Weber SILVER A - Manual
This Installation Manual covers the setup and safety requirements for Weber Summit built-in gas grills, including precise cutout dimensions, clearance specifications, and structural mounting guidelines. The document addresses key topics such as grill frame placement on level surfaces, required electrical outlet spacing, and gas line installation–including pipe sizing, pressure tolerances, and ventilation standards. It also emphasizes safety protocols for propane supply systems, such as proper enclosure design, cylinder valve accessibility, and compliance with ANSI regulations to prevent hazards like fires or explosions.
Table of Contents:
- Page 1 – Built-in Grill Installation Guidelines and Safety
- Page 2 – Cutout Dimensions and Countertop Installation Specifications
- Page 3 – Gas Supply Installation Specifications and Capacity Tables
- Page 4 – LP Cylinder and Cabinet Installation Safety Standards
- Page 5 – LP Cylinder Enclosure Construction Requirements
- Page 6 – Gas Line Routing and Ventilation Setup
SUMMIT
®
BUILT - IN GAS GRILL DIMENSIONS
THIS GAS APPLIANCE IS DESIGNED FOR
OUTDOOR USE ONLY.
LOCATING YOUR GRILL
When determining a suitable location for your Summit
®
gas grill installation, give attention to concerns such as exposure
to wind, proximity to traffic paths, and keeping any gas supply lines as short as possible. Never locate the Summit
®
gas
grill in a garage, breezeway, shed, under an unprotected overhang, or other enclosed area. Locate the grill and structure
so there is enough room to safely evacuate the area in case of a fire.
CLEARANCE FROM SURFACES OR STRUCTURES
WARNING: Clearance from any surface or structure
is 24 inches from the back and sides of the grill. Refer
to “Typical Gas Supply Installation” before starting
installation.
WARNING: The structure, “island”, countertops, and
adjacent work areas for the built-in grill installation
must be built from non-combustable materials only.
NOTE: If you have questions on what materials are
considered non-combustable, contact you local
building materials supplier or fire department.
An
y Surf
ace
An
y Surf
ace
24 inches Any Surface
24 inches
24 inches
Grill Frame
Note: For a countertop treatment: Recommended 3/4 inc
h
overhang. Notch front edge for frame to fully slide in.
27 inches min. for lid clearance
BUILT-IN STRUCTURE CUTOUT DIMENSIONS
ALL DIMENSIONS ARE TO FINISHED SURFACES.
Built-In Cutout Dimensions
27" Grill 39" Grill
Tolerances
A
30
1/4
"
38
1/4
"
+
1/4
" -
1/4
"
B
34
1/4
"
34
1/4
"
+
1/4
" -
1/4
"
C
21"
21"
+
1/4
" -
1/4
"
WARNING: ALL COUNTERTOP FINISHED SURFACES
MUST BE CONSTRUCTED OF A NONCOMBUSTIBLE
MATERIAL.
SILVER A - SILVER D - GOLD D
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Was this manual helpful?
About this manual
- Brand
- Weber
- Model
- SILVER A
- Document type
- Manual
- Language(s)
- English
- Pages
- 6
- File size
- 2.3 MB
- Format
Summary
Installation requirements, clearance distances from surfaces, cutout dimensions for Silver and Gold series grills, and warnings regarding non-combustible materials.
Built-in cutout dimensions for Summit 28" and 36" grills, required clearances, gas inlet locations, and notes on resting the grill frame on a level structure.
Specifications for built-in gas line locations with diagrams and dimensional tables for 28" and 36" grills, guidelines for bulk propane supply installation, and safety precautions.
