Airlink101 APO1200 - Manual

4 3. Configuring the Access Point Note : 1. It is recommended that you configure the Access Point from a wired computer. Before the Access Point can be configured, if you connect the AP to your computer directly, you must manually assign a static IP address to your computer's network adapter in the ...

5 Note : 1. To protect your network from any unauthorized access it is recommended to enable wireless encryption. 2. The examples below are for WPA2-PSK. If you select WPA-PSK or WPA2-PSK, make sure your wireless adapters support WPA or WPA2. If your wireless adapters do not support WPA or WPA2, the...

6 4. Configuring for WDS Link Note : 1. The system provide WDS function on Router AP Mode , AP Mode and WDS Mode . 2. WDS Link requires at least 2 APO1200. The Two wire networks(LAN) need the same subnet . 3. The WDS Link needs to be set at same Channel and with same Security Type . 4. Please instal...

7 4. Click Enable and enter the Remote APO1200's MAC Address. Setting Up the Remote APO1200 (Remote Base Station) 1. Copy down the 12 digit MAC Address of the Main APO1200 ( Main Base Station ). The MAC Address is on the device label or the Overview Page ( Status->Overview ) and Wireless General ...

8 5. Configuring for Client Bride Note : 1. This section will walk you through the steps of sharing (bridging) an internet connection in one building, and extending that same internet to another building. 2. The “ Main Base Station ” provide Access Point with SSID “ Main_AP ” 3. The Two wire network...

9 Setting Up the Client Bridge (Client Station) 3. Click Site Survey button. The system will automatically scan and display the scan results of all AP existing near by the system 4. Use Main_AP as an example here where the AP is encrypted via WPA2-PSK/ AES security type. Click Select button of the M...

11 6. Configuring for Universal Wireless Repeater Note : 1. This section will walk you through the steps of sharing (bridging) an internet connection in one building, and extending that same internet to another building with repeat Access Point. 2. A repeater is just a very normal client which, at t...

13 7. How to configure TCP/IP settings on your PC Windows XP/2000 1. Go into the Control Panel , double-click the Network Connections icon and then right-click the Local Area Connection icon and then click Properties. 2. Click Internet Protocol (TCP/IP) and then click Properties. Then click on Use t...

14 Technical Support E-mail: [email protected] Toll Free: 1-888-746-3238 Web Site: www.airlink101.com *Theoretical maximum wireless signal rate derived from IEEE standard 802.11 specifications. Actual data throughput will vary. Network conditions and environmental factors, including volume of n...