Apple 073-0723 - Manuals - manualsarea.com

Page 2 - Touch the metal PCI access covers on the back of the computer.; Figure 1; Unplug the power cord.

Power Mac G4 (Mirrored Drive Doors/FW 800) Power Supply - 2 6. Touch the metal PCI access covers on the back of the computer. (Figure 1) Important: To avoid electrostatic discharge, always ground yourself by touching the port access covers before you touch any parts or install any components inside ...

Page 3 - Removing the Installed Power Supply; Figure 2; Slide the back panel off the carrier.; Figure 3

Power Mac G4 (Mirrored Drive Doors/FW 800) Power Supply - 3 Removing the Installed Power Supply 1. Remove the two screws that secure the optical drive carrier to the chassis. (Figure 2) Figure 2 2. Slide the back panel off the carrier. (Figure 3) Figure 3

Page 4 - Figure 4; fan cable connector.; Figure 5

Power Mac G4 (Mirrored Drive Doors/FW 800) Power Supply - 4 3. Slide the carrier back and rotate it so that you can reach the drive cables. 4. Disconnect the drive data and power cables (P6 and P7) from the back of the optical drive(s) and remove the carrier from the computer. (Figure 4) Figure 4 5....

Page 5 - cable and disconnect the cable from the logic board.; Figure 6; fan from the computer.; Figure 7

Power Mac G4 (Mirrored Drive Doors/FW 800) Power Supply - 5 6. Using a small flat-blade screwdriver, gently lift up the locking tab on the lower fan cable and disconnect the cable from the logic board. (Figure 6) Figure 6 7. Slide the fan straight up to disconnect it from the optical drive shelf, an...

Page 6 - Use a T-10 Torx driver to remove the power supply screw.; Figure 8; Remove the Phillips screw from the side panel.; Figure 9

Power Mac G4 (Mirrored Drive Doors/FW 800) Power Supply - 6 8. Use a T-10 Torx driver to remove the power supply screw. (Figure 8) Figure 8 9. Remove the Phillips screw from the side panel. (Figure 9) Figure 9

Page 9 - Installing the Replacement Power Supply; Install the replacement power supply.

Power Mac G4 (Mirrored Drive Doors/FW 800) Power Supply - 9 Installing the Replacement Power Supply 1. Install the replacement power supply. Replacement Note: When rerouting the cable harness, make sure • connectors P4 and P5 are routed inside the front drive carrier • connectors P2 and P3 are route...

Page 12 - Before sliding the rear panel back onto the carrier, make sure

Power Mac G4 (Mirrored Drive Doors/FW 800) Power Supply - 12 Replacement Note: Before sliding the rear panel back onto the carrier, make sure the top lip of the panel engages with the top edge of the drive carrier. Warning: Be careful not to pinch the power cable between the panel and the carrier. (...

Page 13 - Closing the Computer; missing parts can damage your computer or cause injury.

Power Mac G4 (Mirrored Drive Doors/FW 800) Power Supply - 13 Closing the Computer 1. Raise the side access panel, lift the latch, and press the panel against the case until it snaps securely into place. 2. Reconnect all cables and restart your computer. Warning: Never turn on your computer unless al...