Airlink101 AP411W - Manual

6 Connecting the Access Point Step 1 Connect one end of a network cable to the Ethernet port of the access point and connect the other end of the cable to the LAN port of a router. Step 2 Power on the access point by connecting one end of the supplied power adapter to the power jack of the access po...

7 Establishing Wireless Connection Below are the default wireless settings of the access point. You must configure your wireless network adapter to the same settings in order to establish a wireless connection with the access point. SSID: default Operating Mode: Infrastructure Authentication: Open S...

11 Step 10 Select to enable or disable WEP encryption and click Next . If you already have WEP encryption enabled for your existing wireless network, you must enter the identical encryption settings here. Step 11 Click Reboot to save and apply the settings. Note: Once you have configured the setting...

12 Web Configuration Utility The Web configuration utility allows you to configure settings for the Access Point. In order to access the web configuration utility, you’ll need to assign a static IP address to your computer. Please refer to the previous section on how to assign a static IP address to...

13 Advanced Setup Use the list on the left side of the screen to navigate to the desired page. Configuration – IP Address MAC Address : Displays the Access Point’s MAC Address. This value cannot be changed. Get IP From-: Select Manual (Static IP) or DHCP (Dynamic IP) as the method you will use to as...

15 Configuration – AP Mode Settings Access Point: This is the default setting. It connects the wireless clients to the wired part of your network. PtP Bridge: This mode allows you to connect one Access Point to another Access Point of the same model, bridging two wireless LANs together. The two acce...

18 Configuration – WLAN Partition Wireless Band: Select to set the signal to 802.11g or 802.11g/802.11b. Internal Station Connection : Check Enabled to allow internal wireless clients to connect to the Access Point. Ethernet to WLAN Access : Check Enabled to allow the wired part of your network to c...

26 Statistics This window displays the statistics of the wireless local area network. Throughput : displays the throughput statistics. Transmitted Frames Count : displays the transmitted frames count.

28 Troubleshooting This section provides solutions to problems that can occur during the installation and operation of the 108Mbps SuperG Wireless Access Point. We cover various aspects of the network setup, including the network adapters. Please read the following if you are having problems. 1. The...

30 To hard-reset the 108Mbps Super G Wireless Access Point to the Factory Default Settings, please do the following: A. Locate the Reset button at the back of the 108Mbps SuperG Wireless Access Point. B. Use a paper clip to press the Reset button. C. Hold for about 10 seconds and then release. D. Af...

31 Technical Specifications Standards „ IEEE 802.11g „ IEEE 802.11 „ IEEE 802.11b „ IEEE 802.3 „ IEEE 802.3u Device Management „ Web-Based Internet Explorer v6 or later; Netscape Navigator v6 or later; or other Java-enabled browsers „ DHCP Client _ Wireless Operating Range „ Indoors – up to 328 feet...

32 Receiver Sensitivity: „ 54Mbps OFDM, 10% PER, -68dBm „ 48Mbps OFDM, 10% PER, -68dBm „ 36Mbps OFDM, 10% PER, -75dBm „ 24Mbps OFDM, 10% PER, -79dBm „ 18Mbps OFDM, 10% PER, -82dBm „ 12Mbps OFDM, 10% PER, -84dBm „ 11Mbps CCK, 8% PER, -82dBm „ 9Mbps OFDM, 10% PER, -87dBm „ 6Mbps OFDM, 10% PER, -88dBm ...