Autostart AS-1535 SH - Manuals

AS-1535 SH Installation Guide P.5 6-Pin Main Ignition Harness Wire Description A RED +12 V Battery Connect to the largest 12 V supply wire at the Ignition harness. Ensure that the OEM power wire is fused for more than 30 A. NOTE: certain new vehicles have no suitable 12 volts source at the IGNITION ...

P.6 Installation Guide AS-1535 SH NOTE: A Tach signal that is too low will cause the Module to “over crank” and a Tach signal that is too high will cause the Module to “under crank”. 3 GREY (-) Hood Switch input Connect this wire to the Hood Pin-switch supplied. This input will disable or shut down ...

AS-1535 SH Installation Guide P.7 7 WHITE / ORANGE (–) Starter Kill output The unit is equipped with a selectable passive- or active-arming Starter Kill circuit that will immobilize the vehicle when the system is armed. This wire will provide a constant 500-mA negative output when the system is arme...

P.8 Installation Guide AS-1535 SH 9 (cont.) PURPLE (-) External Trigger Option 3 (Key Sense (-) Input): Connects to OEM Key Sense Wire. When the Key is detected in the Ignition Switch (Ground (-) signal on the OEM Key Sense Wire) the Starter Kill will not ARM even when it is set to Passive Mode. If ...

AS-1535 SH Installation Guide P.9 12 (cont.) YELLOW(+) Glow- plug Light input (cont.) A diode must be added between the negative Glow-plug trigger on the relay and the negative Glow-plug wire of the car. This is to prevent feedback effects on the Glow-plug indicator light on the instrument cluster: ...

The Installer … The Module … 1- Press and hold the Hood pin for 4 seconds. 2- Let go of the Hood Pin. Parking Lights “ON” 3- While the Parking Lights are on, press down theHood Pin once more. 4- Release the Hood Pin again --be careful not toover flash the Hood Pin as this will bring up theEvents Pla...

AS-1535 SH Installation Guide P.11 The Module has the ability to retain up to 4 different Transmitter codes; if a fifth Transmitter is programmed, the code of the first Transmitter will be erased from memory. To erase all Transmitter codes from memory, you must perform a Module reset (See “Resetting...

P.12 Installation Guide AS-1535 SH Options Programming MODE 1 *indicates default setting FUNCTION 1 – Ignition-controlled Door Locks OPTION 1* Ignition Locks ENABLED OPTION 2 Ignition Locks DISABLED OPTION 3 Ignition LOCK only OPTION 4 Ignition UNLOCK only FUNCTION 2 – Secure Lock OPTION 1* Secure L...

P.14 Installation Guide AS-1535 SH Close the Hood to cancel the changes. Table 4 Auto Tach Programming Procedure This process can be carried out instead of the conventional Tach Programming Procedure. 1. Make sure all the connections are done properly and that the Module has been powered-up. 2. With...

AS-1535 SH Installation Guide P.15 2. Test Hood Switch shutdown : with the vehicle running under the Remote Starter, open the Hood; the vehicle should shut down. If it does not shut down, check the Hood Pin-switch and its connector. 3. Test the Brake shutdown circuit : With the vehicle running under...

Caution! Do not use more than one of the threesets of jumper pins simultaneously.The relay output rating on this Unit is25A max output. Defective OEMsolenoid switches can sometimes draw up to 50 or 60A, causing the 30A fuseto blow. Using a digital voltmeter, checkthe Starter wire for amperage whenve...

AS-1535 SH Installation Guide P.17 Turbo Mode This Option allows turbochargers to idle down: after the user leaves the vehicle, the Engine will keep running for 60 sec. and then shut down (It is a 1-minute Idle Mode). Safe Start (Child Safety Mode) ( OFF by default.) Requires the user presses the ST...

P.18 Installation Guide AS-1535 SH x With the Parking Lights on, immediately push the Pin-switch 3 times. x The Parking Lights and L.E.D. will flash the five events stored in memory. Table 12 The first four playback codes are Start Failure Events . There is a pause after each event code is played ba...

AS-1535 SH Installation Guide P.19 Note: “x” stands for one flash of the Parking Lights Diagnostics - Parking Lights Flash Rate Flashes Description 1 x Doors locked, Starter Kill armed. x End of Run Time. x TRUNK button pressed x START signal received by the Module. x Cold Weather Mode cancelled. x ...