AT&T MG9150J - Manual
AT&T MG9150J – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Centralized Telephone Programming Quick Reference; TO ENTER PROGRAMMING MODE; System Features; TO ERASE A FEATURE OR AUTO; Refer to document number MG9150J.
- Page 3 – System Features Continued
- Page 4 – System Programming Quick Reference; System
- Page 5 – Lines
- Page 6 – Extensions
- Page 7 – Dialing Restrictions and Permissions; System Speed Dial Numbers
- Page 8 – Groups
- Page 9 – Programming Mixed Telephone Types; Overview; Find the location of the button in the picture of the target phone.
- Page 10 – Figure 1. Programming from a PARTNER-34D Phone
- Page 11 – Figure 2. Programming from a MLS-34D Phone
- Page 12 – System Identifier; SYSTEM; PARTNER II release 3 would return 3 beeps, a 1.5; Notes
MG9150J
Issue 1
October 1995
AT&T
PARTNER® Plus, PARTNER II
Communications System
Programming Quick Reference
Graphics © AT&T 1988
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Centralized Telephone Programming Quick Reference Place the Programming Overlay on the dial pad of the system display phone at extension 10 or 11 (Extension 11 programming: P+ > = R3.0, PII > R1.0) TO ENTER PROGRAMMING MODE PRESS [ Feature ] [ 0 ] [ 0 ] PRESS [ System Program ] [ System Progra...
System Features Continued GROUP CALLING—RING/PAGEP+ 1 Grp < R2.0, 4 Grp > R3.0 (p. 5-64)PII 4 Grp > R1.0 (p. 5-96) P+ > R4.0PII > R3.0 (p. 5-97) (p. 5-132) For ringing the group: PRESS a programmable button PRESS left [ Intercom ] [ 7 ] DIAL a Calling Group number (1-4) For paging the...
System Programming Quick Reference Place the Programming Overlay on the dial pad of the system display phone at extension 10 or 11P+ > R 3.0, PII > R1.0 TO START SYSTEM PROGRAMMING TO END SYSTEM PROGRAMMING TO CYCLE THROUGH SYSTEM TO CYCLE THROUGH AVAILABLE PRESS [ Feature ] [ 0 ] [ 0 ] PRESS ...
