Apple 073-0723 - Manual
Apple 073-0723 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Touch the metal PCI access covers on the back of the computer.; Figure 1; Unplug the power cord.
- Page 3 – Removing the Installed Power Supply; Figure 2; Slide the back panel off the carrier.; Figure 3
- Page 4 – Figure 4; fan cable connector.; Figure 5
- Page 5 – cable and disconnect the cable from the logic board.; Figure 6; fan from the computer.; Figure 7
- Page 6 – Use a T-10 Torx driver to remove the power supply screw.; Figure 8; Remove the Phillips screw from the side panel.; Figure 9
- Page 9 – Installing the Replacement Power Supply; Install the replacement power supply.
- Page 12 – Before sliding the rear panel back onto the carrier, make sure
- Page 13 – Closing the Computer; missing parts can damage your computer or cause injury.
073-0723 Rev. B
Power Mac G4
Power Supply
Replacement Instructions
Follow the instructions in this sheet carefully. Failure to follow these instructions could
damage your equipment and void its warranty.
Note:
Written and video instructions covering customer-installable parts are available at
http://www.info.apple.com/installparts/.
Warning: During this procedure, keep small parts away from children.
Tools Required
The following tools are required for this procedure:
• #2 Phillips screwdriver
• small flat-blade screwdriver
• T-10 Torx driver
Opening the Computer
Warning: Always shut down your computer before opening it to avoid damaging its
internal components or causing injury. After you shut down the computer, the
internal components can be very hot. Let the computer cool down before
continuing.
1.
Place your computer on a clean, flat surface.
2.
If you think your computer is in sleep, press the power button on the front of the
computer to wake it.
3.
Shut down your computer and wait five minutes before continuing.
4.
If you attached a security cable through the computer’s lockable cover latch, remove
the cable.
5.
Unplug all other cables from the computer except the power cord.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Power Mac G4 (Mirrored Drive Doors/FW 800) Power Supply - 2 6. Touch the metal PCI access covers on the back of the computer. (Figure 1) Important: To avoid electrostatic discharge, always ground yourself by touching the port access covers before you touch any parts or install any components inside ...
Power Mac G4 (Mirrored Drive Doors/FW 800) Power Supply - 3 Removing the Installed Power Supply 1. Remove the two screws that secure the optical drive carrier to the chassis. (Figure 2) Figure 2 2. Slide the back panel off the carrier. (Figure 3) Figure 3
Power Mac G4 (Mirrored Drive Doors/FW 800) Power Supply - 4 3. Slide the carrier back and rotate it so that you can reach the drive cables. 4. Disconnect the drive data and power cables (P6 and P7) from the back of the optical drive(s) and remove the carrier from the computer. (Figure 4) Figure 4 5....
