BlackBerry 1902G - Manual

Chapter 1: Setting up the Interface and Test Board 8 RIM OEM Radio Modem for GSM/GPRS Wireless Networks Setup overview To set up the Interface and Test Board, perform these tasks: 1. Insert the SIM card into the SIM card holder on the Interface and Test Board (off-board SIM configuration) or directl...

Connecting the SIM card Getting Started Guide 9 Connecting the SIM card The 6-pin flat SIM interface cable carries the data and power between the Interface and Test Board SIM slot and the radio modem. 1. Remove the radio modem from the Interface and Test Board: unfasten the nuts and lift the radio m...

Chapter 1: Setting up the Interface and Test Board 10 RIM OEM Radio Modem for GSM/GPRS Wireless Networks Connecting the radio modem The 22-pin flat interface cable supplies clean, regulated power to the radio and carries most of the data and all of the voice between the Interface and Test Board and ...

Inserting the SIM card into the SIM card holder Getting Started Guide 11 Inserting the SIM card into the SIM card holder 1. If you are using the on-board SIM configuration, turn the test board over to reveal the cut-out that provides access to the SIM card holder on the underside of the radio modem....

Chapter 1: Setting up the Interface and Test Board 12 RIM OEM Radio Modem for GSM/GPRS Wireless Networks 2. Slide the SIM card holder in the direction of the arrow to unlock it, and then lift the cover open. 3. Slide the SIM card into the cover with the conductive side facing the leads on the board....

Chapter 2 Connecting the radio modem to a computer To enable the radio modem to communicate with your computer, you must add the radio modem to your computer, and add a dial-up network connection for the modem. This section provides information on the following topics: • Required information • Conne...

Chapter 2: Connecting the radio modem to a computer 14 RIM OEM Radio Modem for GSM/GPRS Wireless Networks Required information Before you start, determine the access point name (APN) of your network. Connecting with Windows 2000 To connect the radio modem to your computer, you must perform the follo...

Connecting with Windows 2000 Getting Started Guide 17 12. In the Extra initialization commands field, type: at+cgdcont=1,"IP"," apn_name " where apn_name is the access point name (APN) for your network 13. Click OK . The Phone and Modem Options window appears. 14. Click OK . Add a co...

Chapter 2: Connecting the radio modem to a computer 20 RIM OEM Radio Modem for GSM/GPRS Wireless Networks Change registry settings Perform the following steps so that the modem disconnects and reconnects correctly. 1. In a command prompt, type: regedit The Registry Editor appears. 2. Click the follo...

Chapter 2: Connecting the radio modem to a computer 22 RIM OEM Radio Modem for GSM/GPRS Wireless Networks Connecting with Windows 95/98 You must perform the following tasks to connect the radio modem to your computer: • add the modem • add a dial-up connection Add a modem 1. From the Start menu, cli...

Chapter 2: Connecting the radio modem to a computer 26 RIM OEM Radio Modem for GSM/GPRS Wireless Networks Setting up HyperTerminal You can use HyperTerminal to send AT commands to the OEM radio modem. 1. On the Windows Start menu, click Programs > Accessories > Communications > HyperTermina...