Autostart AS-6250V - Manual
Autostart AS-6250V – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – User Guide; Table of Contents; Transmitter Part Number and Module Serial; Parking Lights Flash Rate
- Page 3 – Transmitter Part Number and Module Serial Number
- Page 4 – Basic Remote Operation; Pressing the; and; buttons at the same time will activate the; Remote-starting Your Vehicle; Setting Your Vehicle into Ready Mode
- Page 5 – Vehicle Presets; Heater & Heated Seat; Do not; Idle Mode
- Page 6 – manual transmission; Valet Modes; To put the system; into; To take the system; out of
- Page 7 – Ignition Valet; Mode; activate
- Page 8 – Or; To stop Panic Mode before the 1-minute delay, press the; Panic; Cold Weather Mode; enter
- Page 9 – permanently disabled.; User-selectable Options; Note; the settings may affect the operation of your system.; Swap Start; START
- Page 12 – automatic transmission; Engine Run Time
- Page 13 – press the
- Page 14 – Parking Lights Flash Rate (Normal Operation)
O N E - W A Y A U T O M A T I C / M A N U A L
T R A N S M I S S I O N R E M O T E S T A R T E R
W I T H
F U L L A L A R M S Y S T E M
DOC. 1.00
- AS-6250v -
- August 28, 2007 -
- MO -
Assembled in Canada
AS-6250v
User Guide
WARNING
It is the responsibility of the vehicle operator to ensure their vehicle
is parked in a safe and responsible manner.
1.
a) Manual transmission:
When leaving the vehicle, it is the user’s
responsibility to ensure that the gearshift lever is in the NEUTRAL
position and the parking brake is engaged in order to avoid accidents
upon remote starting.
b) Automatic transmission:
When leaving the vehicle, it is the user’s
responsibility to ensure that the gearshift lever is in “Park” in order to
avoid accidents upon remote starting.
(
Note:
Make sure that the automatic vehicle cannot start in "Drive".)
2. It is the user's responsibility to ensure that the remote starter is disabled
or put into valet mode before servicing.
FCC USER NOTICE (U.S.A.):
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
NOTE:
The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to
this equipment. Such modifications could void the user's authority to operate the equipment.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
P. 2 User Guide Table of Contents Transmitter Part Number and Module Serial Number............................................................... 3 Introduction ....................................................... 3 Basic Remote Operation .................................. 4 Remote-starting Your ...
User Guide P. 3 Transmitter Part Number and Module Serial Number Transmitter Part Number: The installer is to write in the boxes below the Module’s serial number and the location of the Valet Switch. Module Serial Number: Valet Switch is located (if installed): Introduction This Module is a state-of...
P. 4 User Guide Basic Remote Operation This system is equipped with a 5-button multi-channel transmitter. It can operate two in-dependent identically-equipped vehicles (see Multi-Car Operation for second-car transmitter functions). The functions of the transmitter are as follows: Note: Pressing the ...
