Wagner 9155 - Manual

English 6 Assembly Do not plug in the power cord until assembly is complete. If you have one of the cart models, follow these assembly instructions. If you have the model 9145 sprayer, skip to item 4, below. 1. Twist the knobs on either side of the handle counterclockwise to unlock the handle. Pull ...

7 English Before you Begin - This section contains instructions that will be repeated throughout this manual. Locking the Spray Gun Always lock the trigger off when attaching the spray tip or when the spray gun is not in use. GX-05 / GX-07 The gun is locked when the trigger lock is at a 90º angle (p...

English 8 Preparing the Sprayer All new units are performance-tested at the factory and are shipped with test fluid in the fluid section to prevent corrosion during shipment and storage. If you have already used your pump, some water or solvent used in cleaning may remain in the fluid section. Wheth...

9 English Preparing the Spray Hose and Spray Gun The spray tip assembly should not be attached to the spray gun when purging the spray hose. Failure to comply could result in an injection injury. 1. Unlock the spray gun and turn the PRIME/SPRAY knob to PRIME. 2. PULL the trigger and aim the spray gu...

English 10 Practice / Spraying Technique IMPORTAnT: Be sure that the paint hose is free of kinks and clear of objects with sharp cutting edges. 1. Switch the pump ON (l). Turn the PRIME/SPRAY knob to SPRAY. Turn the pressure control dial to maximum pressure (+). The spray hose should stiffen as pain...

GX-05 / GX-07 GX-08 CLEAn 11 English Spraying Troubleshooting - unclogging the Spray Tip If the spray pattern becomes distorted or stops completely while the gun is triggered, follow these steps. Do not attempt to unclog or clean the tip with your finger. High pressure fluid can cause injection inju...

English 12 Spraying Troubleshooting - Cleaning the Spray Gun Filter The screen at the bottom of the suction tube may also need cleaning. Check it every time you change spray containers. The filter must be cleaned every time you use your sprayer. When using thicker spray materials, the filter might n...

13 English Cleanup Important Cleaning notes - Read before cleaning • When using latex materials, clean your sprayer and components with water. When using oil-based materials, use mineral spirits. DO nOT use gasoline to clean your sprayer. • Do not use mineral spirits on latex materials, or the mixtu...

English 16 Cleaning the Suction Set 1. Lock the gun and turn the pump OFF (O). 3. When suction set is clean, thread the suction tube back into the inlet valve, and replace the return tube onto the return tube fitting. Replace clip. 5. Turn the PRIME/SPRAY knob to PRIME. Turn the pump ON (l), and tri...

17 English Cleaning the Spray Gun Components 1. Make sure the pump is switched OFF (O). Make sure the PRIME/SPRAY knob is turned to PRIME. Unplug the sprayer. 3. Remove filter from spray gun (refer to Cleaning the Spray Gun Filter , page 12). 5. Install gun filter tapered-end first. Reassemble spray...

English 18 Title Short-Term Storage (up to 16 hours) Follow these steps when using latex materials only. If using materials that are oil-based, follow the Cleanup and Long- Term Storage steps. Shutdown 1. Lock the spray gun off. 2. Turn the PRIME/SPRAY knob to PRIME. Switch the pump OFF (O). Unplug ...

English 20 Cleaning the Inlet Valve Cleaning or servicing the inlet valve may be required if the unit has priming problems. Priming problems may be prevented by properly cleaning the sprayer and following the long-term storage steps. 1. Remove the suction set. 3. Lubricate the O-ring on the inlet va...

21 English Fluid Section Seal Replacement Instructions Kit Part number 0512221A (9145 and 9155) Kit Part number 0516724 (9175 and 9195) Always wear protective eye wear while servicing the pump. Be sure to follow the Pressure Relief Procedure (page 7) when shutting the unit down for any purpose, incl...

English 22 Title Troubleshooting / Maintenance Problem A. The sprayer does not start. B. The sprayer starts but does not draw in paint when the PRIME/SPRAY knob is set to PRIME. C. The sprayer draws up paint but the pressure drops when the gun is triggered. D. The PRIME/SPRAY valve is on SPRAY and t...

67 Title Español Français English 67 Title Parts List • Liste de pièces • Lista de piezas GX-05 Item Article Articulo Part no. nº de piéce Pieza no. English Description Français Description Español Descripción quantity quantite Cantidad 1 0501011 Guard assembly Protège-embout et ses composants Ensam...

68 Title Español Français English Parts List • Liste de pièces • Lista de piezas Item Article Articulo Part no. nº de piéce Pieza no. English Description Français Description Español Descripción quantity quantite Cantidad 1 0501517 Tip, 517 Embout, 517 Boquilla, 517 1 2 0501011 Guard assembly Protèg...

72 Title Español Français English 72 Warranty • Garantié • Garantía LIMITED WARRAnTY - AIRLESS PAInT SPRAY EquIPMEnT This product, manufactured by Wagner Spray Tech Corporation (Wagner), is warranted to the original retail purchaser against defects in material and workmanship for one year from date ...