock the doors with the remote transmitter, but do not open any door or trunk within 60 seconds, the doors will automatically relock. Harness Description 5 PIN HARNESS WIRE Wire colour Function Description 1 BLACK (-) CHASSIS GROUND INPUT This wire must b...
P. 4 Installation Guide 0 3 PIN CONNECTOR – 2 WIRE HARNESS Wire Wire colour Function Description 1 GREEN (–) Unlock output Programmable 500mA negative output: 1/10-sec., 7/10-sec., 4-sec. or double 1/4-sec. pulse ( ON 250 ms, OFF 500 ms, ON 250 ms) 2 No wire (+) 12V This pin provides +12V output for...
