Page 3 - WARNING
802734ENR1 1 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT NOTE: The WARNING and IMPORTANT instructions appearing in this manual are not meant to cover all possible conditions and situations that may occur. It must be understood that common sense, caution, and carefulness are f...
Page 4 - Table of; Safety Information
© Copyright 2014, Alliance Laundry Systems LLCAll rights reserved. No part of the contents of this book may be reproduced or transmitted in any form or by any means without the expressed written consent of the publisher. 802734ENR1 2 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMI...
Page 5 - Maintenance
3 802734ENR1 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Operation Instructions for NetMaster Washers .................................... 27 Step 1: Load Laundry....................................................................... 27Step 2: Close Loading Door.................
Page 6 - Explanation of Safety Messages; DANGER
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 802734ENR7 4 Safety Information Explanation of Safety Messages Throughout this manual and on machine decals, you will find precautionary statements (“DANGER,” “WARNING,” and “CAUTION”) followed by specific instructions. These precau...
Page 7 - NOTE: The WARNING and IMPORTANT
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Safety Information 5 802734ENR7 7. Do not allow children to play on or in the washer. Close supervision of children is necessary when the washer is used near children. This appliance is not intended for use by persons (including chi...
Page 8 - Installation; Dimensions and Specifications
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 802734ENR7 6 Installation Dimensions and Specifications FLW2201N FLW2201N S ta ndard Ca p a ci ty Me ter Ca se 43 in. ( 109. 2 c m ) High Ca p ac ity M et er Ca se 43 .8 75 in. ( 11 1 .4 4 cm) 28 in. (71.1 cm) 24 in. (61.0 cm) 26.87...
Page 9 - Before You Start; Tools; For most installations, the basic tools you will need
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Installation 7 802734ENR7 Before You Start Tools For most installations, the basic tools you will need are: Figure 1 NOTE: If the washer is delivered on a cold day (below freezing), or is stored in an unheated room or area during th...
Page 10 - Installing the Washer; Step 2: Position and Level the Washer; Figure 3
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Installation 802734ENR7 8 Installing the Washer Step 1: Position Washer Near Installation Area Move washer so that it is within 4 feet (1.2 meters) of the desired area of installation. NOTE: For best performance and to minimize vibr...
Page 11 - Step 3: Connect Fill Hoses; Water Supply
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Installation 9 802734ENR7 NOTE: DO NOT slide washer across floor if the leveling legs have been extended, as legs and base could become damaged. Remove rubber feet from accessories bag and place on all four leveling legs. Verify tha...
Page 12 - Connecting Hoses
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Installation 802734ENR7 10 Connecting Hoses Insert each filter screen into the end of each fill hose that will connect to the water supply faucet. The screen must be facing outward. Refer to Figure 4 . Insert each plain rubber washe...
Page 13 - Risers; IMPORTANT: Drain receptacle must be capable of
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Installation 11 802734ENR7 Risers Risers (or air cushions) may have to be installed if the pipes knock or pound when flow of water stops. The risers are more efficient when installed as close as possible to the water supply faucets ...
Page 14 - Standpipe Installation; IMPORTANT: Increasing the drain hose length,; Drain Flow Rate
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Installation 802734ENR7 12 Standpipe Installation Place the drain hose into the standpipe.Remove the beaded tie-down strap from accessories bag and place around standpipe and drain hose and tighten strap to hold hose to standpipe. R...
Page 15 - Remove brace. Five bolts secure brace to
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Installation 13 802734ENR7 Step 6: Remove the Shock Sleeves and Shipping Brace 1. Remove panel. Figure 10 2. Remove brace. Five bolts secure brace to machine. For easier removal, remove in order shown. Figure 11 3. Remove shock slee...
Page 16 - Step 7: Wipe Out Inside of Wash Drum; Electrical Requirements; NOTE: The wiring diagram is located in the
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Installation 802734ENR7 14 Step 7: Wipe Out Inside of Wash Drum Before using washer for the first time, use an all-purpose cleaner, or a detergent and water solution, and a damp cloth to remove shipping dust from inside wash drum. F...
Page 17 - Grounding Instructions; DO NOT; Step 9: Check Installation; Installer Checklist; Improper connection of the equipment-
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Installation 15 802734ENR7 Grounding Instructions The washer must be grounded. In the event of malfunction or breakdown, grounding will reduce the risk of electric shock by providing a path of least resistance for electric current. ...
Page 18 - Vending; Meter Case; Figure
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Installation 802734ENR7 16 Vending Meter Case The factory mounted coin meter case does not include the service door lock, coin slide, coin drawer, coin drawer lock or keys. These parts must be ordered (at extra cost) according to th...
