Autostart AS-6205 SH - Manual
Autostart AS-6205 SH – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Table of Contents; Started; Flashing; Auto Tach; IGN or 2; ACC or
- Page 3 – Introduction; The following is a list of components included in the kit:; Transmitters
- Page 4 – Before You Get; only when the Hood is up.; Always solder and tape all connections.; Harness Description
- Page 5 – -Pin Main Ignition Harness; -Pin Secondary Harness
- Page 6 – 2-Pin Accessories Harness
- Page 8 – plug Light
- Page 9 – YELLOW; Flashing the Hood Pin; What is F; Flash the Hood Pin
- Page 10 – Table 1; How to Enter Options Programming Mode; Table 2
- Page 11 – Options Programming
- Page 12 – Mode 2; Mode 3
- Page 13 – Ignition Valet - ENABLED; Mode 3 Function 4 Option1; Table 4
- Page 14 – Table 5; Multi-Speed Tach Programming; Table 6; Testing
- Page 15 – medium “tap”; the Shock Sensor will not; Closing Up; the last step before the initial powering of the Module; Supplementary Information; Fifth Relay Output (2; ACC or 2
- Page 16 – Ignition-Controlled Door Locks; Table 7; Secure Lock; Table 8; Turbo Mode
- Page 17 – Table 9; Siren or Horn Chirps
- Page 18 – Disarmed Notification; Trunk pin”; Resetting The Module; Events playback
- Page 19 – 0 x = Alarm condition; Intrusion Codes; Intrusion Codes via LED light; Events Playback; x = Doors intrusion; Chirps; Constant up to 30
- Page 20 – Diagnostics - Parking Lights Flash Rate
Notice
The manufacturer will accept no responsibility for any electrical damage resulting from
improper installation of the product, be that either damage to the vehicle itself or to the
Unit. This Unit must be installed by a certified technician using all safety devices
supplied. Please note that this guide has been written for properly trained Autostart
technicians, a certain level of skill and knowledge is therefore assumed. Please review
the Installation Guide carefully before beginning any work.
Warning
This unit is designed for vehicles with an
automatic
Transmission only.
Before installing the Unit, test that the vehicle will not start if the gear select lever is in the
“Drive” position. If the vehicle starts in gear, install a manual-transmission Car Starter
instead.
H.310 S.3.20 DOC: 1.00
CA –
September 15, 2003
Manufactured in Canada by Autostart
A U T O M A T I C
T R A N S M I S S I O N R E M O T E S T A R T E R
S Y S T E M
AS-6205 SH
Installation Guide
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
P.2 Installation Guide AS-6205 SH Table of Contents Introduction ..................................................... 3Included in the Package ................................. 3Before You Get Started …............................... 4 Installation Points To Remember ................... 4Harness De...
AS-6205 SH Installation Guide P.3 Introduction This Guide contains all information pertinent to the installation. Most (if not all) features are grouped in the User Guide and therefore, should you need information on a feature, you should refer to the User Guide Included in the Package Please review...
P.4 Installation Guide AS-6205 SH Before You Get Started … Ƈ On vehicles with a manual Transmission, always ensure that all Doors will get the Unit out of Ready Mode. Switch the wire used so that it is triggered by all Doors. Ƈ Make sure that the Parking Brake and Door Switch contacts work properly....
