Yamaha DVD-S2300 - User Manual
Yamaha DVD-S2300 Player – User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – Laser Diode Properties; Semiconductor laser GaAlAs; WARNING
- Page 4 – PREVENTION OF ELECTRO STATIC DISCHARGE; Grounding for Electrostatic Damage Prevention; Worktable grounding; Handling of the Optical Pickup; LOCALE MANAGEMENT INFORMATION
- Page 6 – REAR PANELS; U model
- Page 7 – SPECIFICATIONS
- Page 8 – INTERNAL VIEW; DVD Mechanism
- Page 9 – DISASSEMBLY PROCEDURE; Removal of Top Cover; (番号順に部品を取り外してください。)
- Page 10 – Gear Jig; Removal of Tray Lid
- Page 11 – Removal of Front Panel Unit; ロントパネルユニットを取り外します。(Fig. 6)
- Page 13 – and
- Page 14 – ス用延長ケーブルに交換します。(Fig. 12)
- Page 16 – OPTICAL PICKUP SELF-DIAGNOSIS AND REPLACEMENT PROCEDURE; • Be sure to perform the following operation in the DVD mode.
- Page 17 – ■ 光ピックアップの故障診断と交換手順; 注意
- Page 18 – SERVICE MODE AND SELF-DIAGNOSIS FUNCTION
- Page 19 – DVDモードインジケーターが点灯します。; ■ サービスモードと自己診断機能
- Page 22 – Item
- Page 23 – ●テストモードの起動; SACDモードインジケーターが点灯します。; ●テストモード起動時の表示; 電源スイッチをOFFにします。; ●テスト機能一覧; テストモードでは下記のテスト機能が使用できます。; Service Precautions; Recovery After the DVD Player is Repaired; Handling After Completing Repairs; Use the following procedure after completing repairs.; 修理完了後は次の操作を行なってください。
- Page 25 – ASSEMBLING AND DISASSEMBLING THE MECHANISM UNIT; メカニズムユニットの分解組立; Disassembly Procedure
- Page 26 – <メカニズムユニット底部>
- Page 28 – 注意:; a. Place the tray on the unit from rearward.
- Page 29 – < P r e c a u t i o n s i n R e a s s e m b l i n g t h e T r a v e r s e; 下さい。
- Page 30 – トラバースギアBはトラバースギアCの下にあります。; Optical Pickup Unit; <トラバースブロック底部>
- Page 31 – Precautions in Optical Pickup Replacement; D o n o t t o u c h t h e l a s e r d i o d e , a c t u a t o r o r t h e i r
- Page 32 – Install the Terminal FPC, TRV feed rack on the optical; Disassembling the Optical Pickup Unit
- Page 35 – Disassembling the Middle Chassis; フローティングゴムを外す。; Disassembling the Spindle Motor Unit; Remove the rubber isolators.; unit
- Page 36 – Important Points in Optical Pickup Tilt; For your information:
- Page 37 – Check after Adjustment
- Page 38 – Procedure for Screw Lock; base and traverse unit in this sequence.; ELECTRICAL CONFIRMATION /; terminal and terminate at 75 ohms.; V i d e o O u t p u t ( L u m i n a n c e S i g n a l ); Measurement point / 測定点
- Page 39 – Confirmation; Measurement point
- Page 40 – DISPLAY DATA
- Page 41 – ANODE CONNECTION
- Page 42 – IC DATA
- Page 44 – PIN CONNECTION DIAGRAM; • Transistors
- Page 45 – SACD; PRINTED CIRCUIT BOARD
- Page 54 – TIC DIA; D MODULE; TIC DIA; BLOCK DIAGRAM
- Page 55 – LOADING MECHANISM
- Page 77 – ABBREVIATIONS IN THIS LIST ARE AS FOLLOWS:; PARTS LIST; ELECTRICAL PARTS
- Page 100 – Chip Resistors; Description
- Page 102 – MECHANICAL PARTS; EXPLODED VIEW
- Page 103 – BIND HEAD BONDING B‐T. SCREW
- Page 104 – DVD-MECHANISM EXPLODED VIEW
- Page 105 – REMOTE CONTROL
1 0 0 8 2 6
P.O.Box 1, Hamamatsu, Japan
■
CONTENTS
TO SERVICE PERSONNEL .......................................... 2
PREVENTION OF ELECTRO STATIC DISCHARGE ... 4
LOCALE MANAGEMENT INFORMATION ................... 4
FRONT PANELS ............................................................ 5
REMOTE CONTROL PANELS ...................................... 5
REAR PANELS .............................................................. 6
SPECIFICATIONS .......................................................... 7
INTERNAL VIEW ........................................................... 8
DISASSEMBLY PROCEDURE /
.............. 9~15
OPTICAL PICKUP SELF-DIAGNOSIS AND REPLACEMENT PROCEDURE /
光ピックアップの故障診断と交換手順 ..................
