Airlink101 AMPS240W - Manual

Page 2 - Installing the PS Software; all computers; Section 2

Step 1 Power down the printer and the printer server. Step 2 Connect one end of a networking cable to your router, then connect the other end to the Ethernet port on the back of the print server. Step 3 Connect the USB cable coming from your printer into the USB port on the printer server. Step 4 Tu...

Page 3 - OK

Note: If the autorun window does not appear automatically, go to Start -> Run and type D:\Utility\Setup.exe (where D is the letter of your CD-ROM drive) and click OK . Step 2 Select your setup language and click OK.

Page 4 - Step 3; Next; Choose Destination Location

Step 3 Click Next at the welcome screen. Step 4 Click Next at the Choose Destination Location screen.

Page 5 - Step 5; Select Program Folder; Finish

Step 5 Click Next at the Select Program Folder . Step 6 Once the installation is complete, make sure that the Launch PS-Link box is checked and click Finish .

Page 6 - Configuring the Printer Server; Step 1; Section 3

Configuring the Printer Server Note: The following steps only need to be performed one time from one computer. Step 1 Click the Discover button and your printer should show up under Server Name . If your print server does not show up, check all power and network cable connections to the printer. You...

Page 7 - admin

Step 3 A password box will appear. The default password is admin . Enter it and click OK . Step 4 Click Next at the welcome screen.

Page 10 - DHCP Assign Automatically

Step 8 If you have a specific IP address you would like to assign to the print server, select Manually Assign and enter your custom settings. Otherwise, select DHCP Assign Automatically and click Next . Step 9 If your network uses a workgroup name other than WORKGROUP, you can enter it here, or acce...

Page 11 - AppleTalk; Save

Step 10 If you have specific AppleTalk settings, you can enter them here or accept the default settings, and click Next . Step 11 Click Save to save the changes to your print server. If you plan to use the print server wirelessly, you can now disconnect the Ethernet cable between the print server an...

Page 12 - Configuring the Computer; Section 4

Configuring the Computer Note: The following steps must be completed on all computers you plan to use with the print server. Step 1 Double click on the PS-Link icon in the system tray to open the PS-Link software. Step 2 Click the Discover button and your printer should show up under Server Name . I...

Page 13 - Step 6

Step 4 Click OK at the Link Successfully screen. You will see notices appearing in the bottom right-hand corner of your screen while Windows configures the printer. Step 5 Once you see a notice that says Your new hardware is installed and ready to use , go to Start -> Control Panel and double cli...

Page 15 - Wireless Troubleshooting; Discover; Section 5

Wireless Troubleshooting If you are experiencing problems with the wireless connection (print server does not appear when you click discover, print jobs do not consistently work/finish, only able to communicate with the print server intermittently) you will want to tune your router’s signal by chang...

Page 16 - Technical Support; Section 6

Technical Support E-mail: [email protected] Toll Free: 1-888-746-3238 Website: www.airlink101.com *Printer server may not support all printers. Go to the AirLink101 website to view the printer compatibility list. *Theoretical maximum wireless signal rate based on IEEE standard 802.11g specifica...

Airlink101 AMPS240W - Manual

Table of Contents:

Summary

Other Airlink101 Models