WEN 3625 - User Manual

1. TOOL PURPOSE. This circular saw is designed to cut through softwood only. Cutting other materials could result in fire, injury, or damage to the workpiece. Using the machine for any other purpose for which it is not designed may result in serious injuries, machine damage and voiding of the warran...

8 SPECIFIC RULES FOR THE MINI CIRCULAR SAW LASER SAFETY ATTENTION: LASER RADIATION. CLASS 2 LASER. DO NOT STARE INTO THE BEAM. 1. Do not look directly into the laser beam with unprotected eyes. Never look into the path of the beam. 2. Never point the laser beam towards reflective surfaces. Never poi...

1. EXAMINE EXTENSION CORD BEFORE USE. Make sure your extension cord is properly wired and in good condition. Always replace a damaged extension cord or have it repaired by a qualified person before using it. 2. DO NOT ABUSE EXTENSION CORD. Do not pull on cord to disconnect from receptacle; always di...

KNOW YOUR MINI CIRCULAR SAW Power Switch Blade Release Button Laser Power Switch Handle Arbor Screw Depth Locking Lever Fence Lock Knob Bevel Scale Cutting Guide Notch Cutting Depth Scale Spindle Lock Button Rip Fence Hex Key Storage UNPACKING With the help of a friend or trustworthy foe, carefully ...

11 Fig. 1 INSTALLING/REPLACING THE SAW BLADE (FIGS. 1 & 2) Use saw blades with 4-1/2 inch (115 mm) diameter and 3/8 inch (10 mm) arbor. Do not use a blade that does not match the diameter or arbor size. The pre-installed blade has a body that is 1.2 mm thick and theeth that are 1.8 mm thick . Do...

ASSEMBLY & ADJUSTMENTS SETTING THE DEPTH OF CUT (FIG. 4) Before making a cut, it is important to set the correct cutting depth. The saw’s maximum cutting depth at 90° is 1-11/16 inch (43 mm), at 45° it is 1-1/8" (28 mm). We recommend adjusting the cutting depth about 1/16 inch (2 mm) deeper ...

Fig. 6 ASSEMBLY & ADJUSTMENTS USING THE LASER (FIG. 6) The laser located on the top of your saw can also be used to in- dicate the line of cut. Unscrew the laser cover and install the two AG13 batteries. Securely replace the laser cover. Switch the laser ON and align the laser line with your cut...

PREPARING FOR OPERATION 1. Prepare the work space and position power cords away from the cutting area. Connect your saw to a dust extraction system (see Page. 13). 2. Ensure that the saw blade is sharp. Set the correct depth of cut for your workpiece (see Page. 12). 3. Draw a guideline along the des...

MAINTENANCE ROUTINE INSPECTION Before each use, inspect the general condition of the tool. If any of these following conditions exist, do not use until parts are replaced or the sharpener is properly repaired. Check for: • Loose hardware or improper mounting, • Misalignment or binding of moving part...

PROBLEM CAUSE SOLUTION Motor does not start Power cord damaged or not properly plugged in. Check the power cord, extension cord, power plug and the power outlet. Make sure the outlet is func- tional. Do not use the tool if any cord is damaged. Defective power switch. Stop using the tool and contact ...

WEN Products is committed to building tools that are dependable for years. Our warranties are consistent with this commitment and our dedication to quality. LIMITED WARRANTY OF WEN CONSUMER POWER TOOLS PRODUCTS FOR HOME USE GREAT LAKES TECHNOLOGIES, LLC (“Seller”) warrants to the original purchaser ...