Airlink101 AMPS230 - Manuals

Page 2 - Step 4; Installing the PS Software; The PS Software must be installed on; all computers; you plan to use; Install PS Software; Section 2

Step 4 Turn on the printer. Once the printer is powered on, connect the print server’s power adapter to an electrical outlet. Installing the PS Software Note: The PS Software must be installed on all computers you plan to use with the print server. Step 1 Insert the Utility CD into your CD-ROM drive...

Page 4 - Next; Choose Destination Location; Next; at the; Select Program Folder

Step 4 Click Next at the Choose Destination Location screen. Step 5 Click Next at the Select Program Folder .

Page 5 - Configuring the Printer Server; one time; Section 3

Step 6 Once the installation is complete, make sure that the Launch PS-Link box is checked and click Finish . Configuring the Printer Server Note: The following steps only need to be performed one time from one computer. Step 1 Click the Discover button and your printer should show up under Server N...

Page 6 - Step 2; Once the printer server appears in the; Server Name; You should see your printer next to; Device name; A password box will appear. The default password is; admin; and click; OK

Step 2 Once the printer server appears in the Server Name box, click on it. You should see your printer next to Device name . Click on the Setup Wizard button to configure the printer server. Step 3 A password box will appear. The default password is admin . Enter it and click OK .

Page 7 - Step 5

Step 4 Click Next at the welcome screen. Step 5 At the System screen you can change the Server Name , Port Name , and Password . Click Next after making the desired changes. If you do not have a specific Server Name, Port Name, or Password that you would like to use, click Next to accept the default...

Page 8 - and enter your custom settings. Otherwise,; DHCP Assign Automatically; If your network uses a workgroup name other than WORKGROUP, you

Step 6 If you have a specific IP address you would like to assign to the print server, select Manually Assign and enter your custom settings. Otherwise, select DHCP Assign Automatically and click Next . Step 7 If your network uses a workgroup name other than WORKGROUP, you can enter it here, or acce...

Page 9 - Step 8; If you have specific; AppleTalk; settings, you can enter them here or; Save; to save the changes to your print server.

Step 8 If you have specific AppleTalk settings, you can enter them here or accept the default settings, and click Next . Step 9 Click Save to save the changes to your print server.

Page 10 - Adding the Printer to the Computer; Section 4

Adding the Printer to the Computer Note: The following steps must be completed on all computers you plan to use with the print server. Step 1 Double click on the PS-Link icon in the system tray to open the PS-Link software. Step 2 Click the Discover button and your printer should show up under Serve...

Page 12 - Step 6; In; Printers and Faxes; Right click on the copy and click; Set as Default Printer; on each of the computers you plan to use with the print

Step 6 In Printers and Faxes (or Printers ) you will see a copy of your printer. Right click on the copy and click Set as Default Printer . Congratulations, the configuration is now complete. Remember to repeat all steps in Section 4 on each of the computers you plan to use with the print server. Af...

Page 13 - Technical Support; Section 5

Technical Support E-mail: [email protected] Toll Free: 1-888-746-3238 Website: www.airlink101.com *Printer server may not support all printers. Go to the AirLink101 website to view the printer compatibility list *Actual data throughput will vary. Network conditions and environmental factors low...