16~17
SERVICE MODE AND SELF-DIAGNOSIS FUNCTION /
サービスモードと自己診断機能 .............................
18~24
ASSEMBLING AND DISASSEMBLING THE MECHANISM UNIT /
25~35
OPTICAL PICKUP TILT ADJUSTMENT /
.....................................
36~39
DISPLAY DATA ..................................................... 40~41
IC DATA ................................................................. 42~43
PIN CONNECTION DIAGRAM .................................... 44
PRINTED CIRCUIT BOARD .................................. 45~53
BLOCK DIAGRAM ................................................. 54~55
SCHEMATIC DIAGRAM ........................................ 56~76
PARTS LIST ......................................................... 77~104
REMOTE CONTROL .................................................. 105
SERVICE MANUAL
DVD AUDIO/VIDEO SACD PLAYER
DVD-S2300
DVD-S2300
IMPORTANT NOTICE
This manual has been provided for the use of authorized YAMAHA Retailers and their service personnel.
It has been assumed that basic service procedures inherent to the industry, and more specifically YAMAHA Products, are already
known and understood by the users, and have therefore not been restated.
WARNING:
Failure to follow appropriate service and safety procedures when servicing this product may result in personal
injury, destruction of expensive components, and failure of the product to perform as specified. For these reasons,
we advise all YAMAHA product owners that any service required should be performed by an authorized
YAMAHA Retailer or the appointed service representative.
IMPORTANT:
The presentation or sale of this manual to any individual or firm does not constitute authorization, certification or
recognition of any applicable technical capabilities, or establish a principle-agent relationship of any form.
The data provided is believed to be accurate and applicable to the unit(s) indicated on the cover. The research, engineering, and
service departments of YAMAHA are continually striving to improve YAMAHA products. Modifications are, therefore, inevitable
and specifications are subject to change without notice or obligation to retrofit. Should any discrepancy appear to exist, please
contact the distributor's Service Division.
WARNING:
Static discharges can destroy expensive components. Discharge any static electricity your body may have
accumulated by grounding yourself to the ground buss in the unit (heavy gauge black wires connect to this buss).
IMPORTANT:
Turn the unit OFF during disassembly and part replacement. Recheck all work before you apply power to the unit.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Other Manuals for Yamaha DVD-S2300
Summary
DVD-S2300 3 DVD-S2300 Laser Diode Properties Type: Semiconductor laser GaAlAs Wave length: 658 nm (DVD)790 nm (VCD/CD) Output Power: CLASS II a 1mW (DVD) CLASS I 1mW (VCD/CD) VARO! : AVATTAESSA JA SUOJALUKITUS OHITETTAESSA OLET ALTTIINA NÄKYMÄTTÖMÄLLE LASER-SÄTEILYLLE. ÄLÄ KATSO SÄTEESEEN. VARNING! ...
DVD-S2300 4 DVD-S2300 ■ PREVENTION OF ELECTRO STATIC DISCHARGE The laser diode in the traverse unit (optical pickup) may be damaged due to static electricity from clothes or the human body.Use caution to prevent electrostatic damage when servicing or handling the laser diode. 1. Grounding for Electr...
DVD-S2300 6 DVD-S2300 ■ REAR PANELS U model A model B, G models J model