Page 2 - spend a few minutes reading to get the very best from it.; Visit our website for:; CUSTOMER CARE AND SERVICE; Always use original spare parts.; Subject to change without notice.
CONTENTS 1. SAFETY INFORMATION............................................................................................. 3 2. CONDITIONS OF USE................................................................................................ 4 3. SAFETY INSTRUCTIONS....................................
Page 4 - Installation
• The ventilation opening in the base (if applicable) must not be covered by a carpet, mat, or any floor covering. • The appliance must be connected to the water mains using the new supplied hose sets, or other new hose sets supplied by the Authorised Service Centre. • Old hose sets must not be reus...
Page 6 - INSTALLATION; Unpacking
4. INSTALLATION WARNING! Refer to Safety chapters. 4.1 Unpacking WARNING! Remove all the packaging and the transit bolts before installing the appliance. WARNING! Use the gloves. 1. Remove the external film. If necessary, use a cutter. 2. Remove the cardboard top and the polystyrene packaging materi...
Page 9 - Water drainage; On the edge of a sink
CAUTION! Make sure that there are no leaks from the couplings. Do not use an extension hose if the inlet hose is too short. Contact the service centre for the replacement of the inlet hose. 4.4 Water-stop device The inlet hose has a water stop device. This device prevents water leaks in the hose bec...
Page 10 - PRODUCT DESCRIPTION; Special features
The end of the drain hose must always be ventilated , i.e. the inner diameter of the drain pipe (min. 38 mm - min. 1.5") must be larger than the external diameter of the drain hose. 4. If the end of the drain hose looks like this (see the picture), you can push it directly into the stand pipe. 5...
Page 11 - Appliance overview; CONTROL PANEL; Control panel description
5.2 Appliance overview 1 2 3 10 6 7 8 4 11 9 12 13 5 1 Worktop 2 Detergent dispenser 3 Control panel 4 Door handle 5 Internal light 6 Rating plate 7 Drain pump filter 8 Feet for levelling the appliance 9 Drain hose 10 Inlet hose connection 11 Mains cable 12 Transit bolts 13 Hose support 6. CONTROL P...
Page 12 - Display
1 Programme dial 2 Display 3 Energy saving touch button (Eco) 4 Time saving touch button (TimeSave) 5 Skipping phase touch button(Option) • Wash phase skipping (Only Rinse) • Wash and rinse phase skipping (Spin Only) • Only drain (Drain Only) 6 Start/Pause touch button (Start/Pause) 7 Extra rinse to...
Page 13 - DIAL AND BUTTONS; Introduction
Washing phase indicator: it flashes during prewash and wash phase. Rinsing phase indicator: it flashes during rinse phase. The indicator appears when the Soft Plus option is activated. Spin and drain phase indicator. It flashes during spin and drain phase. MIX OKO MIX indicator. Steam phase indicato...
Page 14 - Decrease the spin speed.; Extra Rinse
7.3 Temp When you select a washing programme, the appliance automatically proposes a default temperature.Touch this button repeatedly until the desired temperature value appears on the display.When the display shows the indicators and , the appliance does not heat the water. 7.4 Spin When you set a ...
Page 15 - once; Skipping phase button
This option increases the programme duration. If the Extra Rinse is set as a default option and you select a compatible washing programme, the displayshows . In this case, by pressing the Extra Rinse button , it is possible to add just one rinse. 7.7 Plus Steam This option adds a steam phase followe...
Page 16 - PROGRAMMES; Programme Chart; Washing programmes
8. PROGRAMMES 8.1 Programme Chart Washing programmes Programme Programme description Washing programmes Cottons White cotton and coloured cotton . Normal soil and light soil. Synthetics Synthetic items or mixed fabric items . Normal soil. Delicates Delicate fabrics such as acrylics, viscose, polyest...
Page 18 - Programme options compatibility
Programme Default temperatureTemperature range Maximum spin speedSpin speed range Maximum load Steam - - 1.5 kg OKOPower 30 °C60 °C - 30 °C 1600 rpm1600 rpm - 400 rpm 5 kg Anti-Allergy 60 °C 1600 rpm1600 rpm - 400 rpm 10 kg 20 min. - 3 kg 30 °C40 °C - 30 °C 1200 rpm1200 rpm - 400 rpm 3 kg Outdoor 30...
