Airlink101 AGIGAUSB - Manual

Page 2 - Table of Contents

2 Table of Contents Introduction ..................................................................................................................... 4 Package Contents ....................................................................................................... 4 Specifications ............

Page 4 - Introduction; USB 2.0 Gigabit Network Adapter; Package Contents

4 Introduction The USB 2.0 Gigabit Network Adapter (hereafter referred to as the Gigabit Adapter) is specifically designed to plug into any available Universal Serial Bus port of a desktop or laptop PC. The Gigabit Adapter is for users who wish to connect to a 10Mbps, 100Mbps or 1000Mbps Fast Ethern...

Page 5 - FCC Part15 ClassB

5 100Mbps: Appears as solid orange when the device is connected to 100Mbps network; blinking orange when transmitting data. Gigabit: Appears as solid green, when the device is connected to Gigabit network; blinking green when transmitting data. Power Requirement Operating Voltage: 5V DC Operation Mo...

Page 6 - Installation

6 Installation The following steps and screen shots are for Windows XP. Steps for Windows 2000 are similar unless noted otherwise. Note: Do not connect the USB 2.0 Gigabit Network Adapter to your computer until you’ve reached the appointed step. If the Gigabit Adapter is connected already, Windows w...

Page 7 - Click; at the welcome screen.; Next; in or click; Browse; to select the desired location.

7 Step 3 Click Next at the welcome screen. Step 4 Click Next to accept the default destination location for the driver to be installed in or click Browse to select the desired location.

Page 8 - to accept the Program Folder for the driver.; Continue Anyway; at the Windows Logo Testing prompt.; Yes; at the Digital Signature Not Found prompt).

8 Step 5 Click Next to accept the Program Folder for the driver. Step 6 Click Continue Anyway at the Windows Logo Testing prompt. (For Windows 2000, click Yes at the Digital Signature Not Found prompt).

Page 9 - Finish; to complete the installation wizard.; Found New Hardware Wizard; and

9 Step 7 Click Finish to complete the installation wizard. Step 8 Connect one end of the Gigabit Network Adapter to your computer’s USB port and connect the other end to a hub/switch/router. Step 9 At the Found New Hardware Wizard window, select No, not this time and click Next .

Page 11 - to complete the installation.

11 Step 12 Click Finish to complete the installation. Step 13 Restart your computer to activate the Gigabit Network Adapter.

Page 12 - Verify Driver Installation; My Computer; from your desktop and select; Properties; Select the; Hardware; tab and click on; Device Manager

12 Verify Driver Installation To verify if the driver has been installed successfully, please perform the following steps. Step 1 Right-click on My Computer from your desktop and select Properties . Step 2 Select the Hardware tab and click on Device Manager .

Page 13 - Expand; Network adapters; from the list and verify that; Network Adapter; is listed and no yellow question mark is beside it.

13 Step 3 Expand Network adapters from the list and verify that 10/100 Gigabit USB2.0 Network Adapter is listed and no yellow question mark is beside it. Congratulations! You have successfully installed the USB 2.0 Gigabit Network Adapter.

Page 14 - Technical Support

14 Technical Support E-mail: [email protected] Toll Free: 1-888-746-3238 Web Site: www.airlink101.com *Actual throughput will vary. Network conditions and environmental factors lower actual throughput rate. Copyright © 2005 AirLink101. All rights reserved. AirLink101, the stylized AirLink101 lo...

Airlink101 AGIGAUSB - Manual

Table of Contents:

Summary

Other Airlink101 Models