Xerox 701P40211 - Manual

Xerox 701P40211

Xerox 701P40211 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
25 Page 25
26 Page 26
27 Page 27
28 Page 28
29 Page 29
30 Page 30
31 Page 31
32 Page 32
33 Page 33
34 Page 34
35 Page 35
36 Page 36
37 Page 37
38 Page 38
39 Page 39
40 Page 40
41 Page 41
42 Page 42
43 Page 43
44 Page 44
45 Page 45
46 Page 46
47 Page 47
48 Page 48
49 Page 49
50 Page 50
51 Page 51
52 Page 52
53 Page 53
54 Page 54
55 Page 55
56 Page 56
57 Page 57
58 Page 58
59 Page 59
60 Page 60
61 Page 61
62 Page 62
63 Page 63
64 Page 64
65 Page 65
66 Page 66
67 Page 67
68 Page 68
69 Page 69
70 Page 70
71 Page 71
72 Page 72
73 Page 73
74 Page 74
75 Page 75
76 Page 76
77 Page 77
78 Page 78
79 Page 79
80 Page 80
81 Page 81
82 Page 82
83 Page 83
84 Page 84
85 Page 85
86 Page 86
87 Page 87
88 Page 88
89 Page 89
90 Page 90
91 Page 91
92 Page 92
93 Page 93
94 Page 94
95 Page 95
96 Page 96
97 Page 97
98 Page 98
99 Page 99
100 Page 100
101 Page 101
102 Page 102
103 Page 103
104 Page 104
105 Page 105
106 Page 106
107 Page 107
108 Page 108
109 Page 109
110 Page 110
Page: / 110

Table of Contents:

