Blomberg FINE 1531P - Manual

EN 4 2 Warnings •DO NOT connect your appliance to the electricity supply until all packing and transit protectors have been removed. • Leave to stand for at least 4 hours before switching on to allow compressor oil to settle if transported horizontally. • If you are discarding an old refrigerator wi...

EN 5 ELECTRICAL REQUIREMENTS Before you insert the plug into the wall socket make sure that the voltage and the frequency shown on the rating plate inside the appliance corresponds to yourelectricity supply. Rating label is on the left hand side of fridge inner liner.We recommend that this appliance...

EN 6 ENERGY SAVING TIPS 1- Ensure your appliance is installed in a well ventilated area.2- Ensure the time between buying chilled/frozen food and placing them in your appliance is kept at minimum, particularly in summer. We recommend you use a cool bag or a special carrier bag to carry frozen food. ...

EN 7 3 Installation TRANSPORTATION INSTRUCTIONS 1. The appliance should be transported only in a vertical upright position. The packing as supplied must be intact during transportation. 2. If during the course of transport the appliance has to be transported horizontally, it must only be laid on its...

EN 9 REVERSING THE DOORS We recommend that you reverse doors before switching on for the first time. Tools required: Small and medium size flat and cross-headed screwdrivers, a pair of pliers. Spare Parts supplied in the plastic bag: The following parts, which are exclusively for left hand side fitt...

EN 10 11. Fit the other front feet (10). 12. Carefully stand your appliance. (You may need somebody to help you.) Adjust the front feet (See Installation Instructions) 13. Put back all, loose items and fittings.14. Wait for at least 4 hours to allow the system to settle before switching on. Spare pl...

EN 12 4 Before operating Final Check Before you start using the fridge/ freezer check that: 1. The feet have been adjusted for perfect levelling. 2. The interior is dry and air can circulate freely at the rear. 3. Clean the interior as recommended under “CLEANING AND CARE.” 4. Insert the plug into t...

EN 13 5 Using your refrigerator 4 2 3 1 TEMPERATURE CONTROL AND ADJUSTMENT INDICATOR LIGHTS There are three coloured indicator lights located on the front of the appliance which shows the operating mode of the freezer. Green Indicator (1) Illuminates when the appliance is connected to the mains and ...

EN 14 IMPORTANT: When you press the fast freeze switch, there may be a short delay before the compressor starts to operate. This is normal and does not indicate a compressor fault. Remember you must take your reading very quickly since the thermometer temperature will rise very rapidly after you rem...

EN 15 DEFROSTING Your appliance defrosts automatically. Warnings! The fan inside the freezer compartment circulates cold air. Never insert any object through the guard. Do not allow children to play with the freezer fan. Never store products that contain inflammable propellant gas (eg dispensers, sp...

EN 16 6 Maintenance and cleaning ** We recommend that you switch off the appliance at the socket outlet and pull out the mains plug before cleaning. ** Never use any sharp abrasive instrument, soap, household cleaner, detergent and wax polish for cleaning. ** Use luke warm water to clean the cabinet...

EN 18 Don’t- Exceed the maximum freezing loads (6 kg in any 24 hours) when freezing fresh food. Don’t- Give children ice-cream and water ices direct from the freezer. The low temperature may cause ‘freezer burns’ on lips. Don’t- Freeze fizzy drinks.Don’t- Try to keep frozen food which has thawed, it...

EN 19 8 How To Obtain Service Please keep your purchase receipt or other proof of purchase in a safe place; you will need to have it should the product require attention under guarantee. You should also complete the details below; it will help us assist you when requesting service. (The model number...

EN 20 9 Guarantee Details Your new BLOMBERG product is guaranteed against the cost of breakdown repairs for three years from the date of the original purchase. What is covered? • Repairs necessary as a result of faulty materials, defective components or manufacturing defect. • The cost of functional...