Blomberg WM 67121 NBL00 - Manual

5 EN Front Loading Automatic Washer WM67121NBL00 33 (85) 23 (59.5) 21 (54) 156 / 71 208-240 / 60 10 2350 1200 15-145 psi (1-10) bar 4.9 ft (1.5m) 1.88 cu. Ft. 15.4 (7) Specifications Specifications of this appliance may change without notice to improve the quality of the product. Figures in this gui...

6 EN B WARNING - To reduce the risk of fire, electric shock or injury to persons while using your appliance follow basic safety precautions, including the following: • Read all instructions before using the washer. • Do not wash articles that have been previously cleaned in, washed in, soaked in, or...

9 EN Read this first ! This washer can be individually installed in free-standing and built-in installations. You can also install your washer with your dryer as a free-standing or built-in pair. Before you install your appliance, read the following instructions completely and carefully: • Save thes...

11 EN be damaged seriously! 1. Loosen all the bolts with a spanner until they rotate freely (“C”) 2. Remove the shipping bolts by turning them gently. 3. Bolt hole covers (supplied in the bag with the owner’s guide) are fitted into the holes on the rear panel with a special lock mechanism. To fit th...

14 EN • Washer must be properly leveled by using the adjustable feet. • Water inlet hoses are connected to the water faucets, secured and checked for any leaks by turning on both faucets. • Drain installation is done properly and drain hose is checked and secured to prevent any flooding. • Washer is...

15 EN First Use B WARNING – To reduce the risk of fire, electric shock, or injury to persons, read the IMPORTANT SAFETY INSTRUCTIONS before operating this appliance. Before the first use, • Be sure that the washer is installed properly by a qualified installer or service technician in accordance wit...

17 EN Light soiling No visible stains or soiling Normal soiling A few visible light stains or soiling Heavy soiling Highly visible stains or soiling Detergent Dispenser Detergent dispenser of your washer has three separate compartments for main wash detergent, fabric softener and liquid bleach. Each...

18 EN on the package. If you use a liquid detergent, be sure to use a HE (High efficiency) detergent and add detergent directly to main wash compartment before operating your washer. If you observe liquid detergent stains on washed items, it is recommended for subsequent wash cycles that you should ...

19 EN Control panel 5 Selecting a program and operating your washer 7 - Power button 8 - Program follow-up indicator 9 - Display 10 - Cycle selection knob 11 - Start/Pause/Cancel Button 12 - Auxiliary Function Buttons 13 - Time Delaying Button (+/-) 14 - Spin Speed Adjustment Button Turning the wash...

20 EN Program Cycle Selection Table W ash Cycle Load T ype Soiling Level W ater Intake (1) W ash water T emp. Max Spin Speed (rpm) (2) Load Capacity (max) (3) Bleach (4) Options A vailable Cycle T ime (normal) (5) Cottons/ Regularwash Sanitary White and colorfast items made of cotton and linen (baby...

21 EN Selectable options of a wash cycle are extra rinse “R”, superwash “S” and quickwash “Q”. 1. Even if there is no hot water system, hot water inlet must still be connected to another cold water faucet. Otherwise a fault will occur on water intake. 2. Programs are limited with the maximum spin sp...

22 EN items when you want to pre-treat them. Cycle soaks the laundry in a relatively high amount of warm water for two hours approximately. You can use full load and HE “High efficiency” main wash detergent for this cycle. Use half of the recommended detergent dose for the load amount to be soaked. ...

23 EN steps of three hours for the remainder (1, 2, 3, 6, 9, …24). 1. Open the loading door, place the laundry inside and fill detergent disperser. 2. Set the washing program, spin speed and, if required, select the auxiliary functions. 3. Press “Time Delay” button gradually to adjust the desired ti...

24 EN machine to “Pause” mode in order to change the spin speed. New spin speed can be selected. Spin speed selection can be changed until the end of final rinse cycle. Adding/removing laundry in standby mode The door can be opened if the water level and temperature in the drum is suitable. “Ready” ...

25 EN 6 Quick instructions for daily use Preparation 1. Turn on both hot and cold water faucets fully. Check and be sure the water connection is tight. 2. Place the laundry in the drum. 3. Add laundry additives (e.g. detergent, fabric softener,bleach). Starting 1. Press the “On/Off” button. 2. Selec...

26 EN A WARNING – Be sure to unplug the power cable before attempting maintenance or cleaning of your appliance to minimize the risk of electric shock. Cleaning detergent dispenser Remove any powder/liquid residue buildup in the dispenser drawer. To do this; 1. Press the dotted point on the siphon o...

28 EN below: • Pull out the emergency drain hose from its housing. • Place a large container at the end of the hose. Drain the water off into the container by pulling out the plug at the end of the hose. If the amount of water to be drained off is greater than the volume of the container, replace th...

29 EN Problem Cause Explanation / Suggestion Water in the washer. There may be some water in your appliance when you receive it. This is from the quality control process and is normal. It is not harmful to your washer. You should run a “sanitary” cycle without any clothes and laundry additives befor...

39 EN 10 HOW TO GET SERVICE Please contact the Distributor for your State or Province as listed on the Distributor Contact List, or call our Toll Free Number at 1 800 459 9848 for direction to an Authorized Blomberg Service Agent.