Autostart AS-1535 SH - Manual
Autostart AS-1535 SH – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Table of Contents; Started; Flashing; Auto Tach; IGN or 2; ACC or
- Page 3 – Introduction; The following is a list of components included in the kit:; Before You Get; always
- Page 4 – only when the Hood is up.; Always solder and tape all connections.; Harness Description
- Page 5 – -Pin Main Ignition Harness; -Pin Secondary Harness
- Page 6 – only; 2-Pin Accessories Harness; Wire
- Page 7 – ORANGE; PURPLE; Connects to Negative Trunk Pin.
- Page 8 – Connects to OEM Key Sense Wire.; Connects to the Negative Door; Leave this pin empty.
- Page 9 – plug Light; YELLOW; Flashing the Hood Pin; What is F; Flash the Hood Pin
- Page 10 – Table 1
- Page 11 – How to Enter Options Programming Mode; Table 2
- Page 12 – Options Programming
- Page 14 – Table 4; Table 5; Multi-Speed Tach Programming; FLASH; Start the vehicle and let it to reach regular Engine-idle speed.; Table 6; Testing; Remote-start the Engine and listen for Starter drag.
- Page 15 – Test Hood Switch shutdown; Closing Up; the last step before the initial powering of the Module; Supplementary Information; Fifth Relay Output (2; ACC or 2
- Page 16 – Ignition-Controlled Door Locks; Table 7; Secure Lock; Table 8
- Page 17 – Turbo Mode; Table 9; Vehicle Type – Gas Or Diesel; Resetting The Module; Events playback
- Page 18 – With the Parking Lights on, immediately push the Pin-switch 3 times.; Start Failure Events; . There is a pause after each event; Start Failure Codes via Parking Lights; detected, or Tach before Start
- Page 19 – “x” stands for one flash of the Parking Lights; Diagnostics - Parking Lights Flash Rate
Notice
The manufacturer will accept no responsibility for any electrical damage resulting from
improper installation of the product, be that either damage to the vehicle itself or to the
Unit. This Unit must be installed by a certified technician using all safety devices
supplied. Please note that this guide has been written for properly trained Autostart
technicians, a certain level of skill and knowledge is therefore assumed. Please review
the Installation Guide carefully before beginning any work.
Warning
This unit is designed for vehicles with an
automatic
Transmission only.
Before installing the Unit, test that the vehicle will not start if the gear select lever is in the
“Drive” position. If the vehicle starts in gear, install a manual-transmission Car Starter
instead.
H.2.40 S.3.00
Rev.
XWW
DS CA – June 23, 2003
Manufactured in Canada by Autostart
A U T O M A T I C
T R A N S M I S S I O N R E M O T E S T A R T E R
S Y S T E M
AS-1535 SH
Installation Guide
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
P.2 Installation Guide AS-1535 SH Table of Contents Introduction ..................................................... 3Included in the Package ................................. 3Before You Get Started …............................... 3 Harness Description ....................................... 4 6...
AS-1535 SH Installation Guide P.3 Introduction This Guidebook contains all information pertinent to the installation. Most (if not all) features are grouped in the User Guidebook and therefore, should you need information on a feature, you should refer to the User Guidebook Included in the Package B...
P.4 Installation Guide AS-1535 SH Ƈ Never leave the keys in the car. Leave them on a workbench with a window rolled down. Ƈ Remove courtesy light fuse, if possible, to prevent battery drain. Ƈ The Programming Assistance Button (A.k.a. PAB.) The PAB is mounted on the side of the Unit. This push butto...
