AEG LFM8C9612S- User Manual

It is possible to see water flowing from the drain hose. This is due to the testing with water of the appliance in factory. 15. Remove the three bolts by using the key supplied with the appliance. 16. Pull out the plastic spacers. 17. Put the plastic caps, that you find in the user manual bag, in th...

Make sure that the plastic guide cannot move when the appliance drains. Make sure that the drain hose end is not immersed in the water. There may be a return of dirty water into the appliance. 3. To a stand pipe with vent-hole - Insert the drain hose directly into a drain pipe. Refer to the illustra...

thanks to different pre-mixing phases that dissolves first the detergent and then fabric softener in the water before they are distributed in the laundry. So every fibre is reached and cared for. • The ProSense technology detects the laundry load size defining the programme duration in 30 seconds. T...

5. CONTROL PANEL 5.1 Control panel description 2 3 6 12 11 10 8 1 4 5 7 9 13 1 Programme dial 2 Display 3 Energy saving touch button (Eco) 4 Time saving touch button (Gain deTemps) 5 Skipping phase touch button(Options) • Wash phase skipping (Rinçage) • Wash and rinse phase skipping (Essorage) • Onl...

5.2 Display MIX Maximum load indicator. The icon flashes during laundry load esti- mation (refer to "PROSENSE load detection" paragraph). Maximum laundry indicator. It flashes when the laundry load exceeds themaximum declared load of the selected programme. Delay start indicator. Door locked...

Time saving indicator. Temperature indicator. The indicator appears when a cold wash is set. Spin speed indicator. Rinse hold indicator. Quiet indicator. Pre-wash indicator. Stain indicator. Extra rinse indicator. 6. DIAL AND BUTTONS 6.1 Marche/Arrêt Pressing this button for a few seconds allows to ...

The drum turns regularly to reduce creasing. The door stays locked. The drum turns regularly to reduce creasing. You must drain the water to unlock the door. Touch Départ/Pause button: the appliance performs the spinning phase and drains the water. • Activate the Quiet option. All spinning phases (i...

button the anti-crease movements stop and the door unlocks. A small laundry load helps to reach better results. 6.8 Eco Set this option for slightly or normally soiled items washed at 30°C or higher temperatures.The appliance decreases the washing temperature and extends the washing time to obtain a...

Blanc/Couleurs Synthétiques Délicats Laine/Soie Vapeur ÖKOPower Anti-Allergie 20 min. - 3 kg Outdoor Jeans ■ ■ ■ Taches 1) ■ ■ ■ ■ ■ Prélavage ■ ■ ■ ■ ■ Rinçage Plus ■ ■ ■ ■ ■ ■ Eco 2) ■ ■ ■ ■ Gain de Temps 3) ■ ■ ■ ■ ■ Rinçage ■ ■ ■ ■ ■ ■ ■ ■ ■ Essorage ■ ■ ■ ■ ■ ■ ■ ■ ■ Vidange ■ ■ ■ ■ ■ ■ ■ ■ ■ D...

8. BEFORE FIRST USE 1. Make sure that all transit bolts have been removed from the appliance. 2. Make sure that the electrical power is available and the water tap is open. 3. Pour 2 litres of water into the detergent compartment marked by . This action activates the drain system. 4. Pour a small qu...

indicator comes on/goes off above the indicator. 10. DAILY USE WARNING! Refer to Safety chapters. 10.1 Activating the appliance 1. Connect the mains plug to the mains socket. 2. Open the water tap. 3. Press the Marche/Arrêt button for a few seconds to activate the appliance. A short tune sounds (if ...

After a washing cycle, if necessary, remove any detergent residue from the detergent dispenser. 10.4 Check the position of the flap 1. Pull out the detergent dispenser until it stops. 2. Press the lever down to remove the dispenser. 1 2 3. To use powder detergent, turn the flap up. 4. To use liquid ...

• After 5 minutes from the end of the washing programme Press the Marche/Arrêt button to activate the appliance again. The display shows the end of the last set programme. Turn the programme dial to set a new cycle. If you set a programme or an option that ends with water in the drum, the Stand-by f...

11.4 Ecological hints • Set a programme without the prewash phase to wash laundry with normal soil. • Always start a washing programme with the maximum load of laundry allowed. • If you pre-treat the stains or use a stain remover, set a programme with a low temperature. • To use the correct quantity...

45° 20° 12.9 Emergency drain If the appliance cannot drain the water, carry out the same procedure, described in 'Cleaning the drain filter' paragraph. If necessary, clean the pump.When you drain the water with the emergency drain procedure, you must activate the drain system again: 1. Put 2 litres ...

• - The mains supply is unstable. Wait until the mains supply is stable. • - No communication between electronic elements of the appliance. Switch it off and switch on again. The programme was not finished properly or the appliance stopped too early. If the alarm code appears again, contact the Auth...

Problem Possible solution The washing results arenot satisfactory. • Increase the detergent quantity or use a different deter- gent. • Use special products to remove the stubborn stains before you wash the laundry. • Make sure that you set the correct temperature.• Decrease the laundry load. Too muc...

5. Take out the laundry and then close the appliance door. 6. Close the filter flap. 14. CONSUMPTION VALUES Stated values are obtained in laboratory conditions with relevant stand- ards. Different causes can change the data: the quantity and type of laundry and ambient temperature. Water pressure, t...

Programmes Load(kg) Energyconsump-tion (kWh) Waterconsump-tion (litre) Approxi-mate pro-grammeduration(minutes) Remain-ing mois-ture (%) 1) Standard 40°C cotton 4.5 0.36 40 190 44 1) At the end of spin phase. Off Mode (W) 0.30 Left On Mode (W) 0.30 The information given in the chart above is complia...

16. ACCESSORIES 16.1 Available in www.aeg.com/shop or from authorised dealer Only appropriate accessories approved by AEG ensure the safety standards of the appliance. If unapproved parts are used, any claims will be invalidated. 16.2 Fixing plate kit If you install the appliance on a plinth, secure...