Airlink101 AEN-U35SAB - Manual
Airlink101 AEN-U35SAB – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Attach the SATA connectors to your hard drive.
- Page 3 – Step 6
- Page 4 – Congratulations! The hard drive installation is complete.; Go to; Control Panel > Administrative Tools; or if you are at category; Control Panel > Performance and Maintenance >; Click on; Disk Management; on the left menu bar. The new disk; Section 2
- Page 5 – Right click; on the Unallocated disk and select; New Partition; from the
- Page 6 – Step 4; Click; to start the New Partition W izard.; Step 5; Select the desired Partition Type and click; Next
- Page 7 – Enter the desired Partition Size and click; Select; Assign the following drive letter; and select a letter for the new
- Page 8 – Step 8; other options preferred. Click; to start formatting the hard drive.; Finish; after the New Partition Wizard completed.
- Page 9 – My Computer; the new drive should be listed there.; Technical Support; Section 3
Quick Installation Guide
3.5” USB2.0 SATA Enclosure
Model # AEN-U35SAB
Hard Drive Installation
Step 1
Use the provided screwdriver to remove the two screws on the right side
of the enclosure. Pull out the right panel.
Section 1
Ver. 1A
Package Contents:
•
3.5” SATA Enclosure with
Stand
•
Power adapter
•
USB 2.0 Cable
•
Quick Installation Guide
•
Screwdriver and screw set
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Step 2 Attach the SATA connectors to your hard drive. Step 3 With the hard drive label facing up, attach the guides to both sides of the hard drive. The picture below shows how the guide being attached to the hard drive correctly. If the guides are not properly installed, the hard drive cannot be in...
Step 4 Line up the guides with the case, and slide the hard drive back in. The enclosure should slide shut. Step 5 Secure the two screws that were removed in step 1 . Step 6 Connect one end of the power cord to the back of the enclosure and connect the other end to a power outlet. Step 7 Connect one...
The hard drive is now ready to use and you can find it under “My Computer”. Congratulations! The hard drive installation is complete. Note: If you do not see your hard drive under My Computer, please continue on Section 2. Disk Management If your disk drive is brand new, you might not be able to see...
