Page 3 - Table of; Troubleshooting LEDs on Inverter Controls Starting Machine
© Copyright 2010, Alliance Laundry Systems LLC All rights reserved. No part of the contents of this book may be reproduced or transmitted in any form or by any means without the expressed written consent of the publisher. 80 3 402 1 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT...
Page 4 - Section 1; DANGER; WARNING
2 80 3 402 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Section 1 Safety Information Throughout this manual and on machine decals, you will find precautionary statements (“CAUTION,” “WARNING” and “DANGER”) followed by specific instructions. These precautions are intended for t...
Page 5 - Locating an Authorized Servicer; reconnected to ensure that the washer is properly grounded.
80 3 402 3 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Safety Information NOTE: The WARNINGS and IMPORTANT INSTRUCTIONS appearing in this manual are not meant to cover all possible conditions and situations that may occur. Common sense, caution and care must be exercised when...
Page 6 - Section 2; Customer Service
4 80 3 402 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Section 2 Introduction Customer Service If literature or replacement parts are required, contact the source from whom the machine was purchased or contact Alliance Laundry Systems at (920) 748-3950 for the name and addres...
Page 7 - Model Identification; Information in this manual is applicable to these washers.
80 3 402 5 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Introduction Model Identification Information in this manual is applicable to these washers. BF 3 LLFSG401UN01 BF 3 LLFSG401UW01 BF 3 LLFSP401UN01 BF 3 LLFSP401UW01 BF 3 LXFSG401UN01 BF 3 LXFSG401UW01 BF 3 LXFSP401UN01 BF...
Page 8 - Theory of Operation; General; and requires less laundry detergent and less water.
6 80 3 402 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Introduction Theory of Operation General This frontload washer provides some of the same principles of operation as the typical topload washers. It senses water level, it dispenses the desired laundry detergent, agitates ...
Page 9 - Technical
80 3 402 7 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Introduction The agitate cycle tumbles the clothing in a clockwise direction for a period of 15 seconds, pauses for nine seconds and then tumbles the clothing in a counterclockwise direction for 15 seconds. This agitation...
Page 10 - Section 3; ohms
8 80 3 402 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Section 3 General Troubleshooting 1. Motor Circuit Resistance Values: Tachometer Circuit:Terminals 4–5Approx. 115 ohms Windings: Terminals 1–2, 2–3, 1-3Approx. 4.5 ohms To reduce the risk of electric shock, fire, explosio...
Page 11 - Troubleshooting Knocking Noise; To correct this condition, replace the belt.; Troubleshooting Coin Drop
80 3 402 9 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT General Troubleshooting To reduce the risk of electric shock, fire, explosion, serious injury or death:• Disconnect electric power to the washer before servicing.• Never start the washer with any guards/panels removed.• W...
Page 13 - Remove Coin Drop From Machine; Figure 2; Replace Tension Spring; Figure 4
80 3 402 11 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT General Troubleshooting To reduce the risk of electric shock, fire, explosion, serious injury or death:• Disconnect electric power to the washer before servicing.• Never start the washer with any guards/panels removed.• ...
Page 14 - (3) Place a small flathead screwdriver under
12 80 3 402 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT General Troubleshooting To reduce the risk of electric shock, fire, explosion, serious injury or death:• Disconnect electric power to the washer before servicing.• Never start the washer with any guards/panels removed.• ...
Page 15 - Reinstall Coin Drop Into Machine
80 3 402 1 3 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT General Troubleshooting To reduce the risk of electric shock, fire, explosion, serious injury or death:• Disconnect electric power to the washer before servicing.• Never start the washer with any guards/panels removed.•...
Page 16 - normally closed
14 80 3 402 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT General Troubleshooting To reduce the risk of electric shock, fire, explosion, serious injury or death:• Disconnect electric power to the washer before servicing.• Never start the washer with any guards/panels removed.• ...
Page 17 - Troubleshooting LEDs on; DO NOT
80 3 402 15 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT General Troubleshooting To reduce the risk of electric shock, fire, explosion, serious injury or death:• Disconnect electric power to the washer before servicing.• Never start the washer with any guards/panels removed.• ...
Page 19 - Section 4; Error Code Listing; Display
80 3 402 17 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Section 4 Electronic Control Troubleshooting 7. Error Code Listing Following is a list of possible error codes for an electronic control. Errors beginning with “EI” refer to external device Infra-red communication errors...
Page 22 - PDA Does Not Communicate With Control
20 80 3 402 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Electronic Control Troubleshooting 8. PDA Does Not Communicate With Control Attempt to communicate with the electronic control u s in g the PDA. I s there acknowled g ement from the control ? Check PDA manual for correct...
Page 23 - Coins Ignored When Entered
80 3 402 21 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Electronic Control Troubleshooting 9. Coins Ignored When Entered S tart Production Te s t Cycle and advance to Coin Drop s tep. Re s et control to ready mode. Ye s No I s "H5" connector properly s eated on the co...
Page 24 - No Visible Display on Control; Control Ha
22 80 3 402 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Electronic Control Troubleshooting 10. No Visible Display on Control Control Ha s No Vi s ible Di s play The electronic control ha s no LED or VFD functionin g on the control board. I s the power cord plu gg ed in ? Plu ...
