Airlink101 AKVM-2A - Manual

Ver. 1A

Quick Installation Guide

1

Model # AKVM-2A

Section 1

The

AKVM-2A switch

is a 2-port PS/2 type KVM switch

with audio support that comes with two sets of built-in
1.5M cables. It enables users to access, control, boot,
and reboot two computers using only one keyboard, video
monitor, mouse, microphone, and speakers. Its one-
piece design offers more portability and convenience to
users than conventional KVM switches.

Introduction

Section 2

Before connecting any cable, please make sure all of your
computers and their peripherals have been powered off.
Otherwise, the KVM switch may not be set up properly.

Installation

Step 1

Make sure all the computers that are to be

connected to the KVM switch and their peripherals
are powered-off. If not, power them off before you
proceed with the following steps.

Step 2

Connect the shared keyboard, monitor,

mouse, microphone, and speakers to the main KVM
unit. See Fig. 1.1

Fig 1.1

Step 3

Connect each set of the built-in KVM cables

to a computer’s keyboard, video, mouse, micro-
phone, and speaker ports. You can use individual
standard keyboard, mouse, video, and audio cables
to extend the cable distance, but depending on the
type of cables you use, the maximum cable dis-
tance is limited to 5 ~ 7 meters (15.5 ~ 23 feet).

Step 4

Power up the connected computers one by

one. After the computers are powered up, the
keyboard and mouse will be recognized and you can
begin operating the KVM switch.

Section 3

Operations

There are two methods to select a specific computer:

Using the

front-panel button

or

the

hotkey

sequence.

Hotkey Sequence

The hotkey sequence consists of three specific
keystrokes pressd on the keyboard.

Hotkey sequence =

ScrLk + ScrLk + Command key

The two consecutive

ScrLk

key should be pressed

within 2 seconds and the following command key(s)
should also be pressed within 2 seconds. Otherwise,
the hotkey sequence will not be validated.

For detailed Hotkey sequences and their correspond-
ing functions, please refer to the Quick Reference
Chart on back.

Front-panel button

The front-panel button lets you directly switch be-
tween the computers. Simply press the button on the
KVM unit to select the computer. By default, PC port
switching and audio port switching are bound together.

If you want to disable the binding of PC and audio port
switching, use the hotkey sequence,

ScrLk + ScrLk

+ W

. To enable the binding again, just click

ScrLk +

ScrLk + Q

.

Section 4

Technical Support

Email: [email protected]

Toll free: 1-888-746-3238

Website: www.airlink101.com

Continue on Back

Copyright © 2005 AirLink101. All rights reserved. AirLink101, the stylized AirLink101 logo,
specific product designations, and all other words and logos that are identified as trademarks
and/or service marks are, unless noted otherwise, the trademarks and service marks of
AirLink101. All other product or service names are the property of their respective holders.
AirLink101 products are protected under numerous U.S. and foreign patents and pending
applications, mask work rights, and copyrights.