3M 746 - Manual
3M 746 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – Declaration of Conformity; Accessories; template; figure 1
- Page 4 – Power Supply; Wrist Strap Test; Depress the metal contact plate and hold it.; Wall Mounting; Note: Make sure the area on the unit in which
- Page 5 – Calibration Procedures; Resistance Substitution Box; Wrist strap test circuit check:; Resistance substitution box; figure 2
- Page 6 – x x x; MTM Wrist Strap Tester 746 Logbook
- Page 8 – Electronic Solutions Division
Wrist Strap Tester 746
Instructions
European Version
March 2005
78-8136-2118-8
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
3 78-8136-2118-8 1.0 General Wrist straps are the primary method to minimize charge generation on the human body. They must be able to drain this charge as rapidly as it is generated. For this reason, it is important to test wrist straps on a regular basis to ensure they are functioning properly, an...
4 78-8136-2118-8 4.0 Specifications Base unit: 158 x 95 x 33 mm (6.25 x 3.75 x 1.25 inches) Weight: 200 g (7 ounces) without battery Battery: 9V alkaline type, e.g. IEC 6F22 Tolerance: 750 k Ω + 20%/-0%, 10 M Ω ± 10% Measurement Voltage: DC (19±1) V (open circuit) Power Supply (not included): DC 9V,...
5 78-8136-2118-8 6.0 Calibration Procedures The 3M™ Wrist Strap Tester 746 cannot be adjusted, but the following steps can be used to determine that the tester is operating within its specification. Equipment needed: 1. Resistance Substitution Box (750 k Ω - 11 M Ω , tolerance < 2%) 2. 2 leads (t...