Page 25 - No Visible Display on Control
80 3 402 2 3 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Electronic Control Troubleshooting No Visible Display on Control FLW1779 S 2 3 1 Refer to washer nameplate on rear panel for proper voltage and Hertz
Page 26 - Washer Will Not Start – “door” Displayed
24 80 3 402 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Electronic Control Troubleshooting 11. Washer Will Not Start – “door” Displayed Wa s her will not s tart. Vend s ati s fied. I s there 220-240 VAC (or 120 VAC) * acro ss "H 3 -5" and "H7-5" on the control...
Page 27 - Washer Will Not Start – “door” Displayed
80 3 402 25 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Electronic Control Troubleshooting Washer Will Not Start – “door” Displayed FLW1779 S 2 1 Refer to washer nameplate on rear panel for proper voltage and Hertz
Page 28 - Washer Will Not Start – “E dL” on Display
26 80 3 402 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Electronic Control Troubleshooting 12. Washer Will Not Start – “E dL” on Display I s there 220-240 VAC (or 120 VAC) * acro ss terminal s "H 3 -4" and "H7-5" on the electronic control ? (1) No Ye s Wa s he...
Page 29 - Washer Will Not Start – “E dL” on Display
80 3 402 27 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Electronic Control Troubleshooting Washer Will Not Start – “E dL” on Display FLW1779 S 1 Refer to washer nameplate on rear panel for proper voltage and Hertz
Page 32 - Wa
3 0 80 3 402 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Electronic Control Troubleshooting 14. Washer Overflows Wa s her Overflow s I s there 220-240 VAC (or 120 VAC) * to the over level terminal on pre ss ure s witch to neutral ? Ye s No Replace inoperative pre ss ure s wit...
Page 33 - Washer Overflows
80 3 402 3 1 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Electronic Control Troubleshooting Washer Overflows FLW1779 S 2 2 1 Refer to washer nameplate on rear panel for proper voltage and Hertz
Page 34 - Pump or Drain Valve Does Not Operate
3 2 80 3 402 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Electronic Control Troubleshooting 15. Pump or Drain Valve Does Not Operate I s there 220-240 VAC (or 120 VAC) * acro ss the wht/blk and the white wire g oin g to the pump or drain valve ? I s there 220-240 VAC (or 120 ...
Page 35 - Pump or Drain Valve Does Not Operate
80 3 402 33 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Electronic Control Troubleshooting Pump or Drain Valve Does Not Operate FLW1779 S 2 1 Refer to washer nameplate on rear panel for proper voltage and Hertz
Page 37 - Serial Communication Error (“E SP” on Display)
80 3 402 3 5 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Electronic Control Troubleshooting Serial Communication Error (“E SP” on Display) FLW1779 S 3 2 1 4 Refer to washer nameplate on rear panel for proper voltage and Hertz
Page 38 - Motor doe
3 6 80 3 402 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Electronic Control Troubleshooting 17. Motor Does Not Run (“E dF” on Display) Motor doe s not run (E:df on di s play) (1) No I s there continuity between motor terminal s? Refer to value s at ri g ht. Ye s Check motor p...
Page 44 - Section 5; Cabinet Leveling Legs; Make sure; CAUTION
42 80 3 402 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT To reduce the risk of electric shock, fire, explosion, serious injury or death:• Disconnect electric power to the washer before servicing.• Never start the washer with any guards/panels removed.• Whenever ground wires ar...
Page 45 - Figure
80 3 402 4 3 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Adjustments To reduce the risk of electric shock, fire, explosion, serious injury or death:• Disconnect electric power to the washer before servicing.• Never start the washer with any guards/panels removed.• Whenever gr...
Page 46 - Motor Belt Tension
44 80 3 402 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Adjustments To reduce the risk of electric shock, fire, explosion, serious injury or death:• Disconnect electric power to the washer before servicing.• Never start the washer with any guards/panels removed.• Whenever gro...
Page 48 - HOWN CLO
46 80 3 402 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Adjustments To reduce the risk of electric shock, fire, explosion, serious injury or death:• Disconnect electric power to the washer before servicing.• Never start the washer with any guards/panels removed.• Whenever gro...
Page 50 - Drop
48 80 3 402 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Adjustments To reduce the risk of electric shock, fire, explosion, serious injury or death:• Disconnect electric power to the washer before servicing.• Never start the washer with any guards/panels removed.• Whenever gro...
Page 51 - i. Check coin return pendulum to verify it
80 3 402 49 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Adjustments To reduce the risk of electric shock, fire, explosion, serious injury or death:• Disconnect electric power to the washer before servicing.• Never start the washer with any guards/panels removed.• Whenever gro...
Page 52 - Cleaning Electronic Coin Drop; a. Disconnect electrical power to machine and; Coin Drops with Old-Style Spring (refer to; (1) Move spring downward until cover catch is
50 80 3 402 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Adjustments To reduce the risk of electric shock, fire, explosion, serious injury or death:• Disconnect electric power to the washer before servicing.• Never start the washer with any guards/panels removed.• Whenever gro...
Page 53 - d. Clean the coin path with a soft brush and wipe
80 3 402 51 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Adjustments To reduce the risk of electric shock, fire, explosion, serious injury or death:• Disconnect electric power to the washer before servicing.• Never start the washer with any guards/panels removed.• Whenever gro...
Page 54 - f. Clean light sensors with a soft brush or air; Coin Drops with OLD-Style Spring; spring back over cover catch.
52 80 3 402 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Adjustments To reduce the risk of electric shock, fire, explosion, serious injury or death:• Disconnect electric power to the washer before servicing.• Never start the washer with any guards/panels removed.• Whenever gro...