Page 19 - NOTE: During coin slide installation, make sure
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Installation 17 802734ENR7 Installing Extension Onto Coin Slide: Option 1 1. Install slide extension onto top of coin slide using two remaining screws and lockwashers. Refer to Figure 19 . 2. Insert coins and partially extend coin s...
Page 20 - install lever with arm that has two stars facing
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Installation 802734ENR7 18 NOTE: If more switch down-force is required, install lever with arm that has two stars facing down to provide additional switch travel. 3. Install extension lever with rounded corner facing away from exten...
Page 21 - Models Prepped for Card Reader
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Installation 19 802734ENR7 7. Before installing coin slide and extension, make sure ground wire is tucked under control shield to provide clearance for coin slide. Refer to Figure 25 . Installing Extension Onto Coin Slide: Option 1 ...
Page 22 - Operation; Step 2: Close Loading Door
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 802734ENR7 20 Operation Operation Instructions for Coin Slide Operated Washers IMPORTANT: Prior to first wash, use an all- purpose cleaner, or a detergent and water solution, and a damp cloth to remove shipping dust from inside of w...
Page 23 - Step 3: Add Laundry Supplies; Dispenser drawer requires a special tool; CAUTION
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Operation 21 802734ENR7 Step 3: Add Laundry Supplies Open dispenser drawer. Measure and add low sudsing, high efficiency (HE) detergent (1), bleach (2) and fabric softener (3) to the dispenser drawer (refer to Figure 29 ). Close dis...
Page 24 - Indicator Lights; To reduce the risk of bodily injury, do not; Cycle Steps
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Operation 802734ENR7 22 Indicator Lights IN USE This light will remain on while washer is in use. DOOR LOCKED This light will come on after the PUSH-TO-START button has been pressed and the washer door has locked. It will remain on ...
Page 26 - Open dispenser drawer. Measure and add low sudsing,; oversudsing by using 1/2 of the detergent; Push touchpad for; COLD
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Operation 802734ENR7 24 Step 3: Add Laundry Supplies Open dispenser drawer. Measure and add low sudsing, high efficiency (HE) detergent (1), bleach (2) and fabric softener (3) to the dispenser drawer (refer to Figure 35 ). Close dis...
Page 27 - To Insert Money; Insert card into opening.; START; pad. DOOR MUST BE CLOSED TO START
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Operation 25 802734ENR7 Step 5: Insert Coin(s) or Card To Insert Money Insert coin(s) in coin slot. Check pricing as seen on digital display. Figure 37 To Insert Card Insert card into opening. Figure 38 Step 6: Start Washer After ve...
Page 28 - WASH
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Operation 802734ENR7 26 Indicator Lights WASH WASH is lit at the beginning of a wash cycle and will remain lit until the wash cycle is complete. RINSE RINSE is lit at the beginning of all RINSE cycles and will remain lit until the r...
Page 30 - Step 4: Set Fabric Selector; Step 5: Set Wash Temperature; Insert card into opening. Do not remove the card until
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Operation 802734ENR7 28 Step 4: Set Fabric Selector Push touchpad for NORMAL, PERM PRESS or DELICATES cycle. Light indicates selection. NOTE: Changes can be made to Fabric Selector setting up until the first fill is complete. Figure...
Page 32 - User-Maintenance Instructions; IMPORTANT: To avoid possible property damage
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 802734ENR7 30 Maintenance User-Maintenance Instructions Lubrication All moving parts are sealed in a permanent supply of lubricant or are equipped with oilless bearings. Additional lubrication will not be necessary.Do not lubricate ...
Page 33 - Reinstallation of Shipping Materials; Cleaning Foreign Object Trap; NOTE: The pump may have some water in it. Use a
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Maintenance 31 802734ENR7 Reinstallation of Shipping Materials To prevent damage while moving the washer, the shipping materials MUST be reinstalled. Disconnect washer from electrical supply. While supporting the front access pa...
Page 34 - Troubleshooting; Washer Symptom; Won’t Fill; Cycle; Water Leaks
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 802734ENR7 32 Troubleshooting Try these troubleshooting tips before making a service call. They may save time and money. Washer Symptom Possible Cause/Solution Won’t Fill Make sure power cord is plugged all the way into the electr...
Page 36 - Contact Information; Alliance Laundry Systems; or attempt any servicing unless specifically
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 802734ENR7 34 Contact Information If service is required, contact the nearest Factory Authorized Service Center.If you are unable to locate an authorized service center or are unsatisfied with the service performed on your unit, con...
Page 40 - Fast Track for Installing the Washer; (Refer to the manual for more detailed information)
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Installer Checklist Fast Track for Installing the Washer (Refer to the manual for more detailed information) CHECK • Position Washer Near Installation Area. • Connect Fill Hoses. CHECK CHECK CHECK CHECK • Remove the Shock Sleeves an...