  • Page 3 – Table of Contents; Introduction
  • Page 5 – Printing
  • Page 6 – Accounting and Billing
  • Page 7 – Hints and Tips
  • Page 11 – About this guide
  • Page 12 – Conventions; This guide includes the following conventions; Customer Support; For additional assistance, dial the following numbers:
  • Page 13 – Gateway Configuration; Internet Services (HTTP) Gateway Configuration; Enter name: Value data
  • Page 14 – IPP Gateway Configuration
  • Page 15 – When asked to accept the values and update the; Simple Network Management Protocol (SNMP) Configuration
  • Page 16 – Enter the following Command Line variables:
  • Page 17 – Printer and job messages
  • Page 19 – NOTE: The other files in Xerox General MIB are not supported.; NDS Setup
  • Page 21 – Backup and Restore; Backup
  • Page 22 – Any soft fonts that have been loaded on the system; Restore
  • Page 23 – Backing up a System; Insert the XBR floppy in the disk drive and a blank tape in the; Type backup and as the system asks for a new tape, remove
  • Page 24 – reboot and pressing Enter.
  • Page 25 – Security and Network Setup; Access and Security; UNIX accounts are defined during the installation process:
  • Page 26 – Overview of Security; Select the Trusted User or System Administrator access level
  • Page 27 – User Password changes; WARNING; Roles and responsibilities; Xerox responsibility
  • Page 28 – Security Setup
  • Page 29 – Using the High security setting; telnet
  • Page 31 – User and File-level changes; User level
  • Page 32 – The following databases are disabled when Security is invoked:
  • Page 33 – The Remote CDE login is disabled.
  • Page 34 – XDSS script components; The configure-xdss script
  • Page 35 – Remote shell internet service; User Account Management
  • Page 36 – Print command line client from remote systems; Users must be listed in the password database.
  • Page 37 – Other security tips; Configure for xrxusr; Set up the xrxusr password as root user in a terminal type:
  • Page 38 – Document and backup; Sample of inetd.conf file
  • Page 43 – Quick reference
  • Page 45 – Controller settings for limited FIFO scheduling/printing; When FIFO is critical, set the release status of all other
  • Page 46 – Enable/Disable FIFO Job Scheduling; To enable or disable FIFO job scheduling, perform the following:; Respond as appropriate to the following prompts: ‘This; The script will exit.; ’Currently FIFO Job Scheduling is off’; The following messages will appear:; ‘Enabling FIFO Job Scheduling’
  • Page 47 – The following message will appear:; ‘Disabling FIFO Job Scheduling’
  • Page 48 – ASCII and PCL Printing Utility; Impact on DocuSP printers; The setpclcontrol utility offers the following user controls:
  • Page 49 – Set lp/lprcopycount utility; Syntax of the utility:; setlpcopycount -f option
  • Page 50 – Socket Gateway Configuration Utility: setVPSoption
  • Page 51 – TIFF files; TIFF orientation; Use CCITT Group 4 compression for speed.
  • Page 52 – DocuSP supports values of 1 and 2.
  • Page 53 – Strip Byte Counts and Strip Offsets; DocuSP supports single and multiple strip images.; X and Y Resolution; Values must be supplied for printing.; MICR Enablement; NOTE: Only 300 dpi mode is supported for MICR printing.
  • Page 54 – Using VIPP; To implement the VIPP Start feature, perform the following:; Paper Trays
  • Page 55 – Printing hints
  • Page 57 – Finishing; Subset Finishing
  • Page 58 – Creating jobs to use subset finishing; PostScript code (using the “setpagedevice” operator)
  • Page 59 – PCL Offset/Separator/Subset Finishing command; The placement guidelines are as follows:
  • Page 60 – PCL Paper Source Command; To program the PCL Paper Source, use the following guidelines:; Mixed Stacking
  • Page 61 – Additional finishing information
  • Page 63 – How to choose fonts; Fonts; At the DocuSP controller, a font can exist in three forms:; Resident fonts
  • Page 67 – PCL resident fonts; Scalable Intellifont typefaces
  • Page 69 – Optional or soft fonts
  • Page 70 – PCL 5e fonts
  • Page 71 – Accounting; Auto exporting accounting log
  • Page 78 – count
  • Page 79 – Billing; Billable Events
  • Page 80 – Billing Meters
  • Page 81 – Troubleshooting; Calling for service; Before calling for service, make note of:; Declared faults
  • Page 82 – Printer fault; Undeclared faults
  • Page 83 – Client problems; The user must exit the Xerox Document Submission and; Macintosh problems
  • Page 84 – NOTE: You must be logged in as the root user to delete this file.; DigiPath problems; NOTE: The “Locale” is the locale of your server.
  • Page 85 – fr for French; Print Quality problems
  • Page 86 – Inoperable system problems
  • Page 87 – Resubmit the job to a draft PostScript printer to determine if
  • Page 88 – Job Integrity problems
  • Page 89 – TIFF problems
  • Page 90 – Has the file been redistilled again using a newer PostScript?; Restore password; An error message will display, “A problem was detected in the
  • Page 91 – Restart DocuSP software without rebooting
  • Page 92 – Ensure that the banner and error pages are enabled,; Printing system logs; Message; The format of the file is as follows:
  • Page 93 – Disposition; The format of these files is as follows:; Printing the system logs; Open a Terminal window and log in as “root”.
  • Page 94 – Printing the accounting log; Rebooting and restarting; Place your mouse cursor in the background outside of the; Put your mouse cursor in the window and type: su; A Program Terminated message and an Ok prompt display.
  • Page 95 – DISplay / NODisplay: Display or suppress XJDC messages
  • Page 96 – Configuring XJDC/Unix; XJDC Hints and Tips
  • Page 97 – Output files; JSL source listing file
  • Page 98 – Configuration window displays.
  • Page 99 – General; Disabling the Solaris 8 Screen Saver; To disable the Solaris 8 Screen Saver:
  • Page 100 – Color Systems; General Comments
  • Page 101 – Time required to print PDL
  • Page 102 – Job submission order; Define own media; Variable data
  • Page 103 – Image Quality
  • Page 104 – Job Printing Hints; Disable banner sheets when making multiple copies of a job.; Skipped Pitches
  • Page 105 – PCI Channel Interface PWB Trace Capture Procedure; Perform a Trace
  • Page 106 – Export the trace file to floppy; To export the trace file to a floppy, perform the following:
  • Page 107 – Index
Loading the manual

Xerox Document Services Platform Series

Common Controller
System Guide

701P40211
Version 3.7
April, 2003

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 3 - Table of Contents; Introduction

SYSTEM GUIDE i Table of Contents 1. Introduction 1-1 About this guide 1-1 Contents 1-1 Conventions 1-2 Customer Support 1-2 2. Gateway Configuration 2-1 Internet Services (HTTP) Gateway Configuration 2-1 IPP Gateway Configuration 2-2 Simple Network Management Protocol (SNMP) Configuration 2-3 Config...

Page 5 - Printing

TABLE OF CONTENTS SYSTEM GUIDE iii Quick reference 4-19 5. Printing 5-1 First In/First Out (FIFO) Printing 5-1 Controller settings for limited FIFO scheduling/printing 5-1 Enable/Disable FIFO Job Scheduling 5-2 ASCII and PCL Printing Utility 5-4 Impact on DocuSP printers 5-4 setpclcontrol Utility 5-...

Page 6 - Accounting and Billing

TABLE OF CONTENTS iv SYSTEM GUIDE Non Resident Fonts 7-6 Font substitution 7-7 8. Accounting and Billing 8-1 Accounting 8-1 Auto exporting accounting log 8-1 Accounting exported values 8-1 Accounting file fields 8-2 Billing 8-9 Billable Events 8-9 Billing Meters 8-10 9. Troubleshooting 9-1 Calling f...

Other Xerox Models

All Xerox Other