Audiovox AX-500 - Manual
Audiovox AX-500 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – YOUR “ Code Hopping “ TRANSMITTERS; will not; ARMING THE SYSTEM - ACTIVE
- Page 3 – PROTECTION WHILE THE SYSTEM IS ARMED
- Page 5 – WHILE THE SYSTEM IS SOUNDING; turns on. The LED will remain on as long as the system is in valet mode.
- Page 6 – Programming Your Custom Override Code:; override sequence. Turn the ignition switch to the on position.
- Page 7 – Custom Code Programming Example:; (The siren or horn will beep and the lights will flash one time.)
- Page 9 – IGNITION CONTROLLED LOCK UNLOCK:
- Page 10 – SYSTEM FUNCTIONS AT A GLANCE; DASH LED INDICATORS
128-7000
1 OF 10
Model AX-500
Owner’s Manual
4 Button Remote Security System
with Dual Stage Shock Sensor
IMPORTANT !
In order to provide the highest possible level of security to your vehicle, this
system is equipped with selectable manual override circuitry. It is possible that you will need
to manually override your security system if the transmitter becomes lost, or inoperative due
to battery failure. Reading the sections on
"MANUALLY OVERRIDING YOUR SYSTEM"
is
necessary to fully understand the procedure required to enable your vehicle in such
situations. In addition, the chart on the last page of this manual has a section for the particular
features and options installed in your vehicle as well as the override method selected.
Valet Switch manual override is pre-selected from the factory,
however, the system
can be configured for "Custom Code" operation. Confirm the override mode selected on the
last page of this manual, and familiarize yourself with the selection on it's operation.
FEATURES :
2 Four Button Programmable RF Transmitters (capable of accepting 4 transmitters)
Five Channel Receiver
Code Hopping Technology
Selectable Manual Override Mode
Remote Panic in all modes
Protected Valet
User Programmable Manual Override Code
7 Function
LED
(Light Emitting Diode) - Arm / Disarm / Zone 1, 2, 3 / Valet / Arming
Intrusion Alert with Memory
Audible Arm / Disarm / Defective Zone / Tamper Confirmation
Instant Siren Activation
Starter Disable
Additional Engine Immobilizer Output (optional relay required)
True Last Door Arming (hardwire only)
Defective Zone By-Pass
Hardwire or Voltage Sense Selectable
Active or Passive Arming Selectable
Programmable Auto Lock On / Off
Programmable Auto Unlock On / Off
Programmable Door Lock Pulse Duration 1 Second / 3.5 Seconds/1 Sec L/ Dbl. U/L
Programmable Active or Passive Door Locks
User Programmable Permanent Chirp Delete
On Command RF Chirp Delete from Transmitter
6 Tone Multi Tone Siren
RF Inhibit with ignition on
Parking Light Flasher
Plug In Dual Stage Shock Sensor
O P T I O N S :
Remote Trunk Release ( must have electronic trunk release )
Remote Keyless Entry ( must have power door locks )
Multiple Vehicle Capable
Remote Starter
Remote Power Window Roll Up
Remote Garage Door Interface
Two Step Unlock Configurable
Headlight Illumination During Arming, Disarming, Or Both
Interior Illumination Upon Disarm
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
128-7000 2 OF 10 Page 2 YOUR “ Code Hopping “ TRANSMITTERS The transmitters included with your new security system use the most advancedand secure form of radio frequency transmission available on any currentautomotive security system. Some of today’s sophisticated auto thieves use adevice known as ...
128-7000 3 OF 10 Page 3 disarm the system to make the correction. Doors Lock - Optional Headlight Illumination - Optional ARMING THE SYSTEM - PASSIVE ( AUTOMATIC ) 1. Turn off the engine, exit the vehicle, and close and lock all doors, hood lid andtrunk lid. Dash mounted LED begins to flash rapidly,...
128-7000 5 OF 10 Page 5 transmitter button is activated, the drivers door only will unlock, pressingthe unlock button a second time will cause all doors to unlock. If yourtransmitter has a separate lock/unlock buttons, pressing the unlockbutton anytime after the first unlock command will cause all t...
