Weber Burner Tube Replacement Instructions - Manual
Weber Burner Tube Replacement Instructions – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Do not loosen screws. The screws are only guides.; Reinstall Burner Tubes (; reverse steps 5 and 6; burner; Center Bracket; Old; row of gas portholes should be facing up.; Do not tighten screws. The screws are only guides.
- Page 3 – Follow steps 1 through 3 in reverse order.; DANGER; LP Grills; the source and rinse connections with water.
- Page 4 – Natural Gas Grills; Hose to manifold connection.
1
Burner Tube Replacement Instructions
55355 07/31/02
WARNING: BEFORE STARTING, TURN THE GAS OFF AT THE GAS SUPPLY, DISCONNECT
THE GAS SUPPLY AND CAREFULLY READ THESE INSTRUCTIONS BEFORE REPLACING THE
MAIN BURNERS.
STEP 2
Remove the Control Panel and burner control knobs
Be sure gas is turned off at source.
Remove control panel and burner control knobs
You will need
: Phillips screwdriver.
1) Remove control knobs.
2) Remove screws through slots in trim with a Phillips
screwdriver.
3) Pull up igniter button until it sticks in the up position and
remove control panel from grill.
*If you have a different style grill, put your fingers under
the edge of the control panel at the control panel push-
in buttons and pull toward you.
(3)
(2)
(1)
*The grill illustrated may have slight
differences than the model purchased
Control panel
push-in buttons
Hole in the
frame brace
(2)
*If you have a different style grill
there will be push buttons
to remove instead of screws
STEP 1
Remove the Manifold and Valve Assembly
Unhook the manifold bracket
(1)
and unscrew the two nuts
(2)
that hold the manifold to the cooking box. Pull the manifold
assembly out of the burners and carefully set it down.
(2)
(1)
Frame Brace
Cookbox
Manifold Valve Assembly
*The grill illustrated may have slight differences than
the model purchased
STEP 3
Remove the Cooking Grates and Flavorizer
®
Bars
Your Weber Gas Barbecue must be OFF and cool.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 5) Slide the burner assembly out from under the guidescrew and washer(1) in the corners of the cooking box. Do not loosen screws. The screws are only guides. (1) 6) Lift and twist the burner assembly slightly, to separate the Crossover ® tube(1) from the burners. Remove the burners from the cookin...
3 STEP 5 Reinstall the Manifold and Valve Assembly and theControl Panel. Follow steps 1 through 3 in reverse order. Check for gas leaks. DANGER Do not use an open flame to check for gas leaks. Be sure there are no sparks or open flames in the area while you check for leaks. Sparks or flames will res...
© 2002 The following trademarks are registered in the name of Weber-Stephen Products Co., an Illinois corporation, located at 200 East Daniels Road, Palatine, Illinois 60067 U.S.A. Australia; Smokey Joe, Weber, Kettle Silhouette , Genesis, Austria; Kettle Silhouette , Smokey Joe, Weber, Benelux; Ket...