Page 19 - Woolmark Apparel Care -; BEFORE FIRST USE
Cottons Synthetics Delicates Wool/Silk Steam OKOPower Anti-Allergy 20 min. - 3 kg Outdoor Duvet Time Save 3) ■ ■ ■ ■ Only Rinse ■ ■ ■ ■ ■ ■ ■ ■ ■ Spin Only ■ ■ ■ ■ ■ ■ ■ ■ ■ Drain Only ■ ■ ■ ■ ■ ■ ■ ■ ■ Delay Start ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ Plus Steam 1) ■ ■ ■ Soft Plus ■ ■ ■ ■ ■ ■ 1) This option is not a...
Page 20 - SETTINGS; Child Lock; off; Acoustic signals; DAILY USE; Activating the appliance
10. SETTINGS 10.1 Child Lock With this option you can prevent that the children play with the control panel.• To activate/deactivate this option, touch the Stains/Prewash and the Extra Rinse buttons simultaneouslyuntil the indicator comes on/goes off on the display. You can activate this option:• Af...
Page 22 - With the flap in the; Setting a programme; not; Starting a programme
4. To use liquid detergent, turn the flap down. With the flap in the position DOWN: • Do not use gelatinous or thick liquid detergents. • Do not put more liquid detergent than the limit shown on the flap. • Do not set the prewash phase. • Do not set the delay start function. 5. Measure out the deter...
Page 24 - without repeating
11.9 Programme phase indicators When the programme starts the indicator of the running phase flashes and the other phase indicators are steady on.E.g. the washing or pre wash phase is running: . When the phase ends the relevant indicator stops flashing and is steady on. The next phase indicator star...
Page 25 - HINTS AND TIPS
In the display all washing phase indicators become steady and the timearea shows .The indicator of the Start/Pause button goes off. The door unlocks and the indicator goes off. 1. Press the On/Off button to deactivate the appliance. After five minutes from the end of the programme, the energy saving...
Page 27 - CARE AND CLEANING
Use the correct quantity of water softener. Follow the instructions that you find on the packaging of the product. 13. CARE AND CLEANING WARNING! Refer to Safety chapters. 13.1 External cleaning Clean the appliance with mild soap and warm water only. Fully dry all the surfaces. CAUTION! Do not use a...
Page 28 - Cleaning the drain pump
1. Open the drawer. Press the catch downwards as indicated in the picture and pull it out. 1 2 2. Remove the top part of the additive compartment to aid cleaning and flush it out under running warm water, to remove any traces of accumulated detergent. After cleaning, replace the top part in its posi...
Page 31 - TROUBLESHOOTING; In case of major problems, the acoustic
45° 20° 13.9 Emergency drain If the appliance cannot drain the water, carry out the same procedure, described in 'Cleaning the drain filter' paragraph. If necessary, clean the pump.When you drain the water with the emergency drain procedure, you must activate the drain system again: 1. Put 2 litres ...
Page 32 - Possible failures
• - No communication between electronic elements of the appliance. Switch it off and switch on again. • - The anti-flood device is on. Disconnect the appliance and close the water tap. Contact the Authorised Service Centre. WARNING! Deactivate the appliance before carrying out any check. 14.2 Possib...
Page 34 - Emergency door opening; TECHNICAL DATA
14.3 Emergency door opening In case of power failure or functioning failure the appliance door remains locked. The washing programme continues when the power is restored. If the door remains locked in case of failure, it is possible to open it using the emergency unlock function.Before opening the d...
Page 35 - ACCESSORIES; Available in; WARRANTY
Maximum Load Cotton 10 kg Spin Speed Maximum 1600 rpm 1) Connect the water inlet hose to a water tap with a 3/4'' thread. 16. ACCESSORIES 16.1 Available in www.aeg.com/shop or from authorised dealer Only appropriate accessories approved by AEG ensure the safety standards of the appliance. If unappro...
Page 38 - ENVIRONMENTAL CONCERNS
FOR SERVICE or to find the address of your nearest state service centre in Australia PLEASE CALL 1300 363 664OR EMAIL [email protected] For the cost of a local call (Australia only) FOR SPARE PARTS or to find the address of your nearest state spare parts centre in Australia PLEASE CALL 13 13 50OR EM...
