Zanussi ZGF 982- Manual

5 Maintenance and Cleaning Before any maintenance or cleaning can be carriedout, you must DISCONNECT the hob from the electricity supply.The hob is best cleaned whilst it is still warm, asspillage can be removed more easily than if it isleft to cool. The Hob Top Regularly wipe over the hob top using...

6 Something Not Working? If the hob is not working correctly, please carry out the following checks before contacting your local Service ForceCentre. SYMPTOM „ There is no spark when lighting the gas „ The gas ring burns unevenly SOLUTION ‹ Check that the unit is plugged in and the electrical supply...

7 Zanussi Guarantee conditions We, Zanussi, undertake that if, within 24 months of thedate of the purchase, this Zanussi appliance or any partthereof is proved to be defective by any reason only offaulty workmanship or materials, we will, at our option,repair or replace the same FREE OF ANY CHARGE f...

8 OVERALL DIMENSIONS Width: 860 mm Depth: 510 mm CUT OUT DIMENSIONS Width: 830 mm Depth: 480 mm SUPPLY CONNECTIONSGas: R 1/2 inch (1/2 inch male) Rear right hand corner Electric: 230 V 50 Hz supply, 3 core flexible cable with nonrewireable plug fitted with a 3 amp cartridge fuse. Rear Left Burner (s...

9 FITTING THE GAS HOB WITHOUT A COOKER HOOD ABOVE FITTING THE GAS HOB WITH A COOKER HOOD ABOVE 700 mm 400 mm 400 mm 100 mm 55 mm 50 mm 50 mm 600 mm 700 mm 400 mm 400 mm 100 mm 55 mm 600 mm 50 mm 50 mm FO 2369* FO 2231* Important safety requirements This hob must be installed in accordance with the G...

10 Installation IMPORTANT: This hob must be installed by a competent person to the relevant Gas Standards.Any gas installation must be carried out by acompetent person.The manufacturer will not accept liability, shouldthe above instructions or any of the other safetyinstructions incorporated in this...

11 F O2564 FO 2044 3 Dimensions are given in mm. Building In Building over a cupboard ordrawer If the hob is to be installed above a cupboard or drawer itwill be necessary to fit a heat resistant board below thebase of the hob on the underside of the work surface.It is also recommended to carry out ...

12 Electrical connections Any electrical work required to install this hobshould be carried out by a qualified electrician orcompetent person, in accordance with the currentregulations. THIS HOB MUST BE EARTHED. The manufacturer declines any liability should thesesafety measures not be observed. Thi...

13 Fault Finding Preliminary Electrical SystemsCheck A. EARTH CONTINUITY CHECK - Appliance must be electrically disconnected - meter set on Ω (Ohms) x 1 scale and adjust zero if necessary.a) Test leads from any appliance earth point to earth pin on plug. Resistance should be less than0.1 Ω (Ohm), ch...

14 Ignition System / Gas Ignition YES Check plug top fuseandreplace if necessary Check polarity andearth continuity ofsupply point Check earth continuityof appliance Ignitor does not spark Check fitting of burners Check position of theelectrode Check by pass simmeradjusted Light burner manually Chec...

15 Commissioning When the hob has been fully installed it will be necessaryto check the minimum flame setting. To do this, followthe procedure below. - Turn the gas tap to the MAX position and ignite. - Set the gas tap to the MIN flame position then turn the control knob from MIN to MAX several time...